A pipe of diameter 400 mm carries water at a velocity of 20 m/s.The pressure ta point A is 300000 N/m2 and at point B is 200000 N/m2, while the datum head at A and B are 20 m and 25 m respectively. Find the loss of head (HL) between A and B ● A-4.5 m O B-5.19 m O C-6.2 m O D-5.6 m O E- 7.1 m O

A pipe of diameter 400 mm carries water at a velocity of 20 m/s.The pressure ta point A is 300000 N/m2 and at point B is 200000 N/m2, while the datum head at A and B are 20 m and 25 m respectively. Find the loss of head (HL) between A and B ● A-4.5 m O B-5.19 m O C-6.2 m O D-5.6 m O E- 7.1 m O

Name: A pipe of diameter 400 mm carrieswater at a velocity of 20 m/s .Thepr
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A pipe of diameter 400 mm carrieswater at a velocity of 20 m/s .Thepressure ta point A is 300000 N/m2and at point B is 200000 N/m2 , whilethe datum head at A and B are 20 mand 25 m respectively . Find the lossof head ( HL ) between A and BA- 4.5 mB-

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

reservoir with water pressurized pipe diameter is 5 cm. The head loss in the system as given by hL= 5V^ 2/ 2g. The height between the water surface and the pipe outlet is 400 m. A discharge of 0.11 m3 /s is needed. What must the pressure in the tank be achieve such a flow rate? Assume a turbulent flow.
Water is pumped between two reservoirs in a pipeline with the following characteristics; (d= 300mm, L= 70m, /= 0.025, minor loss coefficient: YK=2.5). The pump performance curve is approximated by the equation: H,=22.9-650° Where H, is in meters and Q is in m's. Determine the discharge Q and pump head A when two pumps in series are used for total static head (4Z=25m).
A 60-cm water pipe carries a flow of 0.1 m³/s. At point A the elevation is 50 meters and the pressure is 200 kPa. At point B, 1200 meters downstream from A, the elevation is 40 meters and the pressure is 230 kPa. The head loss , in feet, between A and B isA. 6.94B. 15.0C. 20.88D. 100.2
A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev. 15m). The head loss from the reservoir (point 1) to the summit (point 2, elev. 22m) is 2.5 times the velocity head in the siphon and head loss from the summit to the discharge end is 4 times the velocity head in the siphon. What is the absolutepressure at the summit (point 2) assuming the atmospheric pressure to be 101.3 kPa? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: kPa (indicate the sign if negative) Decimal Places required in the final answer: 3
For the system-Water at 20°C flows by gravity through a smooth pipe fromone reservoir to a lower one. The elevation difference is 60 m.The pipe is 360 m long, with a diameter of 12 cm. A pump, which delivers15,000 W to the water, is used at night to refill the upper reservoir. The pipe diameter is increased from 12 cm toprovide more flow. If the resultant flow rate is 90 m3/h, estimatethe new pipe size.
A 25cm circular pipe carries 0.16m3 /sec of water under a pressure of 200Pa. The pipe islaid at an elevation of 10.71m above the mean sea level (MSL) of Ibadan. What is theenergy head measured with respect to the MSL? If = 9810N/m3 (9.81KN/m3).
The penstock of hydroelectric turbine is 0.5m x 0.5m with velocity of 5.5m/s and head of 20m. What is the output of the turbine if the turbine efficiency is 92%?
The pump , running at 880 r/min, is topump water at 20°C through 75 m of horizontal galvanizediron pipe. All other system losses are neglected. Determinethe flow rate and input power for (a) pipe diameter =20 cm and (b) the pipe diameter found to yield maximumpump efficiency.
An 11.5-in-diameter centrifugal pump, running at1750 r/min, delivers 850 gal/min and a head of 105 ftat best efficiency (82 percent). (a) Can this pump operateefficiently when delivering water at 20°C through200 m of 10- cm-diameter smooth pipe? Neglect minorlosses. (b) If your answer to (a) is negative, can thespeed n be changed to operate efficiently? (c) If youranswer to (b) is also negative, can the impeller diameterbe changed to operate efficiently and still run at1750 rev/min?
Water flows through a horizontal Venturi meter whose inlet diameter is 33 cm. and throat diameter is 21 cm. The pressure at the inlet is 770 kPa and at the throat is 585 kPa. Determine the discharge in L/s. Neglect head lost. Only accepted answer is 728.658. Show solution.
A pipe carrying oil of specific gravity 0.877 changes in size from 150 mm at section 1 and 450mm at section 2. Section 1 is 3.6 m below section 2 and the pressures are 90 KPa and 60 KPa, respectively If the discharge is 150 lit/sec, determine the head lost and the direction of flow.
Two new cast-iron pipes (ε = 0.26 mm) in series connect two reservoirs. Both pipesare 300 m long and have diameters of 0.6 m and 0.4 m, respectively. There is a valvein the 0.6 m diameter line with K = 10. The elevation of water surface in reservoir A is80 m. The discharge of 10°C water from reservoir A to reservoir B is 0.5 m3/s. Find theelevation of the surface of reservoir B. Assume a sudden contraction at the junctionand the entrance and exit is sharp.