A power amplifier has an input of 90mV across 10K ohm. The outputis 7.8V across an 8 ohm speaker. What is the power gain in dB?

Q: Consider the following system: Y(s) s+2 U(s) s³ +35² +2s Obtain the state space representation of…

A: Controllable Canonical Form (CCF) The controllable canonical form arranges the coefficients of the…

Q: 11.18 Complete the following timing diagrams for a gated D latch. Assume Q begins at 0. (a) First…

A:

Q: B B figure 2 +4 0 VA = IOV, VB = -3V VF = 12V VH = 5V find the remaining voltages

A: We need to find out the current and voltage for given circuit , we will find out it by using of…

Q: HI i) Derive a formula for the closed loop gain of the circuit assuming an ideal op amp. ii) Derive…

A: The required voltage gain can be calculated by using the ideal opamp characteristics and for non…

Q: A certain single mode step index optical fiber has a maximum core radius equal to 7 um at 1550-nm…

A: Given: For a certain single mode step index optical fiber, core radius, a=7μm, Optical wavelength,…

Q: type of capacitive probes and inductive probes can be used?

A: Capacitive probe and inductive probe are the capacitive sensor and inductive sensors.

Q: Use source transformation to find the current I. shown in the figure below. 12/0° V+ ΖΩ 2/0° A 20…

A:

Q: Using the Thevenin equivalent circuit

A:

Q: Write the difference equation of the following system. x[n] D DD -2 →y[n]

A: Let x(t) is a continuous time function and x[k] is its Discrete sequence then x[k] can be found from…

Q: Vis Rus www Ca R R Ca CE The NPN transistor has a rated B= 150 and VA = 40V. The collector current…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: What are the electrical components of a single phase motor?

A: Types of single phase Motor Capacitor start Motor Two valve capacitor Motor Permanent split…

Q: The equivalent circuit of a 22KVA, 11700/450 V, 60Hz, single-phase loaded transformer when referred…

A: In this question we need to find a voltage regulation of the given transform.

Q: The given circuit can be minimized to: × > X A XY B X CY D XY

A: Given circuit:

Q: The analog input channel voltage range for a PIC16 Microcontroller is limited to the positive range…

A: Given,Bipolar voltage range = ±10VUnipolar ranfe=0-6.6 VReference voltage, Vref=+6.6 V

Q: How much is Xc [capacitive Reactance] of a 47 PF [pico Faxed] capacitor at I. 1 MHz (Moya Hex12) 11…

A: As per the guidelines of Bartley we supposed to solve 1st question only so we request you to upload…

Q: Draw an ASM chart for the synchronous circuit having the following description, "The circuit has a…

A: Given, The circuit has a control input 'X', clock (i.e rising edge clock) and two outputs ime A…

Q: Let xn be a random walk defined as xo = 0 N Σ n=1 where Zn is an i.i.d process with p(Zn = − 1) =…

A: We have to show Intermediate steps that define absolute value random process Yn=|Xn|.   Explanation…

Q: TRUE OR FALSE A. Under no external bias, electrons and holes inside a p-n device are stationary.…

A: We need to tell about whether the given statement are true or false.

Q: The figure below shows the input waveforms for a NOR latch. Draw the corresponding output waveforms.…

A: Given, Inputs of SR-latch are We need to draw the timing diagram corresponding to SR-latch using…

Q: The spherical surfaces R = 1, 2, and 3 (in meters) carry surface charge densities of 20, -9 and 2…

A: We need to find out the electric flux and electric flux density for given charge distribution , we…

Q: A 4-bit R/2R digital-to-analog (DAC) converter has a reference of 5 volts. What is the analog output…

A: Given,  A 4-bit R-2R  ladder type DAC having Digital input = B3B2B1B0 = 1110 Reference input = Vref…

Q: A signal generator is programmed to output a voltage waveform, f(t), pictured on the right.…

A: The output waveform is shown below,

Q: Asap, determine if True or False A.   The more the number of commutator segments in a dc machine,…

A:

Q: A 2.2 KVA, 480/4800-V, 50 Hz, single-phase transformer is tested with the following results. Find…

A:

Q: A conductor is moving with a velocity of 12 m/s in the direction shown. The flux density is 1.6 T,…

A:

Q: Determine the state-space model

A:

Q: A Revisto 'R with resistance value of 25.0, an inductor 'I' with inductance 20 mH, and capacitor 'C'…

A: We need to find out the impedance and current for given series RLC circuit .

