A pipe 10mm in diameter is fitted to a water tank as shown in figure 4. The nozzle 25mm in diameter at the end if the pipe discharges into the atmosphere. Calculate the flow rate and pressure at

Q: The siphon in the figure has a nozzle 150mm long attached at section 3 reducing the diameter to…

A: A siphon is attached to tank as shown in the figure has, length of nozzle = 150mm diameter of nozzle…

Q: A Venturi meter is installed in a horizontal pipeline carrying air. The meter has a diameter of 60…

A: Venturimeter is a device that is used to determine the discharge flowing through a pipe. The…

Q: Calculate the pressure of the air in the sealed tank shown in the figure that would cause the volume…

A: FindQ=500gal per min=1.11400116cfs v=QA=1.11400116π43122=22.69ftsecso,

Q: For the tank shown in the given figure , using an average coefficient of discharge of 0.65 for the…

A:

Q: a venturi meter having a diameter of 6 in, at the throat is installed in a horizontal 18-in. water…

A: Here  Sm = manometric fluid  Sf = flowing fluid  a) Discharge when friction is neglected,…

Q: The duct shown in the figure has a reduction of 1 to 2, discharge to the atmosphere in section 3,…

A: Flow rate is defined as the rate at which fluid  is flowing in a given tube or section having…

Q: 2. A 6 in. pipe, as shown in the figure, takes water from a reservoir and terminates in a nozzle…

A: Apply the Bernoulli's equation from 1 to 2 as follows: △Z=V2/2g+(0.08)V2/2g+hL…

Q: (Single pipe with pump) The pump shown in the figure below adds a 13-ft head to the water being…

A: Introduction- A pump is a machine that transports liquid (liquids or gases). Pump are divided into…

Q: Oil (sg = 0.85) 3.0 m %3D 35-mm diameter 120-mm OD x 3.5-mm wall Flow 1.0 m Figure 19

A: For the system shown in Figure 19, calculate a) the volume flow rate of oil from the nozzle  b) the…

Q: A pump takes water from an 8 inch suction pipe and delivers it to a 6 inch pipe in which the…

A:

Q: A siphon consisting of a 3 cm diameter tube is used to drain water from a tank. The outlet end of…

A:

Q: QI:Fig. shows a pump drawing a solution (specific gravity =1.8) from a storage tank through an 8 cm…

A: For the given pump,

Q: Water is designed to flow 11 l/s in an 80mm diameter pipe system as shown in the figure. The Total…

A: Introduction- The pipe flow is a sort of flowing fluid within such a closed conduits conduit in the…

Q: D washer (2) n holes of diameter D. To reduce water consumption, a washer is installed in the shower…

A: Velocity in the pipe without reducer at section 1 and at the outlet (considering it as 2):…

Q: The pipeline shown in the figure A. takes water from a reservoir and terminates in a nozzle having a…

A: Given question shows the six stations of a pipeline system taking water fro reservoir and in a…

Q: Water entering a pump through an 200mm diameter pipe at 27.6 kPa has a flow rate of 0.1 m^3/s. It…

A:

Q: Determine the flow in each of the pipes shown in the figure. Assume f = 0.02 for all pipes.

A: Given:- Line-1,2,3 and 4 f=0.02 To find:- flow in each pipes

Q: A 20-lb tank that has a volume of 15 ft3 is filled with liquid water at 20C. Determine the weight…

A:

Q: A pump takes water from an 8 inch suction pipe and delivers it to a ó inch pipe in which the…

A:

Q: Calculate the theoretical discharge through a vertical orifice 0.3 m square in the side of a tank if…

A: Given:- The side of the vertical orifice = 0.3 m  The free surface of the liquid in the tank  above…

Q: For the system shown in figure, calculate the: 4. 2.4 m a.) volume flow rate of water from the…

A:

Q: Q. A fountain consists of a horizontal inlet pipe with a cross-sectional area, A1, which enters a…

A: Figure is as shown

Q: c) For the system shown in Figure 3.1, calculate (i) the volume flow rate of water from the nozzle…

A: To find (a)Q=? (b)Pa=?

