Answered: a resistance of 100k ohms is connected…

a resistance of 100k ohms is connected in series with a 100uF capacitor.if the combination is suddenly connected across a 125V DC source, determine the current one second after the switch is closed

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 1RQ: An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in...

See similar textbooks

Related questions

Q: A CAPACITOR OF CAPACITY 10MF CHARGED FOR A VOLTAGE DIFFERENCE OF 15V WAS CONNECTED IN SERIES WITH AN…

A: For the given question we have to calculate potential difference across each capacitor after…

Q: 10-ohm resistor and 10 H inductor are connected in series across a source of 12 V. If the current is…

Q: A coil of resistance 10 22 and inductance 0.8 H is connected to 200 V dc supply. The initial rate of…

A: Given: A coil of resistance, R=10 Ω Inductance, L = 0.8 H DC supplied voltage, V = 200 V

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: 2. A 4-mF capacitor has the current waveform shown in the figure. Assuming that v(0)=10 V, sketch…

Q: A capacitor that is initially uncharged is connected in series with a resistor and a 300.0 V emf…

A: Given: Series RC circuit EMF, V=300 V Source internal resistance is negligible. Current through…

Q: 20. In the circuit shown, initially the switch is open and all the capacitors are uncharged.…

Q: A 12.0 V battery is connected into a series circuit containing a 16.0 N resistor and a 1.50 H…

A: Case 1) a and b RL circuit charging case 2) c and d RL circuit discharging Given R=16 ohm L=1.5 H…

Q: Design a simple charging circuit using a 100 V source, a 1M resistor and a capacitor. The circuit…

A: The capacitor will not reach its final immediately after giving the input it will take five times…

Q: } A 12.0-V battery is connected in series with two resistors and an inductor. R, = 100 W and R, =…

A: In this question series RL circuit with DC source is given..We have to find out current through…

Q: When the electromotive force (emf) is removed from a circuit containing inductance and resistance…

Q: A vehicle with a 24 V accumulator will have two 12 V, 60 W headlight bulbs. ww m lighting system is…

Q: A resistor-inductor circuit is supplied by a variable voltage source defined by 3 sin(2t) in Volts.…

Q: 3. Four capacitors are connected to a EMF as shown with C, = 20 µF, C2 = 4 µF, C3 = 3 µF, and C4 = 4…

Q: 7. The initial rate of current rise in an R-L circuit is 350 amp per sec when 220 volts is suddenly…

A: Given initial rate of rise of the current in the circuit di/dt = 350 amp/sec And 220 v is suddenly…

Q: a) A coil of inductance 5H and internal resistance 202 is placed in parallel with a resistor of…

A: As per Bartleby guidelines we are allowed to solve only one question, since these parts are…

Q: at: During this COVID-19 pandemic, how will you design your ideal capacitor which is possible to…

A: A capacitor is known as the two-terminal device formed of two conductors which are separated by a…

Q: What is the general statement of the self-solution in a circuit composed of a linear time invariant…

A: Interconnection of elements like resistors, capacitors, and voltage sources are called Network. Here…

Q: A 10 pF capacitor is connected in series with a 100 kilo-ohm resistor across a 100 V DC supply.…

A: (a) Time constant = RC C = 100×103×10×10-12 C = 1 μ sec(b) steady stule voltage…

Q: v(t) = -3e-3t V and i(t) = 4 + 2e-3t A fort >0

A: Designing a circuit can be done in multiple way. It is depend on the designer and their knowledge.…

Q: Q5. If three capacitors, C, = 5µF, C2 = 10µF and C3 = 20µF are connected in parallel across %3D %3D…

Q: taking the square root of the mean. 5. A condenser of 1 µF capacitance is charged to 100 volts and…

Q: 2. series RLC circuit has a resistance of 60 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A: Series RLC circuit has the following parameters : R=60 ΩC=10-2 FL=5 Happlied voltage=20sin5t volts =…

Q: 6. A series circuit connected across a 100-Vac source consists of a 10-N resistor, a 5-Q capacitor,…

A: The solution is given below

Q: The capacitors C, C, C3, C4, and Cs are charged with a battery of V = 10 volt as shown in the…

Q: A 200 resistor, a 0.01 H inductor and a 100 uF capacitor are connected in series A DC voltage of 100…

A: In this question we need to find a how the current through the circuit varies with time. Find the…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: A capacitor of capacitance 4700mF is charged to a potential difference of 18v. It is then partially…

Q: A coil having a resistance of 30 ohms and an inductance L is connected in parallel with a resistor…

