Answered: You have been asked to design a cheap…

You have been asked to design a cheap fan to fit in a refrigerator. Which motor would you select among the single phase induction motors? Justify your choice.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 6RQ: Name three factors that determine the torque produced by an induction motor.

See similar textbooks

Related questions

Q: Given a 50MVA, 3.3kV generator has a synchronous impedance of 10%. Find the per unit impedance on a…

A: A generator has,Synchronous impedance, .So .

Q: 4- Find the z transform of the following functions: (a) x₁(n)= (-1)"2"u(n) (b) x2 (n) = na"…

A: Given Data:To Find:Z transform

Q: A circuit consisting of three resistances 12 ohms, 18 ohms and 36 ohms, respectively. The whole…

A: Three resistances are given Supply voltage V = 60 V.Power dissipated in resistance is

Q: 2. Determine the output voltage, Vo and the current I, of the circuit shown below. 15 V 2KQ2 www Ge…

A: We need to find out the output voltage and current through given circuit.

Q: Question No.84 Find the output Boolean function for the logic circuit. Ao B Di

A: Given Logic circuit:

Q: (a) In the context of semiconductors, (i) (ii) (iii) name the process that creates an extrinsic…

A: As per the our company guidelines we are supposed to answer first three subpart, kindly repost other…

Q: 2- Consider the sampled data system shown below. The steady state error for unit ramp input is (b)…

Q: corresponds to the signal flow graph shown below G₁ 1 R(s) Y(s) R(S) Y(s) (b) = G₁ G₂ 1-H₁G₁-H₂G₂ G1…

Q: Find the Nyquist rate of the following signal (2000) a 300 samples/beconds Ob 400 samples/seconds c.…

A: In this questionWe need to choose the correct option. We knowNyquist frequency ws = 2wm Where wm…

Q: Q3. A 3-phase 20km line delivers a load of 10MW at 11KV having a lagging power factor of 0.707 at…

A: In this questionWe need to determine the regulation and efficiency of the line. We knowEfficiency of…

Q: Q2) Assume that a system G(s) is being controlled by a Proportional gain K₂ in a closed loop unity…

Q: 5) Consider the sampling system at the right. The input signal xe(t) has the Fourier transform shown…

A: To determine the minimum sampling rate without aliasing, we need to consider the bandwidth of the…

Q: For the feedback circuit in fig(2): What is the F.B. topology Draw the basic amplifier without F.B.…

A: given that feed back amplifier with common emitter current gain…

Q: 1) Find the current flowing through 10 resistance by using Kirchhoff's voltage law / Mesh analysis.

A: It is given that:

Q: 10- Find the sequences for the following z-transform z² z² + 4 (a) X(z) = |z| > 2, (b) X(z) = Z…

Q: For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA a. 90 V…

A: Circuit diagram is given as,

Q: Consider the following LRC-series circuit. Find the general solution for charge q(t) on the…

Q: LRC circuit + { +qC 1 -9 +Qmax L Dr <I а так S2 -IR-L - 1²/12 = 0 + &#+++ 4 = 0 R L (-B/L) + ⇒ 9 = A…

A: Given Data:An RLC source-free circuit with, the charge equation as,To Find:The expression for…

Q: Α) 2: Tel Rab 8 Ω Ο 18 Ω ²³-are 2012 www www 9Ω. ΣΩ www 20 Ω HE 20TH CLICHT 22 ΑΛΜ wwwww 12 AST

A: We need to find out equivalent resistance between a and b for given circuit.

Q: True or False 1. In solid grounding large fault current flows between the fault point and the…

A: We need to tell about whether the given statement are true or false.

Q: V1 240 Vrms 60Hz 0° M

A: Current Power factor Given circuit diagram is,

Q: 3.34 Obtain the transfer function of the circuit in Figure 3.31. 3.35 Consider the circuit shown in…

A: Given different circuits we have to calculate transfer function,current and impulse response.

Q: rectangular waveguide with a=3 cm and b=5 cm as shown in the figure is filled with polyethylene hich…

Q: Q1/ Choose the correct answers and fill the blanks for the following questions: 1. Matching of a…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The useful full-load torque of 3-phase, 6-pole, 50-Hz induction motor is 242.84 Nm. The rotor emf is…

A: The above question is based on 3 phase induction motor power flow.The results used are mentioned in…

Q: HSWOI 1- In a circuit, voltage and current are given by v(t)=10 sin (oot +30°) And i(t)=10 sin (oot…

A: In this question, we have to find the correct option regarding power consumption in the circuit,…

Q: 1- The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in Fig.1.…

Q: Please do not give solution in image format thanku convert this into pybricks : from…

A: Aim: To write the equivalent code using Pybricks which is a python library.

Q: From Carson's rule, determine the approximate bandwidth of the FM signal. TABLE OF BESSEL FUNCTION…

Q: Reduce the block diagram to a single transfer function.

A: The transfer function needs to be obtained from the given block diagram by using the block diagram…

Q: Assume that at the instant the 2 A dc current source is applied to the circuit in (Figure 1), the…

A: Given:A circuit,To find:Current through inductor for , when

Q: 1. The initial voltage across the capacitor at t = 0 in the circuit shown in following figure is…

A: In this questionWe need to determine the voltage across the capacitor C and current in it. We…

Q: It has the advantage of having less number of resistors used (three) compared to voltage divider…

Q: 2- Consider the following feedback system R(s) + M 12 2s5-s4+s²+4 1 S C(s) a) Find the closed-loop…

A: Given Data:A negative-feedback closed loop system with,Open loop function Feedback function To…

Q: Draw The Nyquist that Determine k to check Stability, in stability of the system: G(s) = k(s+1)/…

A: Given dataTo find outDraw the Nyquist plot.The value of for which the system is stable.

