Subject : Environmental scienceGive me right solution with clear steps A multiple-tube fermentation test for coliform group of two water samples yielded the following results. Determine the MPN per 100 ml for sample 2.Sample Portion (mL)Number of positive tubes out of fiveSample 1Sample 2150.1530.0120.00110.000130.000011801,800140130O O O O

Given data, 1 ml = 5 0.1 ml = 3 0.01 ml = 2 0.001 ml = 1 0.0001 ml = 0

Answered: A multiple-tube fermentation test for…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The BODs of a domestic wastewater sample is considered to be about 200 mg/l and the DO in it is measured as 0 mg/L. The laboratory staff are preparing to set up a BOD test to determine the actual BOD of the sample. The DO of the dilution water was measured to be 9 mg/I. Which of the following volume ratios of (total volume of BOD bottle = 300 mL) / (volume of wastewater sample) would be most appropriate to use in setting up the BOD bottle for incubation? Select one among the following: (a) 20/1; (b) 50/1; (c) 100/1; (d) 500/1. Justify your selection
In the lead content analysis of a wastewater sample, 50.00 mL of the original sample was taken and diluted with 150.00 mL deionized water. The diluted sample was found to have a lead content of 17.8 ppb. What is the lead content (in ppb) of the original wastewater sample? DENSITY VALUES AT 25°C Ethanol: 0.789 g/mL Acetic Acid: 1.05 g/mL Water: 0.997 g/mL
1.Determine the 5-day BOD (in mg/L) for a 15 ml sample that is diluted with dilution water to a total volume of 300 ml when the initial DO concentration is 8 mg/l and after 5 days, has been reduced to 2 mg/1 2.A 100-ml of water sample has an initial DO level of 2 mg/L, and after 5 days of incubation decreased to 1.8 mg/L. Determine the BDO of the water.
Hello can you help me solve this. Calculate the suspended solids in mg/L given the following data: Weight of crucible: 21.0256 g, Weight of crucible and dry solids: 21.0301 g, Weight of crucible and ash: 21.0263 g, and Volume of sample filtered: 50 mL. Answer should have 2 significant figures.
A water sample was incubated at 20 °C for 3 days and its BOD3 concentration was found to be 150 mg/L. Given k20°c = 0.20/day (base e) and temperature coefficient for the rate constant is equal to 1.05. (a) BODultimate of this water sample=..............….mg/L (b) The BODs of this sample at 20 °C (in mg/L) =...……...... (c) kıs°c (in day-¹) mg/L.............. (d) The BODs of this sample at 15 °C (in mg/L) =...............
For a BOD analysis, 30 ml of waste with a DO of zero mg/L, is mixed with 270 ml of dilution water with a DO of 9 mg/L. The sample is then put in an incubator. The final DO is measured after 7 d. The final DO is measured at 3.0 mg/L. However, it is discovered that the incubator was set at 30°C. Assume a k1 of 0.2 d–1 (base e) at 20°C and θ = 1.05. Determine the 5 d, 20°C BOD of the sample
Domestic wastewater has a reaction rate coefficient of 0.3 1/d at 20° C. The ultimate BOD of the sample is 550 mg/L. What is the BOD remained after incubation at 20° C for 5 days in mg/l?
Determine the moisture content and density (kg/m3) of the sample from the following data: Waste Composition % by Weight % Moisture Density Content Food wastes 15 70 290 Paper 45 6 85 Cardboard 10 5 50 Plastics 10 2 65 Garden Trimmings 10 60 105 Wood 5 20 240 Tins, cans 3 3 90 Dirt, ashes 2 0 480 Based on 100 kg’s sample
The result No of blows(N) and water content in % (w) of liquid limit tests are given as follows: Trial 1 N= 48 w=32.1 Trial 2 N=38 w=35.1; Trial 3 N= 29 w=40.7; Trial 4 N=20 w=46.1; Trial 5 N=15 w=52.8. Determine the liquid limit. CHOICES: a.20 b.52 c.34 d.43
A BOD analysis was performed on a municipal wastewater. The 300 mL test bottle was filled with 2.0% wastewater mixed with dillution water, The initial dissolved oxygen (DO) was 8.3 mg/L. The sample is then put in a incubator and set at 20°C. Since the 5th day falls on public holiday, the final DO does not get measured until the 7th day. The final DO is measured at 4.5 mg/L. Assuming k30 (base e) is 0.2/day, determine the BOD3 @ 20°C BOD5 @ 30°C
Suppose the estimated BOD of an influent sample is expected to be 150 mg/L and the dissolved oxygen concentration of the oxygen saturated dilution water used in the BOD test is 8.5 mg/L. If you are using a 300 mL BOD bottle, estimate the maximum and minimum amount of sample you would add to the BOD bottle to ensure satisfactory test results. NOTE: Acceptable BOD test should comply with the two essential criteria: DO final ≥ 2 mg/L and DO initial – DO final ≥ 2 mg/L. Assume that the dilution water is the only source of oxygen.
For the measurement of the BOD of a wastewater sample from textile industry, five different dilutions (0.5%, 1%, 2%, 5% and 10%) of 1 L are prepared, with the addition of 2 mL of seed. Three different dilutions (0,5%, 2% and 5%) are used for seed corrections. The results of DO measurements are given below. Calculate the BOD5 concentration of the sample.

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A multiple-tube fermentation test for coliform group of two water samples yielded the following results. Determine the MPN per 100 ml for sample 2. Sample Portion (mL) Number of positive tubes out of five Sample 1 Sample 2 1 0.1 3 0.01 5 0.001 1 0.0001 0.00001 180 1,800 140 130 O O O O