A: This question belongs to circuit theory . It is based on the concept of power consumption in the…

Q: A. Simplify the circuit below by finding the equivalent resistance and equivalent capacitance. Show…

A: Given circuit shown

Q: 2. Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance…

A: In this question, Find the current I and charge Q at steady state conditions. If R= 45 ohm L =…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

A: GivenResistance R= 20 ohm Inductance L= 0.05H, Capacitance C= 100uF. Voltage V= 100cos(200t)…

Q: A 0.8-H inductor is connected in series with a 7-ohm resistor. If the connection is energized from a…

Q: An inductor of 5H, a resistor of 20ohms, and a capacitor of 20mF are connected in series with a…

Q: You are provided with three capacitors of values 4μF, 6μF, 30μF and 220V power supply. Connect the…

A: As per the guidelines of Bartleby we have to solve first three sub part of the question. For…

Q: For the circuit in Figure 1: a) Determine the equivalent capacitance of the system. b) If the…

Q: Two capacitors C1 and C2 are marked ‘200 pF, 500 V’ and ‘300 pF, 900 V’, respectively. If they are…

A: Given C1 = 200pF and C2 = 300pF. Find equivalent capacitance when they are connected in series and…

Q: Problem 4 The current through a 12-mH inductor is 4 sin 100t A. Find the voltage, across the…

A: Need to find energy and voltage

Q: At room temperature (T = 300 k), an ideal solar cell has a short circuit current of 2 A and an open…

A: to find the open circuit voltage

Q: An inductive coil with a resistance R and inductance L is connected in parallel with a 30-ohm…

A: The solution is given below

Q: An inductor and a capacitor are both energy storage elements. Discuss the main differences between…

A: In this question we discuss about inductor and capacitor in terms of their application

Q: A 42 µF capacitor is in parallel with a 230 Ko resistor and a 300 V power supply. The switch is…

A: Resistance absorb active power and dissipate it in the form of heat Capacitor and inductor store or…

Q: H.W: for the circuit shown in figure find: (a) the 12uF 4uF charge in each capacitor. (b) The energy…

A: In this question, We need to charge on each capacitance, energy on each capacitors? And also find…

Q: Two capacitors of 10mF and 30mF are connected in series. Since the equation of the voltage applied…

Q: A 6-mH inductor is used in a fusion power experiment. If the current through the inductor is 5…

Q: A capacitor of capacitance C discharges through a resistor of resistance R. Which one of the…

A: we want to know which statement is not true when a capacitor discharges through a resistance R

Question

a resistance of 100k ohms is connected in series with a 100uF capacitor.if the combination is suddenly connected across a 125V DC source, determine the current one second after the switch is closed

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
In an R-L parallel circuit, ET=240 volts, R=560, and XL=330. Find apparent power.
An AC electric motor is connected to a 240-V, 60-Hz source. A clamp-on ammeter with a peak hold function reveals that the motor has an inrush current of 34 A when the motor is first started. Your job is to reduce the inrush current to a value of 20 A by connecting a resistor in series with the motor. The resistor will be shunted out of the circuit after the motor is started. Using an ohmmeter, you find that the motor has a wire resistance of 3 . How much resistance should be connected in series with the motor to reduce the starting current to 20 A?
A series circuit containing a resistance of 20-ohms, an inductance of 0.10 Henry, and a 100 microF capacitor all connected in series. The applied voltage is 240V at 60 cycles. Find the true Power of the circuit.
A 200 resistor, a 0.01 H inductor and a 100 uF capacitor are connected in series A DC voltage of 100 Vis suddenly applied to the circuit. Obtain the equation showing how the current through the circuit varies with time. Find the maximum current that may possibly occur.
How can four 100 kΩ resistors be connected so that the equivalent resistance of the four equals 250 kΩ? Sketch the arrangement, describe the resistor arrangement in words, and justify your picture by calculating the equivalent resistance. Repeat this part of the question with four 100 F capacitors and an equivalent capacitance of 75 F.
A series RL circuit consisting of a single resistor a single inductor is being supplied by a 20 volt battery. The circuit is currently open and has a initial current of 0 A. The resistor has a resistance value of 100 ahms. If the current flowing through the circuit 1.5 sec after closing the circuit is 0.15 A, find the value of inductance
A coil of 20 ohms resistance has an inductance of 0.2 H and is connected in parallel with a 100 microfarad capacitor. Calculate the frequency at which the circuit will act as a non inductive resistance of R ohms. Find also the value of R.