Answered: a motor spins at 50 rad/s when given a…

a motor spins at 50 rad/s when given a voltage of 0.5V. this motor also reaches ss satte angular speed after 80 ms. This motor is used in position control. find state space representation

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.27P: An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8...

See similar textbooks

Related questions

Q: Compute the convolution of the discrete-time signal f[k] with the discrete-time impuise response…

Q: 1 Amplitude of a damped oscillatory motion of frequency 150 per second decays down to th 5 of its…

A: a) According to question, It is asked amplitude after 600 cycles that means, 600 Cycles= 600 Time…

Q: 4. A common-source amplifier is based by R₁ and R2 as shown below. Assume VTHN= |VTHP|= 0.6 V,…

Q: A 500 kw electric lighting plant cost $95 per kw installed. Fixed charges is 14%, operating cost is…

A: Given: 500 kW electric plant Per kW cost= $95

Q: 1. Using the characteristics shown below, determine ID and Vp for the circuit provided. a. Use the…

A: The required parameters can be analysed by drawing a load line based on the diode voltage and…

Q: draw a diagram of how Small-scale AE systems can increase renewable energy production?

A: Renewable energy The energy that can be renewed again and again and present in a replenished…

Q: 1.) An electric field points to the right. An electron placed in that field experiences a force…

A: 1) The direction of the electric field is towards the right. When the electron is placed in the…

Q: On full load a 500-volt series motor takes 100-Amp and runs at 840 rpm. The armature resistance of…

A: Given: The voltage is 500 V. The ampere is 10 Amp The armature resistance is 0.1 ohm The field…

Q: Question 2 (a) A 3-phase, 10-pole, star-connected alternator has 90 slots, each containing 12…

A: It is given that:- P = 10S= 90z=12N=600 rpmϕ=0.1 Wb

Q: If D=12x²,-32³a, -9yza, C/m² in free space, specify the point within the cube, 1sxy s2 at which the…

Q: what is the total Resistance offered by In the circuit to the 2v mw R₁ fgive 6 www R₂. the 12V…

A: We need to find out the equivalent resistance for given circuit, we will find out it by using of…

Q: A conductor is moving with a velocity of 12 m/s in the direction shown. The flux density is 1.6 T,…

Q: How many parallel paths does a shunt machine having 6 poles, triplex, wave winding?

Q: can you write it in paper and use super position

Q: Q1. Generate Bode magnitude and phase plots (straight-line approximation) for the following voltage…

Q: Can you try this problem again the solution was wrong

Q: A 2-GHz uniform plane wave has an amplitude of E₁ =1.4 kV/m at (0,0,0,t=0) and is propagating in the…

A: The general expression of the electric field in the lossy medium is, E(z, t)=E0e-αzcosωt-βz The…

Q: 25. If D-4x³,-2ra, -2ya, C/m², find: (a) V. D; (b) p, at P(x,y,z); (c) the total charge lying within…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: Distinguish the different kinds of quantities and description of power in alternating current…

Q: 3. A current of 0.4 ? is flowing out of a battery connected to a circuit. a. If the battery is…

A: It is given that: I=0.4 At=25 sec

Q: A 3-phase, 415 V, 4-pole, 50 Hz induction motor draws 5 times the rated current at rated voltage at…

A: It is given that: Isc=5Ifl

Q: Consider an asymmetric p-n junction which has a heavily-doped n-type side relative the p-type side.…

Q: ssuming that output Q=0 initially (before point A), apply the waveforms x and y shown in the figure…

Q: A blocked electric current of 4000 A is passing through the primary side of a converter having 400/5…

A: In this question, We need to determine the plug setting multiplier. PSM = fault current/(plug…

Q: 36 SECTION 6 Alternating Current (AC) Circuits Containing Inductance ET IT Z VA PF LO FIGURE 18-1 A…

Q: Solve for the voltage, current, and power across the 12-ohm resistor. 12 Ω 3 Ω 10 € (1 + V- 4 A Τ 8…

A: Previous approach of uploaded answer is also correct at the end u just need multiply with 12 so that…

Q: 1. Consider a system with the following impulse response h(t) and input x(t): h(t) = [u(t + 1) -…

A: In this question we need to find the zero state response of the given system.

Q: 13. A three phase source supplies power to a delta connected load (Z1, Z2, Z3), through the…

Q: PMOS NMOS + Vout

A: Vout = vdd option d is correct.

Q: If the effective (RMS) voltage across a resistor is 10 V, then The maximum voltage is: Select one: O…

Q: e) The complex waveform shown below is given by the equation: Determine: v = 100 sin(100 лt) + 50…

Q: An LTI system is described by the following differential equation: d² y(t) + 3 = y(t) + 2y(t) = =…

Q: Consider the following transfer function G(s) Y(s) U (s) 5 10s +1 a) What is the steady state gain?…

A: Given Data:- G(s)=Y(s)U(s)=510s+1

Q: 3. while the relationships for nodes A, B and c in fig 1. A I, 3A 15 I3-IA * figure 2 B 14 76=1A C…

Q: Use the three methods: Mesh Analysis, Nodal Analysis and Superposition Theorem, Find the current l2…

Q: Using the table method, find the convolution of the following two signals: h[k] = k(u[k] — u[k – 4])…

A: Function Definition uk=0 , k<0=1 , k⩾0δ[k]=1 , k=0 =0 , k≠0

Q: How many parallel paths does a shunt machine having 6 poles, triplex, wave winding? 06 12 O 3 18 Vrū

