A reaction at -6.0 °C evolves 420. mmol of carbon monoxide gas.Calculate the volume of carbon monoxide gas that is collected. You can assume the pressure in the room is exactly 1 atm. Be sure your answer has the correctnumber of significant digits.volume: L A chemical engineer must calculate the maximum safe operating temperature of a high-pressure gas reaction vessel. The vessel is a stainless-steel cylinder thatmeasures 39.0 cm wide and 46.8 cm high. The maximum safe pressure inside the vessel has been measured to be 4.70 MPa.For a certain reaction the vessel may contain up to 2.03 kg of dinitrogen monoxide gas. Calculate the maximum safe operating temperature the engineer shouldrecommend for this reaction. Write your answer in degrees Celsius. Be sure your answer has the correct number of significant digits.temperature: ºcX3

Please note- As per our company guidelines we are supposed to answer only one question. Kindly…

A reaction at -6.0 °C evolves 420. mmol of carbon monoxide gas. Calculate the volume of carbon monoxide gas that is collected. You can assume the pressure in the room is exactly 1 atm. Be sure your answer has the correct number of significant digits. volume: L X 3

A reaction at -6.0 °C evolves 420. mmol of carbon monoxide gas. Calculate the volume of carbon monoxide gas that is collected. You can assume the pressure in the room is exactly 1 atm. Be sure your answer has the correct number of significant digits. volume: L X 3

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter16: Reaction Rates

Section: Chapter Questions

Problem 58A

See similar textbooks

Similar questions

Monochloroethane (C2H5Cl) can be produced by the direct reaction of ethane gas (C2H6) with chlorine gas or by the reaction of ethylene gas (C2H4) with hydrogen chloride gas. The second reaction gives almost a 100% yield of pure C2H5Cl at a rapid rate without catalysis. The first method requires light as an energy source or the reaction would not occur. Yet G for the first reaction is considerably more negative than G for the second reaction. Explain how this can be so.
In Chapter 3, we discussed the conversion of biomass into biofuels. One important area of research associated with biofuels is the identification and development of suitable catalysts to increase the rate at which fuels can be produced. Do a web search to find an article describing biofuel catalysts. Then, write one or two sentences describing the reactions being catalyzed, and identify the catalyst as homogeneous or heterogeneous.
5.12. True or false: If all the partial pressures of reactants and products drop by half, the value of Q drops by half. Give an example of a chemical reaction to support your answer.
Silicon forms a series of compounds analogous to the al-kanes and having the general formula SinH2n+2. The first of these compounds is silane, SiH4, which is used in the electronics industry to produce thin ultrapure silicon films. SiH4(g) is somewhat difficult to work with because it is py-ropboric at room temperature—meaning that it bursts into flame spontaneously when exposed to air. (a) Write an equation for the combustion of SiH4(g). (The reaction is analogous to hydrocarbon combustion, and SiO2 is a solid under standard conditions. Assume the water produced will be a gas.) (b) Use the data from Appendix E to calculate ? for this reaction. (c) Calculate G and show that the reaction is spontaneous at 25°C. (d) Compare G for this reaction to the combustion of methane. (See the previous problem.) Are the reactions in these two exercises enthalpy or entropy driven? Explain.
. Hydrogen gas and chlorine gas in the presence of light react explosively to form hydrogen chloride H2(g)+Cl2(g)2HCl(g)The reaction is strongly exothermic. Would an increase in temperature for the system lend to favor or disfavor the production of hydrogen chloride?
Why are there no changes specified for Ni in Exercise 13.61, part (f)? What property of Ni does change?
Substances that poison a catalyst pose a major concern for many engineering designs, including those for catalytic converters. One design option is to add materials that react with potential poisons before they reach the catalyst. Among the commonly encountered catalyst poisons are silicon and phosphorus, which typically form phosphate or silicate ions in the oxidizing environment of an engine. Group 2 elements are added to the catalyst to react with these contaminants before they reach the working portion of the catalytic converter. If estimates show that a catalytic converter will be exposed to 625 g of silicon during its lifetime, what mass of beryllium would need to be included in the design?
hydrogen peroxide can decompose in the presence of which of the following reaction: 2 H2O2 (l) ———> 2 H2O (l) + O2 (g) H = -196 kj Calculate the value of q when 10.0 g of H2O2 (l) decomposes at constant pressure. Masses of atoms: H(1.0 amu); O (16.0 amu). Show brief calculation steps.
A. Indicate the factors that affect the rate of chemical reactions and explain 1. Rusting of iron but not gold 2. Spoiling of food at a warmer temperature 3. Fermentation of sugars to alcohol using yeast 4. Copper oxide speeds up the decomposition of H2O2 (hydrogen peroxide) 5. Grinding of calcium carbonate before calcining B. From the given reaction 4NH3(g) +5O2(g) 4NO(g) + 6H2O(g) ΔH = 950 KJ. Write True if statement is correct, otherwise write False and explain. 1. The reaction is exothermic. 2. Heating will cause forward reaction to occur. 3. Pressure has no effect. 4. The reaction will go forward if volume is increased. 5. Adding ammonia will cause forward reaction to occur.
A reaction at 32.0 degrees Celsius evolves 882. mmol of carbon dioxide gas. Calculate the volume of carbon dioxide gas that is collected . You can assume the pressure in the room is exactly 1 atm.
The value of ΔG° at 25°C for the decomposition of gaseous sulfur trioxide to solid elemental sulfur and gaseous oxygen, 2SO3 (g) → 2S (s, rhombic) + 3O2 (g) is __________ kJ/mol. A) +740.8 B) -370.4 C) +370.4 D) -740.8 E) +185.2
Consider the decomposition of methanol, as follows. 2 CH3OH(l) → 2 CH4(g) + O2(g) Suppose 200.0 mL of liquid methanol decomposes at 298 K. The density of methanol is 0.792 g/mL. What is ξ and ΔH if ΔrH = 327.7kj/mol? Hint: ΔH=ξ×ΔrH