A reaction between liquid reactants takes place at 14.0 "C in a sealed, evacuated.vessel with a measured volume of 15.0 L. Measurements show that the reaction produced 19. g of boron trifluoride gas. Calculate the pressure of boron trifluoride gas in the reaction vessel after the reaction. You may ignore the volume of the liquid reactants. Be sure your answer has the correct number of significant digits. pressure: P

A reaction between liquid reactants takes place at 14.0 "C in a sealed, evacuated.vessel with a measured volume of 15.0 L. Measurements show that the reaction produced 19. g of boron trifluoride gas. Calculate the pressure of boron trifluoride gas in the reaction vessel after the reaction. You may ignore the volume of the liquid reactants. Be sure your answer has the correct number of significant digits. pressure: P

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter5: Gases

Section: Chapter Questions

Problem 152CP: You have an equimolar mixture of the gases SO2 and O2, along with some He, in a container fitted...

See similar textbooks

Similar questions

A sample of a smoke stack emission was collected into a 1.25-L tank at 752 mm Hg and analyzed. The analysis showed 92% CO2, 3.6% NO, 1.2% SO2, and 4.1% H2O by mass. What is the partial pressure exerted by each gas?
93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
60 Automakers are always investigating reactions for the generation of gas to inflate air bags, in part the because the sodium produced in the decomposition of NaN3 (see Problem 5.59) presents safety concerns. One system that has been considering is the oxidation of graphite by Strontium nitrate, as Sr(NO3)2as shown in the equation below: 5C(s)+2Sr(NO3)2(s)2SrO(s)+2N2(g)+5CO2(g) . Suppose that a System is being designed using this reaction and the goal is to generate enough gas to inflate a bag 61 L and 1.3 atm at 23 C. What is the minimum mass of graphite that should be used in the design of this system?
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
Hydrogen azide, HN3, decomposes on heating by the following unbalanced equation: HN3O(g)N2(g)+H2(g) If 3.0 atm of pure HN3(g) is decomposed initially, what is the final total pressure in the reaction container? What are the partial pressures of nitrogen and hydrogen gas? Assume the volume and temperature of the reaction container are constant.
Helium gas, He, at 22C and 1.00 atm occupied a vessel whose volume was 2.54 L. What volume would this gas occupy if it were cooled to liquid-nitrogen temperature (197C)?
A mixture of chromium and zinc weighing 0.362 g was reacted with an excess of hydrochloric acid. After all the metals in the mixture reacted, 225 mL dry of hydrogen gas was collected at 27C and 750. torr. Determine the mass percent of Zn in the metal sample. [Zinc reacts with hydrochloric acid to produce zinc chloride and hydrogen gas; chromium reacts with hydrochloric acid to produce chromium(III) chloride and hydrogen gas.]
A 275-mL sample of CO gas is collected over water at 31C and 755 mmHg. If the temperature of the gas collection apparatus rises to 39C, what is the new volume of the sample? Assume that the barometric pressure does not change.
You have an equimolar mixture of the gases SO2 and O2, along with some He, in a container fitted with a piston. The density of this mixture at STP is 1.924 g/L. Assume ideal behavior and constant temperature and pressure. a. What is the mole fraction of He in the original mixture? b. The SO2 and O2 react to completion to form SO3. What is the density of the gas mixture after the reaction is complete?
A gas of unknown identity diffuses at a rate of 83.3 mL/s in a diffusion apparatus in which carbon dioxide diffuses at the rate of 102 mL/s. Calculate the molecular mass of the unknown gas.
Metallic molybdenum can be produced from the mineral molybdenite, MoS2. The mineral is first oxidized in air to molybdenum trioxide and sulfur dioxide. Molybdenum trioxide is then reduced to metallic molybdenum using hydrogen gas. The balanced equations are MoS2(s)+72O2(g)MoO3(s)+2SO2(g)MoO3(s)+3H2(g)Mo(s)+3H2O(l) Calculate the volumes of air and hydrogen gas at 17C and 1.00 atm that are necessary to produce 1.00 103 kg pure molybdenum from MoS2. Assume air contains 21% oxygen by volume, and assume 100% yield for each reaction.