Answered: A pure ALOHA network transmits 200-bit…

A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the throughput if the system produces, (i) 1000 frames/sec (ii) 500 frames/sec

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 4RQ

See similar textbooks

Related questions

Q: For a binary transmission link, the uncoded E/No ratio is 9 dB and matched filtering with polar…

A: Given Eb/N0 = 9db Eb/N0 is the SNR in db SNR(db) = 9 10*log10(SNR)=9 SNR = 7.943

Q: The rate osferring a frame of 58500 bits in a network is 160 bps. Calculate the taken time in…

A: The calculation is given in step 2.

Q: A channel has a bit rate of 4 kbps and a propaga- tion delay of 20 msec. For what range of frame…

A: The Answer is

Q: Ethernet implements the Frame Check Sequence (FCS) using a technique called Cylic Redundancy Check…

Q: A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the…

A: The Answer is

Q: In a digital transmission, the sender clock is 0.2 percent faster than the receiver clock. How many…

A: It is can be solved by finding the extra percentage of the total data sent in one second. Below is…

Q: For an 8-PSK system, operating with an information bit rate of 24kbps determine baud, minimum…

A: According to the information given:- We have to define baud, minimum bandwidth and bandwidth…

Q: A 20 Kbps satellite link has a propagation delay of 400 ms. The transmitter employs the "go back n…

A: Introduction :Given , Implementation of "go back n "link bandwidth = 20 Kbps Tp = 400 ns n= 10 Frame…

Q: This type of data transmission allows data to be sent in both directions on the same signal carrier…

A: Introduction: This type of data transmission is known as "full-duplex" because it allows data to be…

Q: In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock. How many…

A: Given: In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock.…

Q: A noiseless channel with a bandwidth of 'B' Hz is transmitting a signal with 16 signal levels. Then…

A: In this problem, we will calculate the maximum bit rate passing through a noiseless channel.

Q: Five Channels each with a 100 KHz bandwidth are to be multiplexed together using Frequncy division…

A: Answer is. The minimum bandwidth is 540 Khz.

Q: What is the maximum data rate of a channel with a bandwidth of 200KHZ if we use four levels of…

A: This question explains about the maximum data rate of a channel with a bandwidth of 200KHz if we use…

Q: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal for…

Q: A 3000km long trunk operates at 1.536 Mbps is used to transmit 64 byte frames. If the propagation…

A: The Answer is

Q: A serial transmission T1 uses 8 information bits, 2 start bits, 1 stop bit and 1 parity bit for each…

A: Introduction serial transmission T1 info bits 8 Start bit 2 Stop bot 1 Parity bit 1 synchronous…

Q: A digital signaling system is required to operate at 512 Kbps. a. If an 8-bit word is used to encode…

A: The Answer is in given below

Q: Exercise (1): A line has a Signal-to-Noise ratio 35dB and a bandwidth of 4000HZ, what is the maximum…

A: Data rate governs the speed of data transmission. A very important consideration in data…

Q: A group of some stations share a 56 kbps pure ALOHA channel. Each of these stations output a 1000…

Q: -A synchronous TDM with four 2 Mbps data stream inputs and one data stream output. The multiplexing…

A: Here we have given the answer for the first question as per the guideline.

Q: (Compute the maximum channel utilization for a MAN which uses CSMA mechanism and has a length of 50…

A: Introduction :Given , A MAN , uses CSMA mechanism Length = 50 Km Bandwidth = 50 Mbps Frame size =…

Q: a) A pure ALOHA channel is going to be shared among some number of stations. Each station is…

A: Actually, 1 byte =8 bits. given each station is transmitting a 1024 -byte frame average every 28…

Q: How many bytes can be stored by a 2Gbps (gigabits per second) link with a delay or latency of 3.2 ms…

A: - We need to calculate the data that can be stored in bytes with a 2Gbps link given a delay of 3.2…

Q: Line coding is done at the data link layer

A: We are asked a true false question on Line coding and whether it is done at data link layer or not.…

Q: Q4\ In IS-95 system, assuming the speed of a vehicle is 100 Kmph, carrier frequency, fe 860 MHz,…

A: the answer is as follows.

Q: Data may be transferred in both directions on a signal carrier at the same time using this kind of…

A: In the given scenario, the type of data transmission is full-duplex. Full-Duplex is the data…

Q: what is the throughput if the system produces the 500 frames/sec then A pure ALOHA network transmits…

A: The Answer is

Q: For an 8-PSK system operating at an information rate of 36 kbps determine, 1. Minimum bandwidth 2.…

A: The Answer is

Q: Q5: An analog signal is first encoded in binary PCM before being transformed to a multilevel signal…

Q: A pure ALOHA network transmits 200-bits frame on a shared channel of 200 kbps. What is the…

A: The answer of this question is given below as:

Q: Match the Protocol Data Unit (PDU) with the OSI layer. Layer 1 v [ Choose ] Segment Packet Frame…

A: Here in this question we have asked to match the osi layer with thier data unit term.

