a o 10 ohms bo 30 ohms 20 ohms 15 ohms 25 ohms 40 ohms

Q: Q4: Find Vx in the network in fig.(4) using mesh (loop) analysis. 1202 M m 30v Fig.4 ≤lov 4VX + vx≤4

A:

Q: Exercise 1: Design a common collector amplifier that produces the maximum output excursion and the…

A: Given: A common-collector amplifier produces the maximum output excursion and the maximum input…

Q: Q2- In the circuit in fig.(2) if 13= 1mA . Find all currents (11, 12, 14 and 15) and the voltage…

A:

Q: Q2. Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Rc 1.0 KO RB Vcc 20 KQ Bpc =50…

A:

Q: y(n) = h(n)) * x(n) where, A. h(n) = u(n − 1) and x(n) = u(n-5)

A: Use the property of unit step convolution i.e        u(n-a) * u(n-b) = (n-a-b-1) u(n-b-a)

Q: A load voltage with flicker can be represented by the following equation Vload =…

A:

Q: The neutral current

A:

Q: Low Frequency Response: Compute for the following. g. Dominant Frequency

A: The required parameters can be calculated by using DC analysis and AC analysis of the amplifier…

Q: Q2- In the circuit in fig.(2) if 13= 1mA . Find all currents (11, 12, 14 and 15) and the voltage…

A: In this question we need to find all current and supply voltage

Q: PROBLEM: Find the C/R₂ using the Block Diagram Method for the given system below. H₂ | R₂

A: According to the question, for the given block diagram, we need to find C/R2 by using the block…

Q: 21. Determine IE, VBE, VCE, and VCB in the circuit. Assume BDC = 150.

A:

Q: Consider the circuit in the figure below: a) What are the benefites of using the transformer in this…

A: Cut in voltage of silicon diode is 0.7V and cut in voltage of germanium diode is 0.3V. During…

Q: What is Ohms law? Explain with examples

A: Define Ohm's Law

Q: olve for current I and voltage across the second branch. I A Ас I₁ 1₂ C₁ C₂ 12v 0.1uF 0.2uF Bo 13 C3…

A:

Q: A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal…

A: Given  A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input…

Q: Four resistors, R1 = 100 ohms, R2 = 250 ohms, R3 = 350 ohms, and R4 = 200 ohms are connected such…

A:

Q: Q10- Design Colpitts oscillator to generate sine wave with frequency equal to 3 KHz, with gains…

A:

Q: Q1. Determine IE, VBE, VCE, and VCB in the circuit. Assume BDC = 150.

A:

Q: 1. An AM wave is given by CAM = 10(1+0.4 cos 10³t + 0.3 cos 104t) cos 10ºt Determine the modulation…

A: 1. an AM wave is given as eAM = 101+0.4 cos 103 t + 0.3 cos 104 t  cos 106 t   here we have to find…

Q: : Find the transmission parameters !

A:

Q: A combinational circuit with four inputs (A, B, C, D) and one output (Z) is designed as follows…

A:

Q: Problem 4: Design a sequential circuit with the finite state machine shown in Table 2, using D…

A:

Q: +||| VT = 15 V Fig. 5.5 W R₁ = R2 = 150 Ω R3 = 220 Ω = 100 Ω Series string resistance.

A: circuit is solve as first calculate req of circuit then calculate total current in the circuit

Q: 8. A 4.7M ohms resistor is in series with a 0.15 farad capacitor. The combination is across a 12 V…

A:

Q: IS 19 load at power factor of 0.9 and efficiency o 28%. find the quality of cooling air required.…

A: Given,P = 4.2 MVAPOWER FACTOR = 0.9P= 0.9×4.2 = 3.78 MWEfficiency = 28%losses dissipated =…

Q: Q4: For the unity feedback system below: k G(s) = - (s+5)(s+20) (s +50) 1. Draw the Bode…

A:

Q: Determine the power absorbed by each of the resistors in the circuit shown in Fig.(3). 12 v ܤ ܚܕ ܟ ܕ…

A: Given the circuit with the voltage and current source.

Q: las Rs negligibly mV, and Vo= 5V determine: Av, B, Avf (including the units) Rif, Rof if Ri= 5 Kohm…

A:

Q: Determine the input impedance of this amplifier configuration if Vin = 15 mV. Rf www R₁ Vino-W 33 ΚΩ…

A: In this question we need to find a input impedance of the given amplifier

Q: explain the aliasing in the PAM Signal?

A: The analog pulse modulation techniques are classified into three types, which are mentioned as…

Q: Solve the following using the re model. 1. The dc emitter current IE is: A. 2.62 mA B. 2.99 mA 2.…

A: Bartleby has policy to solve only first 3 subparts of a question. So reupload the question.

Q: Calculate the capacitance and stored energy for one dimensional change in potential using direct…

A: Vr To show all the calculation with diagram of the capacitor structure.

Q: Q2.Find Q-point when VBB = 1V, 2 V and 3 V.. Assume VCE(sat) = 0 V. Rc 1.0 KQ Vcc RB www 10 V 20 kN…

A:

Q: How much in decibels is 125 W larger than 45 W?

A:

Q: Is the synchronous motor works on the principle of magnetic attraction? TRUE or FALSE

A: Yes, synchronous motor works on the principle of magnetic attraction or magnetic locking.

Q: Determine the causal signal x(n) if its z-transform is given by 1+2₂-2 1+z=2

A:

Q: B-When the number of poles of a low pass filter circuit is increased, the a. frequency response…

A: when the number of poles of low pass filter circuit is increased then the root locus of low pass…

Q: Given the circuit below, determine the magnitude of the current through the 20-volt source. 10 ohms…

A: This question belongs to circuit theory . It is based on the concept of calculation of current…

Q: Determine the values of i2, i4, V2, V3, and V6 in Fig.(2). U3 + 4 V- E 6 A 3 A 6 V 12A 1214 -2V Di…

A:

Q: 40 ΚΩ VB.VG 10 ΚΩ 916 V IB 2.2 ΚΩ # Vs.Vcllc VDs + -OVD VE OLIE VCE 1.2 ΚΩ IDSS = 6 mA Vp = -6 V B:…

A:

Q: A 2002 load receives power from parallel-connected battery cells, as shown in the figure below.…

A:

Q: In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Vab = 476∠3°…

A:

Q: When a current of 2.5 A passes through a circular loop, the magnetic field at the center is 125 µT.…

A:

Q: for signals below.

A:

Q: Q. No. 3: Determine the power absorbed by each of the resistors in the circuit shown in Fig. (3). 3…

A: Consider the given circuit.

Q: Bandwidth of a signal in the 250…255 MHz frequency band, b. The gain in decibels of the system with…

A: Note  According to the bartleby's guidelines we have to solve only first three subparts of a…

Q: When resistors R1 and R2 are connected in parallel each resistor dissipate 100 W and 75 W,…

A:

Q: 01: Explain the following briefly: a) Access Time, b) Seek time, c) Transfer time, d) ROM, e)…

A: ROM is the read only memory it is a non volatile memory. it receives the data and permanent writes…

Q: Xc не a 120/0⁰ mA XI b For the circuit shown above, what is the magnitude of the Thevenin voltage as…

A: Thevenin's theorem states that any network containing linear and bidirectional elements and…

Q: (1) show that the wr= resonance frequency is: 2 Lc-(^_^)² = 500 rads & 4H L IM R =1MF

A: Given here a electrical circuit and asked to find resonance frequency with proof.

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.