Answered: A Parallel wire line has its radius of…

A Parallel wire line has its radius of the conductor is 0.4 mm and the distance between the conductors is 0.4 inches. Compute for the characteristic impedance of the line

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.12P: Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60...

See similar textbooks

Related questions

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for…

A: Impedance matching is a phenomenon in electrical engineering in which the impedance of electrical…

Q: Q/What is the effect of the length of the transmission line on the Phasor measurement unit (PMU)…

A: - A phasor measurement unit (PMU) is a gadget used to gauge the greatness and stage point of an…

Q: A Parallel wire line has its radius of the conductor is 0.2 mm and the distance between the…

Q: Taking the dielectric strength of air to be 30 kV/cm, calculate the disruptive critical voltage for…

A: Critical disruptive voltage, vc=g0r logedrwhere g0=breakdown strength of air d=distance between…

Q: The transmission line has a characteristic impedance equal to 502, and it was found that the speed…

Q: Derive the expression for total inductance of a transmission line.

A: According to the question we have to drive the expression for total inductance of a transmission.

Q: For the circuit shown below, the maximum power supplied to the load resistor (Pmax)= 400 Watts and…

A: The electrical circuit transfers power from the source to the load. This power is maximum for some…

Q: A transmission line has a characteristic impedance of 100 ohm and a resistance of 0.2 ohm/m. If the…

A: A transmission line can be characterized by 4 parameters:1. Resistance per unit length (R)2.…

Q: :State the primary transmission line constants and talk briefly about them.

A: The explanation is as follows.

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

A: Given, A single phase transmission line consists of two conductors. Radius of each conductor (r)=…

Q: A transmission line of characteristic impedance 40 ohms and length 6.2λ is terminated by an unknown…

A: Given: Z0=40 ΩΓin=0.45+j0.55 ΩL=6.2λZL=?

Q: What's the importance of mutual impedance of antenna elements? Please include an application

Q: In transmission lines, the length of the line is small as compared with the distance of separation…

A: Transmission lines especially power lines are very long and they carry electric current over…

Q: 1/In the Transmission Line Simulator, the Transmission Line is connected in Nominal-Pi Circuit.…

A: According to the question we have to discuss about transmission line simulator,the Transmission Line…

Q: For a transmission line, if the terminal is short-ended, is the input impedance will be zero? If…

A: for a transmission line : if the terminal is short ended is the input impedance will be zero if not…

Q: A Parallel wire line has its radius of the conductor is 0.4 mm and the distance between the…

A: characteristic impedance=inductance of linecapacitance of line.

Q: (a) Conductors of a 3-phase line are arranged at the corners of a triangle of sides 15, 15, and 18…

Q: When determining the Capacitance of a Transmission Line, which value is not needed? O A.…

A: capacitance of line = 2π×permitivity of free space ln(distance between conductorsradius)

Q: A 3 –phase 50 HZ transmission line have conductors of sections 90 mm2 and effective diameter of…

A: A 3 –phase 50 HZ transmission line have conductors of sections 90 mm2 and effective diameter of…

Q: A Parallel wire line has its radius of the conductor is 0.4 mm and the distance between the…

Q: 69KV line has a horizontal configuration. The distance between adjacent conductors is 6ft. What is…

A: Given, A 69 kV transmission line has a horizontal configuration. The distance between adjacent…

Q: Question 4 The line-to-line voltage of an overhead distribution line is 100 kV and radius of the…

A: Electric field intensity is given by: E(x)=V2xlndr

Q: A lossless coaxial cable transmission line has L = 200 uH/ft and C = 100 nF/ft. The inner diameter…

Q: A load has a reflection coefficient of 0.5 when referred to 50 Ω. The load is at the end of a line…

A: GIVEN: reflection coefficient=0.5 (a) reflection coefficient when distance l from…

Q: 7. Does the length of an ac transmission line affect the values of the characteristic impedance and…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Q3. For the Figure below, find the inductance per km of a transposed double circuit three- phase…

A: Given, r=1.2 cm d1=7.5 mD=42+0.752=4.07 md2=42+7.5+0.752=9.17 md3=82+7.52=10.97 md4=7.5+0.75+0.75=9…

Q: Three conductors (bundles) each of GMR, - 6 mm are placed at the heads of an equilateral triangle…

A: In the question, Individual GMR is given = 6mm Space between each group 10cm= 0.1m What is the…

Q: Question # 02: What do you understand by impedance matching? Also write the formula of…

A: According to the question we have to find the value of distance between two parallel wire lines in…

Q: A transmission line has two aluminum conductors in bundle. The self GMD of each conductor is 8.90…

A: Solution !!

Q: 2m, 2.5 m and 4.5 m and the diameter of each conductor is 1.24 cm. Calculate: (1) The inductance per…

Q: The conductors of a 12.5 meter long RG-58U type coaxial cable with a capacity of 220 pF per unit…

Q: A parallel-wire transmission line has separation between conductors equal to four times the…

Q: The diagram below (not to scale) shows a symmetrical arrangement of conductors in a 700m long…

Q: The horizontal component of the tension in the conductor is constant throughout the length of the…

A: In this question we will write about horizontal component of tension of conductor ....

