A mixture of 2.00 g of H2 and 14 g of O2 is placed in a 1.8 L flask at 35.5°C. Assuming each gas behaves as an ideal gas, calculate the partial pressure of oxygen gas in Pa unit. Please enter your answer using scientific notation with three significant figures in E notation, such as 2.33E4, without unit.

Q: When a tower A the bottom at once, and the bottom level rises rapidly. all the liquid on the trays…

A: Distillation is a separation process in which the high volatile components are separated from less…

Q: Required information Consider the vapor-compression refrigeration cycle shown below with…

A: For a detailed solution, please see the attached files.

Q: fugacity coefficient Pi

A:

Q: Moist air (2.27 mol % H2O) at 25°C and 100 kPa is to be dehumidified so that during its passage…

A: The mole fraction of water in the air is calculated. The total pressure is calculated. In process…

Q: ollow up: What is the efficiency of Mesh 20 screen?

A:

Q: Use the appropriate property table to fill in the values (letters a to x) in the following table:

A:

Q: When you draw P&ID, letter code will be used. Which one of the following statements is wrong…

A:

Q: How did this arrive from that value? Because when I tried to solve it manually, the value I get is…

A: The value of T2 is to be find out from the equation.

Q: Q3: Air at 15°C and 1.05 bar occupies 0.02 m². The air is heated at constant volume until the…

A: Given Data  Initial Temperature (T1 ) = 150 C =288 K  Initial Pressure (P1 ) = 1.05 bar = 1.05 ×105…

Q: Silica gel is to be used to separate a mixture of butane and butylene. The feed containing 55%…

A: The feed is a mixture of butane and butylene with 55% and 45% by mole respectively. Silica gel is…

Q: Exactly 2.5g was weighed in a silica crucible, after heating for 1hr at 110oC the residue was…

A: Initial mass of coal = 2.5 g Mass of coal after heating for 1 h at 110 0C = 2.415 g Mass of sample…

Q: better selectivity

A:

Q: How is the air pressure in a tightly sealed house affected by operating the furnace? Explain.

A: The affect on air pressure in a tightly sealed house with operation of furnace is to be mentioned.

Q: a. Write the cell with the equilibrium constant of the following reaction can be determined. Cd²+ +…

A: Given data: E0 Cd2+/Cd = -0.4 V E0 (NH3)42+/Cd

Q: QUESTION 4 What is the mole fraction of oxygen Xo2 in a mixture containing 2g of hydrogen and 16g of…

A:

Q: Dry nitrogen is bubbled though benzene at 800 mmHg and 323 K at a rate of 100 m^3 per minute.…

A: P1 = 800mmHg T1 =323k Q1 =100m3/min Nitrogen is saturated benzene vapour leaves at P2 = 740 mm Hg T2…

Q: Hexane (1) / ethanol (2) / methylcyclopentane (3)/ benzene (4) system Determine the following:…

A:

Q: 01: A. Cygen diffuses through a stagnant layer of air, 1mm thick, ambient temperature 2 °C and latm…

A: The value of molar flux with respect to observer and the value at the end of path are to be…

Q: Please explain, thank you so much

A: EGL refers to the energy grade line, and HGL refers to the hydraulic grade line. For a steady-state…

Q: A/ Saturated steam is flow in a double pipe heat exchanger at 250°C. The length of the heat…

A:

Q: Please answer question 3b

A: The extent of both reactions is obtained. Benzene theoretical amount and actual amount are obtained.…

Q: Give the names of the polymers in the IUPAC system ph-CHCH-(CH2CI) CH2CH(OCO-CH3)

A:

Q: 1. The mass density of liquid argon at T = 143 K is Pm = 0.98 x 10³ kg/m³. Assume that the argon…

A: The distance of separation between two particles is calculated from the distance where the…

Q: A certain reaction proceeds in a constant - volume and isothermal CSTR: -TA = KC₂2.15 If the…

