A metal ring is dropped from rest below a bar magnet that is fixed in position as suggested in the figure. An observer views the ring from below. Which one of the following statements concerning this situation is true? stationary bar magnet N O Since the magnet is stati hary, there will be no induced current in the ring. O As the ring falls, an induced current will flow counterclockwise as viewed by the observer. O As the ring falls, there will be an induced magnetic field around the ring that appears counterclockwise as viewed by the observer. O As the ring falls, an induced current will flow clockwise as viewed by the observer. O As the ring falls, there will be an induced magnetic field around the ring that appears clockwise as viewed by the observer.

A metal ring is dropped from rest below a bar magnet that is fixed in position as suggested in the figure. An observer views the ring from below. Which one of the following statements concerning this situation is true? stationary bar magnet N O Since the magnet is stati hary, there will be no induced current in the ring. O As the ring falls, an induced current will flow counterclockwise as viewed by the observer. O As the ring falls, there will be an induced magnetic field around the ring that appears counterclockwise as viewed by the observer. O As the ring falls, an induced current will flow clockwise as viewed by the observer. O As the ring falls, there will be an induced magnetic field around the ring that appears clockwise as viewed by the observer.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 86CP: A rectangular copper ring, of mass 100 g and resistance 0.2 1, is in a region of uniform magnetic...

See similar textbooks

Similar questions

A circular loop of wire of radius 10 cm. is mounted on a vertical shaft and rotated at a frequency of 5 cycles per second in a region of uniform magnetic field of 2104T perpendicular to the arcs of rotation, (a) Find an Expression for the time-dependent flux through the ring (b) Determine die time-dependent current through the ring if it has a resistance of 10.
A solenoid is 40 cm long, has a diameter of 3.0 cm, and is wound with 500 turns. If the current through the windings is 4.0 A, what is the magnetic field at a point on the axis of the solenoid that is (a) at the center of the solenoid, (b) 10.0 cm from one end of the solenoid, and (c) 5.0 cm from one end of the solenoid? (d) Compare these answers with the infinite-solenoid case.
A reasonably uniform magnetic field over a limited region of space can be produced with the Helmholtz coil, which consists of two parallel coils centered on the same axis. The coils are connected so that they carry the same current I. Each coil has N turns and radius R, which is also the distance between the coils, (a) Find tire magnetic field at any point on the z-axis shown in the accompanying figure, (b) Show that dB/dz and d2Bdz2 are both zero at z = 0. (These vanishing derivatives demonstrate that the magnetic field varies only slightly near z = 0.)
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
A circular loop of wire is held in a uniform magnetic field, with the plane of the loop perpendicular to the field lines. Which of the following will not cause a current to be induced in the loop? (a) crushing the loop (b) rotating the loop about an axis perpendicular to the field lines (c) keeping the orientation of the loop fixed and moving it along the field lines (d) pulling the loop out of the field
Two long wires, one of which has a semicircular tend of radius R, are positioned as shown in the accompanying figure. If both wires carry a current I, how far apart must then parallel sections be so that the net magnetic field at P is zero? Does the current in the straight wire flow up or down?
A coil of area 0.100 m2 is rotating at 60.0 rev/s with the axis of rotation perpendicular to a 0.200-T magnetic field. (a) If the coil has 1 000 turns, what is the maximum emf generated in it? (b) What is the orientation of the coil with respect to the magnetic field when the maximum induced voltage occurs?
Magnetic field inside a torus. Consider a torus of rectangular cross-section with inner radius a and outer radius b. N turns of an insulated thin wire are wound evenly on the toms tightly all around the torus arid connected to a battery producing a steady current f in the wire. Assume that the current on the top and bottom surfaces in the figure is radial, and the current on the inner and outer radii surfaces is vertical. Find the magnetic field inside the toms as a function of radial distance r from the axis.
A rectangular copper ring, of mass 100 g and resistance 0.2 1, is in a region of uniform magnetic field that is perpendicular to the area enclosed by the ring and horizontal to Earth’s surface. The ring is let go from rest when it is at the edge of the nonzero magnetic field region (see below). (a) Find its speed when the ring just exits the region of uniform magnetic field. (b) If it was let go at t = 0, what is the time when it exits the region of magnetic field for the following values: a=25cm,b=50cmB=3T , and g=9.8m/s2 ? Assume the magnetic field of the induced current is negligible compared to 3T.
The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole moment of the loop. (b) What is the torque on the loop if it is in a uniform 0.20-T magnetic field such that p and B are directed at 300 to each other? (C) For this position, what is the potential energy of the dipole?
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?