Please help AcontainsfluidPipespecific gravitypressure of 110 kN/ m² and pipe Bcontains oilAaof3 mOil1.30underaof specific gravitykN/ m² .of1 m0.88under170pressuredeflectionComputethehthemercury.Mercury

Answered: Image /qna-images/answer/904ddaff-6122-401d-ab2f-80ee0f053624.jpg

A Pipe specific gravity pressure of 110 kN/ m² and pipe B contains oil of specific gravity A contains a fluid of 3 m Oil 1.30 under a B 1m kN/ m² . of 0.88 under 170 pressure deflection Compute the h the mercury. Mercury

A Pipe specific gravity pressure of 110 kN/ m² and pipe B contains oil of specific gravity A contains a fluid of 3 m Oil 1.30 under a B 1m kN/ m² . of 0.88 under 170 pressure deflection Compute the h the mercury. Mercury

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 3. An open vat holding oil (s=0.80) is 8m long and 4m deep and has a trapezoidal cross -section 3m…

Q: 7.30 FEUS For this refinery pipe, D, 20 cm. D, = 14 cm, and L= 1 m. If crude oil (S = 0.90) is…

Q: Two vertical tanks, one with circular section 3.0 m in diameter, the other square section 1.33 m x…

Q: A gas expands in a cylinder from 500 kPa and 0.1 m3 to a final volume of 0.5 m³. Determine the work…

Q: situation XIX: The head loss in 74 m of 150 mm dianeter pipe is known to be 9 m when oil (s 0.90)…

A: Given that: Length of pipe, L=74mDiameter of pipe, d=150 mmHead loss,…

Q: a) When oil (p=850 kg/m³) flows through a 5 cm diameter horizontal pipe of 12 m length at a velocity…

Q: Brine (SG = 1.1, viscosity = 1.1cP) is pumped at a rate of 45 ft^3/min (ID = 2.5in) from large open…

A: Given, Q = 45 ft3/min or 0.75 cfs D = 2.5 in or 0.208 ft

Q: horizontal pipe, which of the following is constant? Pressure head Elevation head Velovity head

A: In horizontal pipe, pressure head, elevation head and velocity head all will be constant { however…

Q: Estimate the maximum water hammer pressure generated in a rigid pipe of a 3 m dia pipe with an…

A: We have to determine the value of maximum water hammer pressure in rigid pipe of a 3 m diameter pipe…

Q: head lost in the pipe is 30 m and the Reynolds number is 1800. a. What is the friction factor f? b.…

A: Given- head loss = 30 m L = 20 m Re = 1800

Q: Two vertical circular cylindrical tanks are connected near the bottom by a short tube having a…

A: To find The Time (T)required for the surfaces to equalize following a quick opening of the Valve.

Q: P2.18 The air-oil-water system in Fig. P2.18 is at 20°C. Know- ing that gage A reads 101 kPa…

A: Given : Pabsolute =101 kpa PB = PC -8 kpa To find : γoil = ? Pc = ? Solution : Pc = ρwater *…

Q: Solve the TOllowing. Problem 1: The pressure in the air space above the gasoline surface sp.gr. =…

Q: A pressure gage at elevation of 12m at the side of the tank containing liquid reads 100 kPa. Another…

Q: . An open tank contains water to a depth of 2.5 m and an oil of relative density 1.25 to a depth of…

A: Solution Draw the Diagram

Q: Oil (s=0.80) and viscosity (u = 0.098 Pa - sec) flow from a reservoir of surface elevation 100…

Q: 2-An open tank 6 m long, 2.4 m deep and 3.6 m wide contains oil of specific gravity 0.85 to a depth…

Q: 3m 9m W2 8m W1 6m

Q: The pressure in the air space above the surface of oil (SG = 0.78) in a closed tank is 125 KPa…

A: FInd the absolute pressure below 2m P=125+γhP=125+0.789.812P=140.3036kpa

Q: A capillary tube of inside diameter 6 mm connects tan A and open container B, as shown in the…

Q: 3. An empty drum having a height of 4.5 m and a radius of 0.90 m is submerged in sea water (sp. gr.…

Q: An open tank contains water up to a depth of 2.5m and above it is an oil of sp.gr 0.80 for a depth…

A: Consider the free body diagram of oil and water;

Q: Q2) D =9 cm SAE 30W oil at 20°C flows through the 9-cm-diameter pipe in Fig. 1 average velocity of…

A: Diameter of pipe = D = 9cm Average velocity = v = 4.3 m/sec

Q: A viscous liquid (p = 1.2x10³kg/m³, u = 10m//s through a horizontal, 4 mm diamete a 1 m length of…

Q: A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbon…

Q: what will be the pressure gradient (kpa/m) at L=30 cm through the nozzle? At L=0, the liquid flows…

A: first finding pressure at respective sections by applying bernaulli's theorum and here given…

Q: An oil is flowing between two parallel horizontal plates which are 20 mm apart. The top plate is…

A: Since the Question comprises of a number of subparts, the solution for first three subparts is as…

Q: Determine the absolute pressure at A in kPa. Oil, SG = 0.866. a = 26 cm., b = 37 cm., c = 48 cm. Use…

A: Atmospheric pressure, Patm =101.339KPa =101.339 KN/m2Specific gravity of oil, SGoil =0.866Specific…

Q: A liquid of viscosity 1.74 x 103 Ns/m2 is flowing through a horizontal capillary tube of diameter…

A: Given data: Viscosity of the liquid (µ) = 1.74 x 10-3 Ns/m2 Diameter of the tube (D) = 0.5 mm…