Q: Determine the inverse z-transform of the following: 1-1/2-¹ (a) X(2) - |=| > 1/1/201 1-12 (b) X(z) =…

Q: A 3000/200-V, 50-Hz, 1-phase transformer is built on a core having an effective cross-sectional area…

A: 1- phase transformer 3000/200 V ,50Hz Low voltage winding turns=80 Cross-sectional area=150cm2We…

Q: a) Draw the block diagram of the phase locked loop detector that can be used to detect FM signal and…

A: According to bartleby question answers rule I have to solve one question because all the question…

Q: Find i, in the circuit in (Figure 1), given that ig = 1.2 mA. Assume the op amp is ideal. Express…

A: For the given operational amplifier circuit, the current io needs to be calculated and the same can…

Q: Q.1/ Choose the correct answer for the following questions: 1- If a system two real and equal…

A: Nature of roots: 1) Real and equal - Criticality damped2) Real and distinct - Overdamped 3) Purely…

Q: For the waveform f(t), shown in Figure Prob. 4, determine what value K must be so that (a) f(t)dt =…

Q: PROBLEM 3. A set-up transformer is shown below. If N₁-80 turns, N₂-200 turns, the supplied voltage…

A: it is asked to find the currents I1,I2 and power supplied to load for given transformer

Q: Draw the Qoutput waveform if the inputs shown in the following figure are applied to a gated D…

Q: Q3. A 3-phase 20km line delivers a load of 10MW at 11KV having a lagging power factor of 0.707 at…

A: l= 20 KmP= 10 MWVR=11 KVcos= 0.707 (lag)R = 0.2 ohm/km/phaseX= 0.07 ohm/km/phaseregulation =?…

Q: +8) FIND i(t),:>0 2 k 13V 6k i(t) m mog (100 F Xt=0 4 k 6v

Q: A single-phase to single-phase cycloconverter is supplying and inductive load comprising of a…

Q: , Design two single-stub (short circuit) shunt tuning networks to match a load impedance ZL-60-j80…

A: Solution:Load Impedance =60-j80 (ohm)Load matched =2GHzFind :Here Design Single Stub (short Circuit…

Q: Given the circuit below: Iin (w) († jwL ooo Tout (w) R₁ www R₂ 1 - jwC (a) Solve for the frequency…

A: Given Data:An AC three parallel branch circuit with,Input current Output current To Find:Transfer…

Q: A series generator is connected in series to a feeder having 0.522 resistance to boost the voltage.…

A: Given a series generator connected in series with feeder having resistance of The induced voltage,…

Q: Given a sinusoidal waveform: v, (t) = 1000 cos(500t -90°). what is the phase angle? 90 degree -90…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

You have been asked to design a cheap fan to fit in a refrigerator. Which motor would you select among the single phase induction motors? Justify your choice.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Single Phase induction motor

VIEW

Step 2: BLDC Motor

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An industrial plant consisting primarily of induction motor loads absorbs 500 kW at 0.6 power factor lagging. (a) Compute the required kVA rating of a shunt capacitor to improve the power factor to 0.9 lagging. (b) Calculate the resulting power factor if a synchronous motor rated at 500 hp with 90 efficiency operating at rated load and at unity power factor is added to the plant instead of the capacitor. Assume constant voltage (1hp=0.746kW).
Hello my friend, I need a summary of the power laws in a three-phase induction motor, listening to the same timbres on the next page
The concepts a 3 phase squirrel-cage induction motors (SCIM). 3 phase motors are widely used in the industry. they require little maintenance, having no brush gear or centrifugal switch, are robust and relatively inexpensive.
3. What are the various losses in an induction motor? On whatfactors do they depend?
There are three commonly used excitation modes for stepper motors: full step, half step and microstepping.Illustrate micro-stepping with the help of a neat diagram by modulating phase supplyvoltage for a generic stepper motor with 4 and 6 poles respectively in its stator and rotor.
The use of the Internet of Things to control the speed of the three-phase induction motor
13/ The Squirrel cage induction motor has high efficiency. Select one: True False
IV. What are the various losses in an induction motor? On what actors do they depend?
A 208 V, 60 Hz, 2-pole, Y-connected induction motor is rated at 16 hp. Its equivalentcircuit components have the following values:(R1 = 0.200 ohm, X1 =0.410 ohm); (R2 = 0.120 ohm, X2 = 0.410 ohm); Xm = 15.0 ohm.Rotor slip is 4.5% at the rated voltage and frequency. Mechanical and core losses are 230Wand 200W respectively. Find (a) rotor speed (b) line current and motor p.f (c) Air-gap andconverted power (d) Induced torque.
The shunt field winding of the DC motor has many turns of fine wire. Select one: True False
The power input to a 500V, 50Hz, 6 pole, 3 squirrel cage induction motor running at975 RPM is 40kW. The stator losses are 1kW and friction and windage losses are 2kW.Find the output power of the motor
A 50-KW, 220V, 50 Hz, squirrel-cage three-phase induction motor is needed to rotate a mine conveyor belt drive. The motor starts sometimes under load, but most of the time is needed to run at rated speed and slip of 3.5%. Propose an appropriate design of this drive motor in order to suit the application. Motivate and then illustrate your design with suitable drawings and speed (slip)-torque graphs.