A:

Q: 1. A process has been proposed whereby an ideal gas is taken from P = 10 bar and T = 300 K to P = 1…

A:

Q: Ten kg of a solid containing 45% of soluble material were treated with 15 kg of a solvent containing…

A:

Q: Note that if the % carbon and net hydrogen lost in the refuse is around 7%, a. Determine the orsat…

A: The moles of components are calculated by assuming a basis. The loss percent is considered and the…

Q: Q2) In an experiment CO₂ absorbed into a water film (thickness = 2.396x10 m) flowing = 2.396 down a…

A: The rate of mass flow is the mass flux. The flow of mass per unit time is the mass current. The area…

Q: A flue gas is cooled from 950°C to 150°C, and the heat is used to generate saturated steam at 100°C…

A: Given, The heat capacity of the flue gas is, CpR = 3.83 + 0.000551T K-1 The initial temperature of…

Q: A certain catalytic reaction occurs in a packed bed reactor. According to C proceeds through the…

A: Given Data  The reaction from the experimental data is given below : A+B⇔C The mechanism of the…

Q: Chemical Engineering: Material Balance

A:

Q: The following reaction occurs in a constant - volume batch reactor as follows: A+B=C A → D The…

A:

Q: saturated steam is needed in kg per min to heat up

A:

Q: overall rate of reaction, -A.

A:

Q: As is shown in figure 1, the lower plate moves in the x direction with the velocity of U1, and the…

A:

Q: - The following data represents a polymerization of styrene (3.34 mol/LS) after a fix benzene at…

A: Given that- Concentration of styrene, M= 3.34 mol/L.s Concentration of hydrogen peroxide initator,…

Q: Calculate the gross and net calorific value of coal having the following composition carbon=85%…

A: we have,  Gross calorific value = [8080* percentages of carbon + 34500(percentages of hydrogen -…

Q: 4. The turbines in a hydroelectric plant are fed by water falling from a 150 ft height. Assuming 15%…

A: For a detailed solution, please see the attached files.

Q: calculate the heat required to raise the temperature of 1 mol of methane from 260 to 600 °c in…

A: Given that- Moles of methane= 1 mol Initial temperature, T0=2600C =533.15 K Final temperature, T =…

Q: calculations to determine the values of (using the data provided for a heat exchanger): a. energy…

A: Given: Heat energy input (Qin) (J) = 600  Temperature (K) Cold = 273, Hot = 450  Exchanger Volume…

Q: A reaction of H₂ + Cl₂ → HCl occured in a constant temperature and constant pressure flow reactor at…

A: Given data: Temperature = 573.15 K Pressure = 2 atm Composition of feed gas is H2 = 0.8 Inerts = 0.2…

Q: mol ? It is desired to maximize the production of C. At what temperature should the reactor be…

A: The difference in reaction rates of the second and third equation will give the production rate of…

Q: Determine how the chemical potential of each gas changes due to the reduction in pressure.

A: Given that- Pressure of each component is reduced to 4 times than the original pressure so as-…

Q: maximum conversion of A.

A:

Q: Q3: Air at 15°C and 1.05 bar occupies 0.02 m². The air is heated at constant volume until the…

A:

Q: Pressures up to 2000 atm are measured with a dead-weight gauge. The piston diameter is 4 mm. What is…

A:

Q: Groundwater contaminated with 1,1,1-trichloroethane (TCA) is to be air-stripped at 25°C and 1.1 bar…

A: The feed rate of water is L = 900 kg/h, and the molar mass of water is 18 kg/kmol L = 90018L = 500…

Q: 4. Light olefin is produced by cracking propane. Two cracking reactions occur in a steady- flow…

A:

Q: (i) The amount of CO₂ being removed from the gas stream. (ii) The composition of gas leaving the…

A: Answer.

Q: Required information Air at 1(atm) and 35°C is compressed in a staged reciprocating compressor (with…

A: Answer.