Answered: A periodic variable x is shown in the…

A periodic variable x is shown in the figure as a function of time. The root-mean-square (rms) value of x is. 0 T/2 + T/2

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.10MCQ: The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero

See similar textbooks

Related questions

Q: 1. A tuned collector oscillator in radio receiver has a fixed inductance of 60µH and has to be…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In order to control a servomotor from a computer: no conversion is needed We need an DAC such that…

A: To control the servo motor from computer what we needed. Options: No conversion is needed. We need…

Q: Fig. 39.17 shows the negative voltage feedback amplifier. What is the value of feedback fraction?…

A: Given negative voltage feedback amplifier circuit, R1=2 kΩR2=18 kΩ

Q: The voltage of an electromagnetic wave propagating in a coaxial cable with uniform characteristic…

A: The propagation constant for a transmission line is given as: γ=α+jβ α is the attenuation constant…

Q: When a load is applied to a three-phase squirrel cage induction motor, the rotor speed will…

A: If load on three phase induction motor is applied then the power demand is increases and if power…

Q: In which scale must the voltmeter be set if the expected amount of voltage is 8.3V?

A: The voltmeter is used to measure the voltage across the components, devices or circuits. The…

Q: 4. The amplitude spectrum of the signal x(t) is shown as follows: | X()| 2 A -3500 -3450 -2000 0…

Q: 170 Vac 60 Hz 2 ww 0.5 Ω 15 mH Vd=0.76 V 1N4148 124 ΜΗ (1 turn coil) RL 1kΩ V de

Q: Ex. 3) a 3-phase, 50Hz generator running at 1500 rpm, the stator inside diameter is (0.5m) and its…

A: Given data, Frequency (f)=50Hz N=1500rpm D=0.5m L=1.2m Bm=0.62T

Q: Questions 4 For the following circuit, the current I is: R= 5 kn www 12 V Select one: Ⓒa. 1mA b. 0.8…

A: Given data,

Q: Two coils A and B known to have the same resistance are connected across a 110-volts, 60 cycle line.…

A: Given data, Two coils are connected in series. Resistance of both coils are same. Supply 110 V, 60…

Q: what is electricity ?

A: What is electricity?

Q: Using the practical diode model, the current in the circuit shown is: A 1.89 mA C 2.02 mA CA B OC…

Q: ^ what is 200121° Urm 2001-95° Urms 200 1145 Vrms 4 3 IL1 I. k 2a 26 Zc N 2a= 2b = 2c= (25+j5) e…

A: In this question, We need to determine the complex power, active power and reactive power?. We…

Q: Use minimum number of NAND gates only to represent the Boolean operation of an XOR gate.

Q: What will be the average power in the load for the circuit shown, when alpha = π/4 Assume SCR to be…

A: The Given α=π4 Assume SCR to be ideal. The supply Voltage is 330 sin 314t To calculate the RMS power…

Q: An inductance a capacitance connected in parallel across a A OA 50 V, 50 Hz supply. The current…

A: Given: Inductive reactance, XL=4 Ω Inductive capacitance, XC=4 Ω Both are connected in parallel…

Q: What Is polar plot? Draw the polar plot considering a unity feedback system with open loop transfer…

Q: the given RTL code XOR where R1 is 1011 0110, R2 is 11

A: Given as, R1 = 1011 0110, R2 = 1100 0111 RTL code XOR =?

Q: Can you explain step by step what is inside the circle

Q: Problem 5. Calculate the cross-sectional area, in mm², of a piece of copper wire, 40 m in length and…

A: Given: A piece of copper wire having resistance, R=0.25 Ω Length, l = 40 m Resistivity, ρ=0.02×10-6…

Q: Discuss the significance current limiting reactor in power system

A: A current limiting reactor consists of a large inductance compared to its ohmic resistance

Q: In the series RL circuit of figure shown, the sinusoidal source is given by v = 100 sin (500t + )…

Q: What is bode plot ?

A: It is the Frequency domain Analysis which consists of Both magnitude Plot and Phase plot. Purpose of…

Q: A core centres = 0.2 m, Height of window = 0.24 m Diameter of circumscribing circle = 0.14 m. The…

Q: V, is a 60Hz source with a peak voltage VP-120V is feeding a rectifier, assume ideal diode. The load…

Q: The circuit shows a variable resistor, with a lamp (L) connected to an ammeter and a voltmeter. By…

Q: 5 Find the average power delivered to the 3- resistor in the circuit shown in Fig. 11-12. (4 130 m…

Q: The message signal m(t) as shown in the figure is applied to a phase modulator (with kp as the phase…

A: Given similar carrier frequency is used in both FM and PM modulation Instantaneous phase in PM…

Q: ww R₁ 1.0kQ R₁ 3.0kQ ww R. 1.5kQ

A: Calculate I1, I2 , I3 and V1, V2 and V3 for the given circuit?