Q: Question 4 The line-to-line voltage of an overhead distribution line is 100 kV and radius of the…

A: Field intensity variation between the lines is given as: E(x)=V2xlndr x is the variable in the above…

Q: A transmission line section shows an input impedance of 36 2 and 64 respectively, when short…

A: Given a transmission line has, Short circuit input impedance, Zsc=36 Ω Open circuit input impedance,…

Q: An overhead transmission line at a river crossing is supported from two towers at heights of 50 m…

A: The solution can be achieved as follows.

Q: The spacing for a 3-phase horizontally spaced line operating at 50 Hz, 132 kV, is 1.6 m between…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

Q: Taking the dielectric strength of air to be 30 kV / cm, calculate the disruptive critical voltage…

A: Given Dielectric strength of air and radius of conductor.we need to determine the disruptive…

Q: A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a…

Q: A distortionless transmission line has a resistance per unit length of 0.5 ohm/m. If the…

A: For a transmission line, the following line parameters are present: Since the given transmission…

Q: .(self-GMD or self-GMR) ...(positive charge or negative charge) The other name of geometric mean…

A: (a) The other name of Geometric mean radius is Self GMD (self geometric mean distance) which depends…

Q: The three conductors A, B and C of a 3-φ line are arranged in a horizontal plane with DAB = 2 m and…

A: Since, the conductors are arranged in the horizontal plane as shown below: The equivalent distance…

Q: The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft (or…

A: The dc resistance at 20oC is, Rdc,20oC=0.015581000 Ω/ft The temperature constant for aluminum…

Q: A three phase overhead transmission line has its conductors arranged at the corners of an…

A: According to question: The capacitance 'C' of each line per km is calculated as

Q: The span of the same level transmission line is 300 m. The diameter of the conductor is 15 mm. Wind…

Q: the air-filled two-wire line has a characteristic impedance of 50 Ω and is operated at f = 3GHz…

A: The normalized load impedance is given by ZNL=100+j4050=2+j0.8 In smith chart the intersection point…

Q: What do you understand by impedance matching? Also write the formula of characteristic impedance for…

A: Given data: C=31.5 F/m L=9 H/m r=0.008 m

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

A Parallel wire line has its radius of the conductor is 0.4 mm and the distance between the conductors is 0.4 inches. Compute for the characteristic impedance of the line.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A Parallel wire line has its radius of the conductor is 0.4 mm and the distance between the conductors is 0.4 inches. Compute for the characteristic impedance of the line. Answer
A 115 kv line has a horizontal configuration. The distance between adjacent conductors is 9ft. What is the geometric mean distance of the line?
A transmission line has two aluminum conductors in bundle. The self GMD of each conductor is 8.90 mm and the distance between the conductors and phase is 40 cm and 9 m, respectively. What is the inductance of the line per phase? A. 2 μH/m B. 4 μH/m c. 1 μH/m D 3 μH/m
A transmission line has a characteristic impedance of 100 ohm and a resistance of 0.2 ohm/m. If the line is distortion less, then what will be the attenuation constant associated with the line?
What do you understand by impedance matching? Also write the formula of characteristic impedance for a loss less line? A piece of parallel wire line has a nominal capacitance of 30 Farad/mm, and 9 Henry inductance per meter. Assume the radius of the conductor is 0.005 meter then find the distance between the two parallel wire lines in millimeter.
A three phase overhead transmission line has its conductors arranged at the corners of an equilateral triangle of of 2 meters side. calculate the capacitance of each line conductor per kilo meter. given that diameter of each conductor is 1.25 cm. Derive the expression for the capacitance of the transmission line
The conductors of a three phase transmission line are symmetrically arranged in a triangle. If the distance between the conductors is 2 meters and the diameter of each wire is 25 mm, find the value of inductance and capacitance per phase per kilometer.
What do you understand by impedance matching? Also write the formula of characteristic impedance for a loss less line? A piece of parallel wire line has a nominal capacitance of 31.5 F/m, and 9 H inductance per meter. Assume the radius of the conductor is 0.008 meter then find the distance between the two parallel wire lines in milimeter.
Determine the loop inductance, and the capacitance of a 1 km length of single-phase twin line having conductors of diameter 10 mm and spaced 800 mm apart in air.
* Given the poles pattern shown below, find ?n, ?p, %?? and ?s
The capacitance per unit length and the characteristic impedance of a lossless transmission line is C and Zo, respectively. Find the velocity of a travelling wave on the transmission line.
If the ratio of the inner conductor circumference to the outer conductor circumference of a coaxial cable is 0.4993, what is the capacitance per unit length of the air-insulated coaxial line, in pF/m?