A metal plate 2 meters in lenghth and sqrt(2) meters wide will be bend upto its midline by an angle teta on both sides, and capped at both ends with isosceles triangular plates, to make a rough for water for cattle. what is the maximun volume of water, in cubic meters, the the rough can hold? а) 0.5 b) sqrt(2)/2 c) 1 d) sqrt(2) e) 2

A metal plate 2 meters in lenghth and sqrt(2) meters wide will be bend upto its midline by an angle teta on both sides, and capped at both ends with isosceles triangular plates, to make a rough for water for cattle. what is the maximun volume of water, in cubic meters, the the rough can hold? а) 0.5 b) sqrt(2)/2 c) 1 d) sqrt(2) e) 2

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 46P: A rectangular gasoline tank bold 30.0 kg of gasoline when full. What is the depth of the tank if is...

See similar textbooks

Similar questions

What is the mass deep breath of air having a volume of 2.00 L? Discuss this effect taking such a breath has on your body's volume and density.
A certain hydraulic system is designed to exert a force 100 times as large as the put into it. (a) What must be the ratio of the area of the cylinder that is being controlled to area of the master cylinder? (b) What must be the ratio of their diameters? (c) By what factor is the distance through which the output force moves reduced relative to the distance through which input force moves? Assume no losses due to friction.
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
One gallon of paint (volume = 3.79 103 m3) covers an area of 25.0 m2. What is the thickness of the fresh paint on the wall?
A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
Suppose you have a coffee with a circular cross-section and vertical sides (uniform radius). What is its inside radius if it holds 375 g of coffee filled to a depth of 7.50 cm? Assume coffee has the same density as water.
A boat with a flat bottom and its cargo weight 4,311N. The area of the boar's is 4m ^ 2 How far below the surface of the water is the boat's bottom the surface of the lake ? Useg = 9.8 m/s ^ 2 answer to two decimals ,
When researchers find a reasonablycomplete fossil of a dinosaur,they can determine the massand weight of the living dinosaurwith a scale model sculpted fromplastic and based on the dimensionsof the fossil bones. The scale of themodel is 1/20; that is, lengths are 1/20actual length, areas are (1/20)2 actualareas, and volumes are (1/20)3 actualvolumes. First, the model is suspended from one arm of a balanceand weights are added to the other arm until equilibrium isreached. Then the model is fully submerged in water and enoughweights are removed from the second arm to reestablish equilibrium. For a model of a particular T. rex fossil, 637.76 ghad to be removed to reestablish equilibrium.What was the volumeof (a) the model and (b) the actual T. rex? (c) If the density ofT. rex was approximately the density of water, what was its mass?
On a part-time job, you are asked to bring a cylindrical iron rod of length 85.8 cm and diameter 2.85 cm from a storage room to a machinist. Will you need a cart? (To answer, calculate the mass of the rod. Fe = 7800 kg/m3.) Illustrate the rod with its complete dimensions based on the given information.
An aluminum block has a mass of53.7 g. What is the area of the rectangle incm2if the height of the block is2.7cm?
of you have a wire with density 7800 kgm-3 and mass 16 g and length 250 cm , how can we find the area of the wire ( cross section )
DEA agents watch drug smugglers load cocaine onto a fishing boat in a Mexican river to transport it down the river to the ocean, and then to Miami. To estimate how much cocaine was loaded, they measure how much further the boat sinks into the water after being loaded. If the boat’s area at the waterline is 50 m2 and it sinks by 2 cm, how much cocaine was loaded?