Q: The simplified form of the Boolean expression Y = (ĀBC + D) (ĀD + BC) can be written as? ĀD + BCD

A: Given expression, Y=A¯BC+DA¯D+B¯ C¯

Q: 1. Find the out the prime and essential prime implicants for the following Boolean functions. Write…

Q: A 188 KW, 200 volt, three phase, delta-connected induction motor has a full load efficiency of 94 %…

A: Given data, Output Power (Pout)=188kW Line Voltage (VL)=200V Full load efficiency ηfl=94% or 0.98…

Q: (c) A solar farm contains 300 modules each with an active area of 1 m² and generates 30 kW of power.…

A: Utilization factor:The utilization factor is also known as the use factor where the time used by…

Q: round intermediate calculations. Round your answer to 2 decimal places.) y, the PCB machine produces…

Q: Implement the Widrow-hoff learning rule for the set of input training vectors

A: The Given is set of input training vectors is X1=020-1; X2=00.5-0.51;W1=-1-0.500.5 The Constant…

Q: . A system is in the following input-output relationship. y(t) = x(t)x(t − 1) Prove that the system…

A: GIVEN: y(t)=x(t)× x(t-1) FIND: linearity time-invariant causality…

Q: An integrated circuit is .. A. A complicated circuit B. An integrating device C. Much costlier than…

A: Given, An integrated circuit is .. A. A complicated circuit B. An integrating device C. Much…

Q: Given the AC Bridge, determine the phase angle of Z4 (in °), if the values of other impedances are:…

Q: A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage…

Q: A shifted rectangular signal g(t) is represented in the following figure g(t) 2 1 t Let…

A: Fourier series: This is a mathematical tool for expanding the periodic signal in terms of its…

Q: FIND the value of 1₁ and 12 and 13 in the ideal circuit. transformer Topic: Magnetically Coupled…

Q: Fill-In Questions: 1. A forward-biased 2. A reversed-biased diode has_ diode has resistance.…

Q: P 11.9-11 Determine the coil voltages, V₁, V2, V3, and v4, for the circuit shown in Figure P…

A: The given circuit is shown below,

Q: 56. An amplifier has an open loop voltage gain of 10%. With negative voltage feedback, the voltage…

A: Given: An amplifier has open loop voltage gain, Av=105 With negative voltage feedback, the voltage…

Q: Find the Vrms of 5 ohm resistor 2/30° A 352 502 j4Q -j2Q * 6Q

Q: In step 2, why you multiply 10.0,0025 only and did not do it for 0.025s and 1. And how you got that…

A: To explain the solution in step -2 of the previous question

Q: (1) Find the Fourier transform of the signal shown in figure below. f(t) cos (5t)

Q: What are rotor faults in alternators

A: The rotor of an alternator is directly connected with field winding of the alternator whenever there…

Q: (5 minutes) A sine voltage signal is zero at t = 0.1s, and increasing to the succeeding zero at t =…

A: Given, Sine voltage signal with zero at t=0.1 s And increasing to the succeeding zero at t=0.3 s

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

A periodic variable x is shown in
the figure as a function of time. The
root-mean-square (rms) value of x
is.
T/2
Т/2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The average value of a double-frequency sinusoid, sin2(t+), is given by (a) 1 (b) (c) Zero
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
The rms output voltage of an AC source is 150 V and the operating frequency is 90 Hz. Which of the following equation gives the output voltage as a function of time? a. (150 ?) sin(283?)b. (150 ?) sin(565?)c. (212 ?) sin(283?)d. (212 ?) sin(565?)
A voltage is given by the following expression: v(t) = 550*Sin(377*t + 45) Determine: Amplitude, RMS value, Frequency in Hertz, Phase Angle in Radians
The root mean square (or RMS) is anothermeasure of average value, often used with oscillating functions(for example, sine and cosine functions that describe the current,voltage, or power in an alternating circuit). The RMS of a function ƒ on the interval [0, T] isCompute the RMS of ƒ(t)= A sin(Ѡt), where A and v arepositive constants and T is any integer multiple of the period ofƒ, which is 2∏/Ѡ.
The voltage and current at the terminals of a network are v = 15+400 cos 500t+100 sin 1500t V, i = 2+5 sin (500t+ 60 ∘)+3 sin (1500t− 15 ∘ ) A. The current is in the direction of the voltage drop across the terminals. What is the rms value of the current?
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the angular frequency of the ac source? What is the period of ac source? What is the circuit impedance? What is the power factor? What is the real power of the circuit? What is the rms value of the circuit current?
Consider the sinusoidal voltage: v(t) = 125cos (250πt –25°) V. a.What is the maximum amplitude of the voltage? b.What is the frequency in hertz? c.What is the angular frequency in radians per second?
Determine the time-domain expressions for the line-to-line voltages vAB, vBC, and vCA. Please report your answer so the magnitude is positive and all angles are in the range of negative 180 degrees to positive 180 degrees
An alternating voltage is given by v = 20 sin (100πt – π/2) volts. Find (a) the amplitude, (b) thepeak-to-peak value, (c) the r.m.s. value, (d) the periodic time, (e) the frequency, and (f) type ofcircuit if voltage is 200 sin 100πt.
the average power of a load is 3.37 kW with a leading power factor of 0.835. the magnitude of the rms voltage accross the load is given by |Vrms| = 450 V. If the frequency is assumed to be 60 Hz, calculate the apparent power, reactive power, impendance and the value of the capacitor in the circuit.
Determine the peak-to-peak voltages, RMS voltage, frequency, period and phase shift for the following expression: v(t) = −10 sin (2π 250 t + 180°).