Q: 500 sin 10° 86.82 m .10° %3D L = 500 m

Q: Oil, with p-950 kg/m' and v-2x10 m'/s flows through a 30-cm-diameter pipe 100 m long with a head…

Q: A pressure gage at elevation of 12m at the side of the tank containing liquid reads 100 kPa. Another…

Q: Q2: A tank of water empties by gravity through a siphon. The difference in levels is 3 m and the…

Q: For the closed tank with Bourdon-tube gages tapped into it, what is the specific gravity of the oil…

A: The figure is shown below, Calculation: The pressure at gauge B can be calculated as,…

Q: Oil (SG oil = 0.95) flows at 200 L/s through a 200mm diameter pipe, 500m long. Friction factor is…

A: Using Darcy-Weisbach formula the frictional headloss can be calculated. Further using the definition…

Q: A vertical circular gate 3ft in diameter is subjected to pressure of molasses (sp gr 1.50) on one…

A: Question is based on the circular gate . Diameter of gate , depth of free surface and specific…

Q: The distance Ah is the height of the liquid in the manomoter above the heavier liquid in the tank. D…

A: To find Height of liquid column in manometer?

Q: Oil of specific gravity 0.80 and dynamic viscosity of 0.05 Pa-s flows at a rate of 100 lit/sec…

A: per our company guidelines we are supposed to answer only first 3️⃣ sub-parts. Kindly repost other…

Q: Estimate the maximum water hammer pressure generated in a rigid pipe of a 3 m dia pipe with an…

Q: For the open tank, with piezometer attached on the side, contains three immiscible liquids as shown.…

Q: two reservoirs are connected by a cast iron pipe (roughness of 0.025 mm) with 75 mm in diameter and…

A: Roughness n=0.025 mmrelative roughness nD=0.02575=0.00033friction factor for relative roughness…

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

A: Difference in centers of Pipe A and B, h = 0.3 m Specific gravity of oil in Pipe A, SA = 0.9…

Q: An orifice in a 30 degree plane from horizontal as shown has its vena contracta at elevation 10.7m.…

A: The correct answer is (a) 0.983 Using Formula, u = Cd under root2gh

Q: Question 1. Water flows with a discharge of 0,02c through a SG pipe reducer as is shown in the…

A: Consider the given data The value of a, b, c are 4, 0, 1 respectively

Q: 2.6 An open tank contains water upto a depth of 2 m and above it an oil of sp. gr. 0.9 for a depih…

A: Given: Depth of water, h1 = 2 m Depth of oil, h2 =1 m Specific gravity of oil = 0.9

Q: When the accumulated liquid along the bottom of the pipe or in a well reaches a certain level and…

A: When the accumulated liquid along the bottom of the pipe or in a well reaches a certain level and…

Q: At a given point on a horizontal streamline in flowing air, the static ressure is -2.0 psi (i.e. a…

A: Given:The static pressure p1 at the given point is -2.0 psi.The velocity V1 at the given point is…

Q: A 25-mm-diameter pipe 35m long is used to convey oil. The oil has a density of 880kg/m and a…

Q: Determine the outside surface area of the storage tank.

Question

Please help

A
contains
fluid
Pipe
specific gravity
pressure of 110 kN/ m² and pipe B
contains oil
A
a
of
3 m
Oil
1.30
under
a
of specific gravity
kN/ m² .
of
1 m
0.88
under
170
pressure
deflection
Compute
the
h
the
mercury.
Mercury

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

q=3.15 kn/m , a=3.15m
Convert 5.4 °F/1000ft to °F/ft
F (kN)=36 L1 (m)= 37.0053 Eal (GPa)=74
Solve it plz early ok
I cannot understand these For point of contraflexural, 40090300=200×x90300 x=2 m θA=0 (fixed support) θDA=θD-θA=θD=Area of MEI Dia between A and D = 19030012×600×3+600×4+12×300×3-12×200×2 =355090300 θD=0.03931 radianθD= 2.252° Deflection at point D ∆D=31-CosθD ∆D=2.3176×10-3 mm Deflection at point D is 2.3176×10-3 mm
Given the function: 5y - 2 = 6cot(3x - π) +7, determine the period in degrees. 120 3 π/2 270 2π13
a = 4.5 m b = 33.0 kN/m c = 13 kN
Can you check back parts b & c My answers are: using r > 3n method where r= reactions & n= nb of parts b) (16) > (3)(4)statically indeterminate by 4th degreec) (12)> (3)(3) statically indeterminate by 3rd degree let me know where is my mistakethank you
Solveforthemean velocity and dischargeof atrapezoidal channel in whichdepth of flow is3.0 m. The channelis 10.0 m wide and has a side slope of 1.5 horizontal: 1 vertical. The bed slope is 0.0003. The channel is lined with smooth concrete of n =0.012
Fr = 3.266 and thetha =168.79
8.TAPE MEASUREMENTSa. A line was recorded as 1650.00 meters long. It is measured with a 0.65 kg standard tape30.00m long at 20°C under a 50N pull supported at both ends. During the measurementthe temperature was 5°C and the tape was suspended under a 75N pull. The line wasinclined on a 3% grade. What is the true inclined distance? E = 200GPa, A = 3.0 mm² andthe coefficient of linear expansion is 0.0000116 m/°C.b. A line was recorded as 2000.00 meters long. It is measured with a 0.65 kg standard tape30.00m long at 20°C under a 50N pull supported at both ends. During the measurementthe temperature was 5°C and the tape was suspended under a 75N pull. The line wasinclined on a 3% grade. What is the true inclined distance? E = 200GPa, A = 3.0 mm² andthe coefficient of linear expansion is 0.0000116 m/°C.
Whatisthehydraulicradiusofarectangularairduct300mmby 500mm?