Q: In the figure below, water at 20 degrees Celsius flows steadily through the piping junction,…

A: Reference : Fluid mechanics , Uniform Shower flow We need to find exit velocity that is velocity…

Q: For the pipe network shown, the flow of water from A to the first junction is 2 cubic feet per…

A: We are given with the data

Q: Water flows from tank A to tank E as shown in the figure. The head loss from B to C is 9 times the…

A: Compute: A. What is the discharge in m³/s? = B. What is the velocity in the 150 mm diameter…

Q: The flow rate of water through the pipe system shown in the figure is 30 lit/s under the total head…

A: Step 1

Q: A horizontal venturimeter with inlet diameter 200 mm and throat diameter 100 mm is used to measure…

A: Venturimeter is used to measure the flow rate in a pipe. Formula for rate of flow Q=CdA1A2A12-A222gh…

Q: Q1) Water flows from a pressurized tank (in figure below), through a 10.0 cm diameter pipe, exits…

A:

Q: EXAMPLE. An open cylindrical tank is 6 ft in diameter and is filled with water to a depth of 10 ft.…

A: There is an orifice within the fluid that passes through it. As compared to its other dimensions, an…

Q: The flow of water in a pipe of about 3 meters in diameter can be measured by a. venturimeter b.…

A: Venturimeter:- Venturimetre is a device used for measuring the rate of flow of fluid flowing through…

Q: For the siphon in Figure 21, calculate a) the volume flow rate of water through the nozzle and b)…

A:

Q: An le Volve Pump open P=150 kPa Water sprotruding entrance

A: Given data in question  Diameter of pipe Density of water Dynamic viscosity of water Length of pipe…

Q: 3. For the system shown in Figure 3, calculate: a. The volume flow rate of water from the nozzle b.…

A:

Q: A pipe 3in in diameter is fitted to a water tank as shown in figure 2. The nozzle 1in in diameter at…

A: To determine: flow rate pressure at C velocity at D   Given, Pipe diameter (D) = 3 in Nozzle…

Q: Coneider incompressible, frictionless flow of a fluld in a horizontal pipe. The pressure and…

A:

Q: .) A pipe system, connecting two reservoirs whose difference in water surface elevation is 13 m,…

A:

Q: 3 b) c) For the system shown in Figure 3.1, calculate (i) the volume flow rate of water from the…

A:

Q: For the tank, calculate the volumetric flow of water, exiting the nozzle. the tank is sealed and…

A: Given: The pressure above water is p1=20 psig=2880 lb/ft2. The depth of water is h=8 ft. The…

Q: Water flows from point 1 to point 2 at the rate of 280 liters/sec in a 300 mm diameter pipe. The…

A: Given data  Pressure difference  Discharge  Diameter  Friction coefficient

Q: Air flows at the rate of 1.5 m3/s through a horizontal pipe with a gradually reducing cross-section…

A:

Q: Pa. Assuming that the suction and discharge sides of the pump are at the same elevation, find the…

A: Given data Specific gravity of oil, SG=0.82 Flow rate=0.07 m3/s

Q: A cylindrical water tower of diameter 3.5 m supplies water to a house. The level of water in  the…

A: Sub script 1 refers to data related to pipe connected to house or intake pipe. Sub script 2…

Q: an orifice meter of 0.15 m diameter is fitted in a 0.3 m diameter pipe to measure the flow rate of…

A: An orifice meter of 0.15m diameter is given, It is fitted in 0.3m diameter pipe to measu hai flow of…

Q: For the system below assume frictionless one dimensional flow. A circular nozzle with prescribed…

A: (1)Determine the force applied on the plate and the velocity in section 1 (D1) of the nozzle.…

Q: Point A in the suction pipe is 1 m below the pump. It is mounted with anopen manometer which reads a…

A: When the liquid in the motion it possess three energy like kinetic, pressure and potential energy.…

Q: Given A pipe is tapered to form a nozzle as shown in the figure, and the nozzle produces a jet…

A: Given,  d1= 1in d2 = 0.75in V2= 102ft/sec We have to find out required pressure in the larger…

Q: A closed tank contains 20 m deep water. A hose is connected as shown such that the nozzle (diameter…

A:

Q: The head of water at the inlet of a pipe 2000 m long and 500 mm diameter is 60 m. A nozzle of…

A: Given: Length of pipe, L = 2000 m Diameter, D = 500 mm = 0.5 m Head, H = 60 m Nozzle diameter, d =…

Q: Gasoline (sg = 0.67) is flowing at 0.11 m3/s is flowing in the pipe shown in figure 8. If the…

A: This problem is related to the Fluid Mechanics. In this question we calculate Pressure P using…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?