Q: A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the…

A: Actually, Network is consists of two or more computers that are linked in order to share resources…

Q: (Dont copy) Four digital channels each transmitting at rate 2 Mbps with 4 bits are carried by one…

A: FDM is an analog multiplexing technique FDM is an analog multiplexing techniquethat combines analog…

Q: Four channels are multiplexed using TDM. If each channel sends 100 bytes /s and we multiplex 5 bits…

A: i. The multiplexer is shown in the figure. Show the frame (at least three) traveling on the link…

Q: This kind of data transmission allows for simultaneous data flow in both directions on a signal…

A: Introduction: Because "full-duplex" data transmission allows data to be delivered in both directions…

Q: Multiplexing occurs at the physical layer via TDM, FDM, and CDM. What are the advantages and…

A: Multiplexing's Benefits: - A single medium may carry more than one signal. - A medium's bandwidth…

Q: A digital signal system is required to operate at 9600 bps, If a signal element encodes a 4-bit…

A: Solution: Channel capacity = 9600 bps. The signal element encodes a 4-bit word. This means that,…

Q: What is the number of signal levels required to achieve a data rate of 12400 bps using a channel…

A: Data rate = 12400 bps Bandwidth = 3100 Hz Levels = ?

Q: A group of N station share a 56-kbps pure ALOHA channel. Each station outputs a 1000- bit frame on…

A: N Stations Sharing 56kbps Pure ALOHA Channel here pure ALOHA Usable Bandwidth = 0.184*…

Q: 800 b frames are sent over a 500 kbps communication channel. The communication channel uses GBN…

A: Given : 800 b frames bandwidth=500 kbps GBN protocol with 3 bit seq number propagation…

Q: A slotted ALOHA network transmits 200- bit frames using a shared channel with a 200 Kbps bandwidth.…

A: Introduction : Given , A slotted aloha network Data size = 200 bit frame bandwidth = 200 Kbps We…

Q: n rule, determine the system bandwidth that can transmitted imum bit rate of 10 Gbps when the signal…

Q: This type of data transmission allows data to be delivered in both directions on a signal carrier at…

A: Introduction: The data transmission mode in the present circumstance is full-duplex.

Q: This kind of data transmission allows data to be delivered in both directions on a signal carrier at…

A: This kind of data transmission is called "full-duplex" because it enables data to be delivered in…

Q: In a digital transmission, the sender clock is 0.3 percent faster than the receiver clock. How many…

A: Please find the answer and explanation in the following steps.

Q: A group of N station share a 56-kbps pure ALOHA channel. Each station outputs a 1000 bit frame on an…

A: Find the maximum value of N (the number of stations).

Question

A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps. What is the throughput if the system produces,

(i) 1000 frames/sec

(ii) 500 frames/sec

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

what is the throughput if the system produces the 1000 frames/sec then A pure ALOHA network transmits 200-bit frames on a shared channel of 200kbps.
A 20 Kbps satellite link has a propagation delay of 400 ms. The transmitter employs the "go back n ARQ" scheme with n set to 10. Assuming that each frame is 100 bytes long, what is the maximum data rate possible?
A serial transmission T1 uses 8 information bits, 2 start bits, 1 stop bit and 1 parity bit for each character. A synchronous transmission T2 uses 3 eight-bit sync characters followed by 30 eight bit information characters. If the bit rate is 1200 bits/second in both cases, what are the transfer rates of T1 and T2?
A 8 bit data block with 1 start bit, 2 stop bit, and 1 parity bit using an asynchronous mode of transmission can be transmitted 960 times, What is the data rate of that communication link?
A planet located far from Earth is around 9 x 1010 meters away. If a stop-and-wait protocol is employed for frame transmission on a 64 Mbps point-to-point link, what is the channel utilization? Assume that the speed of light is 3 108 m/s and that the frame size is 32 KB.
8. A pure ALOHA network transmits 200-bit frames on a shared channel of 200 kbps.What is the throughput if the system (all stations together) produces?a. 1000 frames per second?b. 500 frames per second?c. 250 frames per second?
Ten signals, each requiring 4000 Hz, are multiplexed onto a single channelusing FDM. What is the minimum bandwidth required for the multiplexed channel? Assume that theguard bands are 400 Hz wide.
In an asynchronous 8 bit transmission using a UART (8051), the crystal in use is 22.1184 MHz. The required Baud rate is 19200. What is the minimum time to transmit a packet containing 124 bytes? Give the answer in ms.
Consider TDM-based circuit switching with 8000 frames per second and 32 time slots per frame. During each time slot 8 bits are sent. What is the total transmission rate of the whole link in kbps?