A porter governor its central load is 18 kg and the weight of each ball is 2 kg. The top arms are 25 cm while the bottom arms are each 30 cm long and all arms pivoted on the axis of rotation. The friction of the sleeve is 14 N. If the top arms make 45° with the axis of rotation in equilibrium position, find the speed of the governor at that position.

A porter governor its central load is 18 kg and the weight of each ball is 2 kg. The top arms are 25 cm while the bottom arms are each 30 cm long and all arms pivoted on the axis of rotation. The friction of the sleeve is 14 N. If the top arms make 45° with the axis of rotation in equilibrium position, find the speed of the governor at that position.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Assume a Centaur V upper stage with an empty mass of 2,247 kg, diameter of 3.05 metersand height of 12.68m, the wall thickness is 41mm, whereas the motor can be assumed tofill up 1/4 of the inner volume. You can assume the density of the walls and the motor tobe uniform. You can assume the upper stage has been properly passivated and has no fuelremaining.
A single cylinder reciprocating engine is to be balanced by 60% of the reciprocating parts and all the revolving parts. Il mass of reciprocating parts and revolving parts is 40 kg and 30 kg respective y, then mass to be balanced at the crank pin will be equal to?
There are two double-acting pneumatic actuators, the extension of each one is executed in 5 seconds at 80 psi and recoil in 4 seconds at 30 psi, the travel of both is 12 inches, the diameter of the piston is dp = 4 "and of the rod dv = 1"a) Determine the compression ratios. The local atmospheric pressure is 79kpa = (11.5 psi)b) Determine the air consumption in cubic feet per minute of free air PCMc) Determine the average air consumption for each.d) Propose the regulation values of the pressure switch, system pressure and safety valve
An office to be air conditioned for 50 staff when the outdoor conditions are 30°cDBT and 75% RH if the quantity of air supplied is 0.4m3/min/per find i) Capacity of cooling coil ii) capacity of heating coil iii) amount of water vapourremoved per hour. Assume that required air inlet conditions are 20°c DBT and 60% RH air is conditioned first by cooling and dehumidifying and by heating. Ifthe heating coil surface temperature is 25°c, find the bye pass factor of the heating coil.
state T(C) P(bar) V(cm^3/g) H(KJ/Kg) S(KJ/kgK) 1(initial) 2(after throttle) 3(after cooling) 4(after compressor) fill out the number in the table
An eight-cylinder, four-stroke engine of 9 cm bore and 8 cm stroke with a compressionratio of 7 is tested at 4500 rev/min on a dynamometer which has 54 cm arm. During a 10minutes test the dynamometer scale beam reading was 42 kg and the engine consumed4.4 kg of gasoline having a calorific value of 44000 kJ/kg. Air at 27C and 1 bar wassupplied to the carburettor at the rate of 6 kg/min. Take R for air = 287 kJ/(kg·K). Find:(1) the brake power delivered (bp),(2) the brake mean effective pressure (bmep),(3) the brake specific fuel consumption (bsfc),(4) the brake specific air consumption (bsac),(5) the brake thermal efficiency (b, th),(6) the volumetric efficiency (vol), and(7) the air-fuel ratio (A/F) on mass basis.Draw the simplified schematic diagram of the plant showing all the necessary data displayed on it. "Please only draw on schematic diagram of the plant"
An eight-cylinder, four-stroke engine of 9 cm bore and 8 cm stroke with a compressionratio of 7 is tested at 4500 rev/min on a dynamometer which has 54 cm arm. During a 10minutes test the dynamometer scale beam reading was 42 kg and the engine consumed4.4 kg of gasoline having a calorific value of 44000 kJ/kg. Air at 27C and 1 bar wassupplied to the carburettor at the rate of 6 kg/min. Take R for air = 287 kJ/(kg·K). Find: (4) the brake specific air consumption (bsac),(5) the brake thermal efficiency (b, th),(6) the volumetric efficiency (vol), and(7) the air-fuel ratio (A/F) on mass basis.Draw the simplified schematic diagram of the plant showing all the necessary data displayed on it.
1, A small ball, mass = 0.60 kg, at the end of a string is whirled in a vertical circle of radius = 60 cm with a tangential velocity of 8.0 m/s. (a) What is the tension in the string when it is at the bottom of the circle? (b) What is the tension in the string when it is at the top of the circle? (c) What is the critical velocity? 2, A cement truck, mass = 2000 kg, has an engine which produces 4000 N. The truck develops a leak and loses cement at a rate of 10 kg/sec, (a) The truck starts from rest and accelerates when the light turns green. What is its initial acceleration? (b) What is the equation for the acceleration as a function of time? (c) What is the equation for the velocity as a function of time? (d) How long will it take the cement truck to get up to a velocity of 15 m/s?
Initial condition: T = 360Ch = 1860.8 KJ/kg Process: IsometricFinal condition: saturatedRequired: Final pressure
A certain gas with Cp= 0.529 BTU/lbmole-Rankine and Cv= 0.4053 BTU/lbmole-Rankine expands from 20ft3 and 500 Rankine to 30 ft3 and 1620 Rankine its pressure remains constant at 40lbf/ in2 . R(gas constant)=97.24 ft3 -lbf/lbmole-Rankine Compute: a) Change of internal energy (BTU) b) Change of enthalpy (BTU) c) Heat Transferred (BTU)
Thermodynamics subject. Pleas show the complete and step by step solution. A vessel of 0.058m3 capacity is well insulated and is divided equally by a rigid conducting diaphragm. Initially both halves contain air pressure of 137.8kPa and 413.4kPa and temperatures of 27C and 177C respectively. What is the increase of entropy of the system in kJ/C?
A 5-feet diameter Chimney is designed to handle a flue gas produced in a steam power plant at a rate of 17 lb/s. The barometric pressure is 29.92-inch Hg. Outside air enters the combustion chamber at 90 F. The average temperature of the flue gas inside the Chimney is 572 F and its molecular weight is 30. Cv = 0.35, Rair = 53.342 ft-lb/lb-R. Calculate: 5. The total draft, feet of air. 6. The height of the Chimney, feet