A particle that carries a net charge of –77.8 µC is held in a constant electric field that is uniform over the entire region. The electric field vector is oriented 25.2° clockwise from the vertical axis, as shown in the figure. If the magnitude of the electric field is 9.82 N/C, how much work is done by the electric field as the particle is made to move a distance of d = 0.156 m straight up? 25.2 work: J What is the potential difference AV between the particle's initial and final positions? AV = V

A particle that carries a net charge of –77.8 µC is held in a constant electric field that is uniform over the entire region. The electric field vector is oriented 25.2° clockwise from the vertical axis, as shown in the figure. If the magnitude of the electric field is 9.82 N/C, how much work is done by the electric field as the particle is made to move a distance of d = 0.156 m straight up? 25.2 work: J What is the potential difference AV between the particle's initial and final positions? AV = V

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter5: Electric Charges And Fields

Section: Chapter Questions

Problem 94P: A proton enters the uniform electric field produced by the two charged plates shown below. The...

See similar textbooks

Similar questions

An electron and a proton, each starting from rest, are accelerated by the same uniform electric field of 200 N/C. Determine the distance and time for each particle to acquire a kinetic energy of 3.21016 J.
A charge of 30C is distributed uniformly a spherical volume of radius 10.0 cm. Determine the electric field due to this charge at a distance of (a) 2.0 cm, (b) 5.0 cm, and (c) 20.0 cm from the center of the sphere.
Consider a uranium nucleus to be sphere of radius R=7.41015 m with a charge of 92e distributed uniformly throughout its volume. (a) is the electric force exerted on an electron when it is 3.01015 m from the center of the nucleus? (b) What is the acceleration of the electron at this point?
A long cylinder of copper of radius 3 cm is charged so that it has a uniform charge per unit length on its surface of 3 C/m. (a) Find the electric field inside and outside the cylinder. (b) Draw electric field lines in a plane perpendicular to the rod.
The charge per unit length on the thin rod shown below is . What is the electric field at the point P? (Hint: Solve this problem by first considering the electric field dE at P due to a small segment dx of the rod, which contains charge dq=dx . Then find the net field by integrating dE over the length of the rod.)
Two parallel conducting plates, each of cross-sectional area 400 cm2, are 2.0 cm apart and uncharged. If 1.01012 electrons are transferred from one plate to the other, what are (a) the charge density on each plate? (b) The electric field between the plates?
A proton enters the uniform electric field produced by the two charged plates shown below. The magnitude of the electric field is 4.0105 N/C, and the speed of the proton when it enters is 1.5107 m/s. What distance d has the proton been deflected downward when it leaves the plates ?
If the electric field is 100 N/C at a distance of 50 cm from a point charge q, what is the value of q?
Two parallel plates 10 cm on a side are given equal and opposite charges of magnitude 5109 C. The plates are 1.5 mm apart. What is the electric field at the center of the region between the plates?
The circular are shown below carries a charge per unit length =0 cos . Where is measured from the x-axis. What is the electric field at the origin?
(a) Find the magnitude and direction of the electric field at the position of the 2.00 C charge in Figure P13.13. (b) How would the electric field at that point be affected if the charge there were doubled? Would the magnitude of the electric force be affected?
Determine if approximate cylindrical symmetry holds for the following situations. State why or why not. (a) A 300-cm long copper rod of radius 1 cm is charged with +500 nC of charge and we seek electric field at a point 5 cm from the center of the rod. (b) A 10-cm long copper of radius 1 cm is charged with +500 nC of charge and we seek electric field at a point 5 cm from the center of the rod. (c) A 150-cm wooden rod is glued to a 150-cm plastic rod to make a 300 cm long rod, which is then painted with a charged paint so that one obtains a uniform charge density. The radius of each rod is 1 cm, and we seek an electric field at a point that is 4 cm from the center of the rod. (d) Same rod as (c), but we seek electric field at a point that is 500 cm from the center of the rod.