Q: TRUE OR FALSE A. Diffusion of charge carriers in a p-n junction is dependent on the concentration…

A: Given: Statements: A. Diffusion of charge carriers in a p-n junction is dependent on the…

Q: Derive the real expression of the sequence r[n] whose z-transform is X(2) -0 0 7 4 Hint: cos 1 √3 y2…

A: According to the question, we need to find the sequence x(n), if Xz=11-2z-1+2z-2;

Q: b) Referring to the circuit below use Kirchhoff's laws to calculate the currents flowing in each…

A:

Q: 2) Consider the following circuit: V, 0- R₁ wwww i) ii) Identify the function of the circuit. Derive…

A: Given: Op-amp circuit,

Q: Induction Motor Torque MCQ Question 1: 3- SRIM is having slip at full load S₁ = 0.05 Rotar…

A: Given- 3-phase SRIM, Sfl=0.05, Rotor resistance r1=0.2 Ω, External resistance rex=0.4 Ω, To Find-…

Q: ssuming that output Q=0 initially (before point A), apply the waveforms x and y shown in the figure…

A:

Q: A transformer has a primary voltage of 120 volts and a secondary voltage of 18 volts. The primary…

A:

Q: This is another set. Please help me find and solve the Color coded value, Actual resistance value,…

A: It is given that: Color Coded  Color Coded Value Actual Resistance Value Maximum Tolerance Value…

Q: 1. Using the characteristics shown below, determine ID and V, for the circuit provided. a. Use the…

A: The load line can be drawn in the given characteristics curve to calculate the diode voltage and…

Q: b) Referring to the circuit below use Kirchhoff's laws to calculate the currents flowing in each…

A: In this question,  We need to determine the current in the each Branch using the KCL and KVL.  We…

Q: Digital transducers

A: Given :- A transducer To find :- Digital transducer produce analog output. Device which changes the…

Q: The timing diagram below shows the input waveform of a NAND latch. Complete the diagram by showing…

A: The latch is a level triggered device that changes its state whenever level of the clock is high.…

Q: assume that tthe circuit shown in figure 21-1 is connected to a 480 v 60 hz line. the capcitor has a…

A:

Q: Question-9 b A 4-pole turbogenerator is rated at 150 MVA, 14 kV and 60 Hz. Its inertia constant is…

A:

Q: Example 4. Assume that there is no initial energy stored in the following circuit at t = 0, and that…

A:

Q: TRUE OR FALSE A. Built-in potential in the depletion region of a p-n junction is zero. B. Minority…

A: We need to check whether the given statement are true or false.

Q: If the armature current in a dc machine is 400A, what should be the current in each winding if the…

A: Given Armature current = 400 Amp, No.of Poles = 10 To calculate current in each path

Q: The equations below are all false except one. Choose the only correct equation. 25 Ω 1+ i₁ 100 V O…

A: Note In Ideal transformer,  V1/ V2  = N1/ N2 I1 / I2= N2/ N1 V1 I1 = V2 I2 1 stands for primary…

Q: TRUE OR FALSE A. Diffusion of charge carriers in a p-n junction is dependent on the concentration…

A: Answer is given below in step 2

Q: As the magnitude of the error signal increases, the derivative control mode mode ; as the magnitude…

A: Error Signal:- The difference between the input variable and the feedback variable is referred to…

Q: The current through a 5-mH inductor is shown in following Fig. Determine the voltage across the…

A: voltage across the inductor VL = L×didt first determine the current equation then obtain the voltage…

Q: If the 10 Ampere DC Motor uses a carbon brush and graphite with a 0.05 ohms of resistance, what is…

A: Given,   DC motor having  Current (I) = 10 A Resistance of carbon brush and graphite (R) = 0.05 ohms…

Q: What are the voltage gain, input resistance, and output resistance of the amplifier in Fig. P10.60…

A: Given, The circuit diagram, The resistor, R1=8.2 KΩR2=750 KΩ

Power Amplifier

The power amplifier is an electronic amplifier designed to maximize the signal strength of a given input. The input signal strength is enhanced to a high enough level to drive output devices such as speakers, headphones, RF (Radio frequency) transmitters, etc. Unlike voltage / current amplifiers, the power amplifier is designed to drive core loads directly and is used as a storage block in the amplifier series.

Maximum Efficiency Criterion

In every field of engineering, there is a tremendous use of the machine and all those machines are equipped for their popular work efficiency so it very much important for operation engineers to monitor the efficiency of the machine, planning engineers to check out the efficiency of the machine before installing the machine and design engineers to design machine for higher efficiency than and then the utility will procure their products that will ultimately lead to profit and loss of the company. It indicates the importance of efficiency right from the initial stage as manufacturing units, intermediate stage as planning coordinators, and end-users stage as a utility.