A pump test was conducted on a test well drilled into a confined aquifer, with the results showr ** elow. If water was pumped at a steady flow of 205 gal/min, deter..... the coefficient of permeability (k in ft/sec) of the permeable soil in the aquifer. 150 ft 75 ft IMPERMEABLE LAYER 20 ft: 12 ft TEST WELL IMPERMEABLE LAYER C5 fax 0.5e. AQUIFER 16 ft OBSERVATION WELLS Lectures: Dr. Christinn

A pump test was conducted on a test well drilled into a confined aquifer, with the results showr ** elow. If water was pumped at a steady flow of 205 gal/min, deter..... the coefficient of permeability (k in ft/sec) of the permeable soil in the aquifer. 150 ft 75 ft IMPERMEABLE LAYER 20 ft: 12 ft TEST WELL IMPERMEABLE LAYER C5 fax 0.5e. AQUIFER 16 ft OBSERVATION WELLS Lectures: Dr. Christinn

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.23P

See similar textbooks

Similar questions

For a falling-head permeability test, the following values are given: Length of specimen = 200 mm Area of soil specimen = 1000 mm^2 Area of standpipe = 40 mm^2 Head difference at time t = 0 = 500 mm Head difference at timt t = 3 minutes = 300 mm Determine the hydraulic conductivity of the soil in ×10−4cmsec Please answer this asap. For upvote. Thank you very much
The section size of a water pipe is (100cm Χ 100cm), three types of soils A, B, and C are placed in the pipe, and a fixed amount of water is injected into the top left tap to keep the water head difference between the left and right ends of the pipe 60cm. The three soil permeability coefficients are k_A = 0.05 cm/sec , K_B = 0.1 cm/sec, k_C = 0.001 cm/sec, please calculate the following values:(1) The fixed amount of water injected into the faucet on the upper left (cm3/hr)(2) What is the total water head consumed by each of the three soils of A, B, and C (cm)(3) The overall volumetric seepage force of water flowing through the three soils (kN/m3)
) A pumping test carried out in a 50 m thick confined aquifer resulted in a flow rate of 600l/min. The thickness of the impermeable layer above the aquifer is 20 m and the originalwater level in the well was 2 mm below the ground surface (which is also the top of theimpermeable layer). Drawdowns in two observation wells located 50 m and 100 m fromthe well are 3 and 1 m respectively. Calculate:i) The coefficient of permeability of the aquifer, ii) The drawdown in the well, iii) The radius of influence. The diameter of the well is 0.6 m.
An unconfined aquifer is 100 feet thick was evaluated using a field pumping test. The depth to groundwater is 10 feet. At a distance of 1000 feet, the drawdown was 40 feet, and at a distance of 5000 feet it was 20 feet. Find the permeability of the aquifer assuming that a steady-state of 960 gal/minute during the test in ft/sec.
H2 = 0.3’ h = 1.25’ H1 = 0.2’ d = 1.5” H = 0.5’ D = 4” Ksand = 0.000075 ft/min Ksilt = 0.0038 ft/min Determine: Determine the total flow of water q. Find the equivalent permeability for the soil.
A concrete dam retains water to a height of 9 m. It has rows of sheet piling at both heeland toe which extend half way down to an impervious stratum. From a flow net sketchedon a transformed section, it is found that there are four flow channels and sixteen headdrops. The average horizontal and vertical permeabilities of the soil are 6 × 10^–3 mm/sand 2 × 10^–3 mm/s, respectively. What is the seepage in cubic meter per day, if the lengthof the dam is 150 meters?
The following data relate to a pump-out test: Diameter of well = 24 cm; Thickness of confined aquifer = 27 m; Radius of circle of influence = 333 m; Draw down during the test = 4.5 m; Discharge = 0.9 m^3/s.What is the permeability of the aquifer in mm/s? Choices: a. 2.15 x 10^-2 b. 4.5 x 10^-1 c. 93 X 10^-1 d. 1.6 X 10^-1
Q#4 : For the concrete Dam shown in figure, determine the total average seepage for the given permeable strata by drawing Flow Net. The detail dimensions are given on the figure. The head of water on upstream side is 6ft and on downstream side is 1ft. Assume of Nf= 3, Nd= 6 and rectangular flow elements. Use MSpaint or graph paper
A pumping test was carried out in a confined aquifer 15m thick overlain by an impermeable layer 30m thick. Rate of pumping was 0.12 m3/s, drawdowns in observation wells located 15m and 30m from the center of the pumping well were 1.60 m and 1.40 m respectively, from the initial groundwater level. The diameter of the pumping well is 0.40m. Determine the coefficient of permeability
A well pumping test was carried out to determine the bulk permeability of a confined aquifer. The aquifer was overlain by a clay layer 4m thick, the depth of the aquifer was 20m, and the initial piezometric level in the aquifer was 2m below ground level. After a period of pumping when steady state conditions had been reached, the following observations were made:pumped flowrate q=1.637 li/swell radius=0.1mdrawdown just outside well = 2mdrawdown in piezometer at 100m distance from well = 0.2m.Determine the bulk permeability of the aquifer in m/s . Use the format for your answer 1.111 x 10^(-4).
For a falling-head permeability test, the following are given:length of specimen = 380 mmarea of specimen = 6.5 cm2k = 0.175 cm/minWhat should be the area of the standpipe for the head to dropfrom 650 cm to 300 cm in 8 min?
A well with a diameter of 18 in. penetrates an unconfined aquifer that is 100ft thick. Two observation well are located at 100 ft and 235 ft from the well, and the measured drawdownsare 22.2ft and 21ft, respectively. Flow is steady and the hydraulic conductivity is 1400 gpd/ft^2. What is the steady-state rate of discharge from the well?