A refrigeration cycle is executed with R-134a under the saturation dome between the pressure limits of 1.6 and 0.2 MPa. If the power consumption of the refrigerator is 3 kW, the maximum rate of heat removal from the cooled space of this refrigerator is (a) 0.45 kJ/s (b) 0.78 kJ/s (c) 3.0 kJ/s (d) 11.6 kJ/s (e) 14.6 kJ/s

A refrigeration cycle is executed with R-134a under the saturation dome between the pressure limits of 1.6 and 0.2 MPa. If the power consumption of the refrigerator is 3 kW, the maximum rate of heat removal from the cooled space of this refrigerator is (a) 0.45 kJ/s (b) 0.78 kJ/s (c) 3.0 kJ/s (d) 11.6 kJ/s (e) 14.6 kJ/s

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter45: Domestic Refrigerators And Freezers

Section: Chapter Questions

Problem 2RQ: The operating condition for the single compressor in a household refrigerator is the lowest box...

See similar textbooks

Similar questions

The operating condition for the single compressor in a household refrigerator is the lowest box temperature, which is typically A. 0F B. -20F C. 20F D. 40F
Why is two-stage compression popular for extra-low-temperature refrigeration systems?
How to express the coefficient of performance of a standard refrigerator in terms of the enthalpies of the fluid ?
Consider a refrigeration system using refrigerant-134a as the working fluid. If this refrigerator is to operate in an environment at 20°C, what is the minimum pressure to which the refrigerant should be compressed? Why?
An R-12 refrigeration system using a single compressor serves three evaporators of 50, 30 and 20 tons capacity in parallel to each other with an evaporating temperatures of 0 C(hg = 351.447 KJ/kg), -5 C(hg = 349.321 KJ/kg) and -10 C(hg = 347.134 KJ/kg), respectively. If the condenser is maintained at 40 C(hf = 238.535 KJ/kg), compute the COP of the system. Enthalpy at the end of compression is at 378 KJ/kg.
Consider a refrigrator that operates on the vapor compression refrigeration cycle with R-134a as the working fluid. The refrigerant enters the compressor as saturated vapor at 70 kPa, and exits at 1200 kPa and 90°C, and leaves the condenser as saturated liquid at 1200 kPa. The coefficient of performance of this refrigrator is
A heat pump is installed in a building to heat the space to a constant 22 ⁰C when the outdoor temperature is 15 ⁰C. The heating requirement at these conditions is 30 kW. The system uses R-410a as a refrigerant and operates according to an ideal vapor compression cycle as shown in the figures below. The saturation temperature of the refrigerant in the indoor coil is typically 20 ⁰C higher than the desired space temperature, and the saturation temperature of the refrigerant in the outdoor unit is typically 20 ⁰C lower than the outdoor temperature. (one of those coils is the condenser, the other is the evaporator) Determine the states at points 1 through 4.
A typical 200-m2 house can be cooled adequately by a 3.5-ton air conditioner whose COP is 4.0. Determine the rate of heat gain of the house when the air conditioner is running continuously to maintain a constant temperature in the house.
Consider a real compressor has an isentropic efficiency of 0.82. This refrigeration cycle has a condenser which over cools a liquid to a temperature of 46.3°C and an evaporator temperature of −8.6°C. The mixture changes to a liquid at a temperature of 48.8°C. Determine the coefficient of performance of this refrigerator for the working fluids of R-12,R-134a,and R-410a.
A commercial refrigerator using R-134a as a refrigerant is used to keep the cooled environment at -35 C. The refrigerator releases the waste heat to the cooling water that enters the condenser at 18 C at 0.25 kg / s and leaves the condenser at 26 C. The refrigerant enters the condenser at a pressure of 1.2 MPa and a temperature of 50 ° C, and leaves the condenser at the same pressure, supercooled at 5 ° C. Since the compressor consumes 3.3 kW of power, a) Mass flow rate of the refrigerant, b) Cooling load and COP value c) Calculate the minimum power consumed by the compressor for the same cooling load.
A commercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at –35°C by rejecting waste heat to cooling water that enters the condenser at 18°C at a rate of 0.25 kg/s and leaves at 26°C. The refrigerant enters the condenser at 1.2 MPa and 50°C and leaves at the same pressure subcooled by 5°C. If the compressor consumes 3.3 kW of power, determine the mass flow rate of the refrigerant,
A commercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at –35°C by rejecting waste heat to cooling water that enters the condenser at 18°C at a rate of 0.25 kg/s and leaves at 26°C. The refrigerant enters the condenser at 1.2 MPa and 50°C and leaves at the same pressure subcooled by 5°C. If the compressor consumes 3.3 kW of power, determine the refrigeration load.