Q: Design an L-matching network centered at 3 GHz that will match a 500 line to a 100 + j120 load.…

A: Given data Matching line impedance, Zo=50 Ω, Load line impedance, ZL=100+j120 Ω, Frequency of the…

Q: Loop1: Loop2: Loop3: 11 + 12= 11+ 11 + 12+ 12+ 12+ 13= 13 = 13 = 3b) Calculate 12 and 13 when I1 = 1…

Q: A magnetic core with an air gap is shown below. For a relative permeability is 3500, and the space…

Q: 3. An LTI system is described by the following differential equation: d² d2z y(t) + 3 = y(t) + 2y(t)…

A: l

Q: 8. A 30.0 mH inductor with a resistance of 4 22 is connected to a 12.0 V battery. Find the current…

A: Given data, Inductance L=30 mH. Resistance R=4 Ω. Battery voltage V=12 V. Time t = 12.5 sec.

Q: Given the shown circuit and its feedback block diagram, find the signal X in terms of the following…

A: According to Kirchoff's voltage law, The sum of the voltage across all the components in a closed…

Q: B) The interface shown can be used for low current LEDs. Assume the LED voltage drop is 2.5 V. The…

A: Given: with R= 5 K Ohm, VDD = 5 V, LED voltage drop = 2.5 V, PPO = 0.4 V when LED is on. To find:…

Q: Hi , Please i want transient t response, using the Laplace transforms for this equation.

Q: Find Fourier series coeficients Ck for the signal below

A: F(t)=3; 0<t<33; -3<t<0

Q: Find the gain

Q: is(t) ( + v(t): =C₂ In the above circuit, is (t) = 2cos (50t +70°) A, R = 600, L = 100mH, C₁ = 4mF,…

A: Given, The circuit diagram, The voltage,

Q: A sequence r[n] yields the z-transform X(z) = (1 - Az-¹)² Express r[n] in terms of n. Hint: The…

A: According to the question, z-transform of the sequence x[n] is given as, Xz=z-21-λz-12, We need to…

Q: Using the Thevenin equivalent circuit

Question

a motor spins at 50 rad/s when given a voltage of 0.5V. this motor also reaches ss satte angular speed after 80 ms. This motor is used in position control. find state space representation

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 - Introduction

VIEW

Step 2 - Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mathematical Modeling of Mechanical System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Considering the scenario of a DC motor, find the Laplace function ofmotor speed with respect to the voltage input signal for the following parameters:• Armature resistance: 5 ohms• Inductance: 15 mH• Motor constant: 1.5 Nm/A• Viscous damper coefficient: 10 N.s/m• Free axis
A coil of 1000 turns is uniformly wound on a ring of non-magnetic material, the mean diameter is 20cm. The cross-sectional area of the coil is 4 cm2. Determine the self-inductance of the coil.
For rotational system, an inertia "J" is subjected to a given torque T(t).. find its transfer function in terms of its output angular displacement and input torque. a. 1/ Js b. 1/ Js2 c. Js d. Js2
A robot wheel rotates with a constant angular speed of 2 rad/s. The radius of the robot wheel is radius = 0.2 meters. Find the following: a) angular displacement of the robot wheel (angle that wheel has rotated) at a time of 3 seconds. b) linear (tangential) speed of a point on the rim.
In order for the system in the picture to be stable in closed loop, find the value range of K with the help of the Routh table (it is necessary to use the Routh method.)
You have been asked to design a cheap fan to fit in a refrigerator. Which motor would you select among the single phase induction motors? Justify your choice.
The position versus time plots of two oscillators are shown in the figure. a) What is the phase difference between the two oscillators at t = 1.0 s?b) At what times, closest to t = 0 s, do the two oscillators have zero velocities?c) At what times, closest to t = 0 s, are the two oscillators moving with maximum velocity toward the negative x-axis?
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
In a DC motor with separately excited configuration, EMF voltage=D10xrotational speed of the rotor (or w). In addition, the resistance and the inductance of the armature are 5 Ohms and 200 mH, respectively. la and Va represent current and voltage of the armature and fit to the following transfer function: la/(Va+pxw)%3Dq/(s+r). What is r?
Discuss the effect of adding a poles on time response, through the speed response ,overshoot ....etc.
Electrocardiology is the study of the electric signals produced by the heart. These signals maintain the heart’s rhythmic beat and are measured by an instrument called an electrocardiograph. This instrument must be capable of detecting periodic signals whose frequency is about 1 Hz (the normal heart rate is 72 beats per minute). The instrument must operate in the presence of sinusoidal noise consisting of signals from the surrounding electrical environment, whose fundamental frequency is 60 Hz—the frequency at which electric power is supplied. Choose values for R and L in the circuit of Fig. 14.4(a) such that the resulting circuit could be used in an electrocardiograph to filter out any noise above 10 Hz and pass the electric signals from the heart at or near 1 Hz. Then compute the magnitude of Vo at 1 Hz, 10 Hz, and 60 Hz to see how well the filter performs.
Answer the following questions by choosing the correct options For Translational and Rotational mechanical system analogy, displacement (x) is similar to ______ in rotational. a.angular speed b.angular acceleration c.torque d.angular displacement Given a mass with inertia (J) 0f 5 kg-m2 , find its transfer function when subjected into rotation force. a. 1/5s b. 5s2 c. 2.5s d. 5s