A resistance of 100n, an inductance of 75.0 mH, and a capacitor of 4.0 µF are onnected in series with a generator (100 volts at 2500 rad/sec). Find a. the current in the circuit b. the voltage across each circuit component c. the power dissipated in the circuit RIVER ENIVER

A resistance of 100n, an inductance of 75.0 mH, and a capacitor of 4.0 µF are onnected in series with a generator (100 volts at 2500 rad/sec). Find a. the current in the circuit b. the voltage across each circuit component c. the power dissipated in the circuit RIVER ENIVER

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.23P: A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the...

See similar textbooks

Related questions

Q: A resistance of 100ohms, an inductance of 75.0 mH, and a capacitor of 4.0 microF are connected in…

Q: A circuit having a resistance of 12Ω, an inductance of 0.15 H and a capacitance of 100μf in series…

Q: 1. A resistance of 1000, an inductance of 75.0 mH and a capacitor of 4.0 uF are connected in series…

A: In this question we will find current , voltage across each circuit element and power dissipated in…

Q: A series circuit composed of a resistance of 24 ohms, an inductance of 0.09 henry and a capacitance…

Q: For the circuit shown, a) To the coil of a henry, measure its internal resistance and the value of…

Q: 23. A 150- microfarad capacitor is connected to a 220 V, 60- cycle source. Calculate a. The…

Q: A parallel circuit of 25 – ohm resistor, 64 – mH inductor and 80 - μF capacitor connected across a…

Q: A 200 – ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in parallel across a…

Q: 1A (b) (a) A * N * 220V C 1 kQ 3 uF 50 Hz (c)V R a.) What is the generic name of the circuit given…

Q: Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal…

A: To determine the current in each branch

Q: 1. Consider the circuit below. Find a value of inductance less than 100 Henries, which ensures that…

Q: AC FUNDAMENTAL Problem Set Problems: 1. The coil having a resistance of 10 Q and an inductance of…

A: impedance of the coil = Resistance2+inductive reactance2 inductive reactance of the coil =…

Q: A 200V, 50 Hz sinusoidal supply is connected to a parallel network comprising three branches A, B…

A: Circuit arrangement

Q: 25. The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A,…

Q: 41. Ideal inductors and capacitors are in phase with each other. True False "By the convention…

Q: A 60 hz voltage of 220 volts from a convenience outlet is impressed on a capacitance of 800 pF.…

A: Choose the correct options If 60Hz , 220V and capacitor C= 800pF Find the effective voltage and…

Q: A three phase star connected motor, connected across a 3-phase star connected supply o 50HZ takes a…

A: In this question we will find capacitance per phase to improve power factor of motor....

Q: A 127 uf capacitor is connected to a 125V 50 cycle source . Calculate (a) the capacitive reactance…

Q: A Coil of Resistance RQ and Inductance L in mH in series with a C in µF Capacitor, is connected to a…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 1. For the following circuit derive the equation for the power factor, where the conducting angle a…

Q: A resistor in series with a 138microfarad capacitor, is connected to a 60HZ source. If the voltage…

A: From given capacitor value and voltage across the capacitor capacitor calculate current through…

Q: Three coils each having resistance 6  and inductance are connected in star with 415V. If the line…

Q: Q1: A three branch parallel circuit has a current locus as given in Figure shown below. Determine…

A: Given:-w=500rad/sec

Q: AC circuit contains resistor 18.7 0, inductor 18 mH, and capacitor 560 µF, where they are connected…

Q: Q3 / A coil of inductance 636.6 mH and negligible resistance is connected in series with a 100 Q…

Q: An RLC series circuit connected to a 110 – volt and 50 – cycle AC source, contains the following…

A: In this question, A RLC circuit connect with 110V , 50Hz battery. Find the all data as per given…

Q: In a three-phase system, the apparent power of a consumer is 700 kVA with a power factor 0.7,…

A: Given values are - S=700kVAcosϕ=0.7LaggingVt=400Volt Given that capacitors are connected in delta.

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

A: In this question, We need to determine the current, voltage across the resistance R and…

Q: A 550-V feeder line supplies an industrial plant consisting of a motor drawing 60 kW at 0.75 pf…

Q: 1. A resistance of 1000, an inductance of 75.0 mH, and a capacitor of 4.0 uF are connected in series…

Q: 2) The three-phase, 50 Hz, 100 km long power transmission line has a resistance per unit length of…

A: Given, Frequency=50Hz, L=Length of transmission line=100Km R=Resistance=0.1×100=10Ω,…

Q: A:(T)The increase in voltage at the line end is dependent on the value of the operating capacitance…

Q: 6) A circuit consisting of a resistor in series with an inductance takes 210W at a power factor of…

A: We are authorized to answer first three parts. As you have not mentioned which part to answer. So,…

Q: Z4956 non-reactive the combined circuit is 500 2, calculate: a) of the capacitor. b) the current in…

Q: A series circuit of RLC with following parameters, R=15 ohm, L=20 m H & C=100 micro Farad.…

Q: A 396-Vrms, 60-Hz supply serves a load that is 17 kW (resistive), 5 KVAR (capacitive), and 14 KVAR…

Q: A series resistance-capacitance (R-C) circuit is connected to a 230 volt 60 cycle source. If the…

A: When R and C are connected in the circuit then Resistance is only responsible for the active power…

Q: 6. A resistance of 50-2 is connected in series with a capacitance of 20 µF. If a supply of 200 V,…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: rt Problem: Given a series circuit comprised of the following element: 67.03-ohm resistor, practical…

Q: 3. A. A coil consists of a resistance of 200 N and an inductance of 2500MH. If an alternating…

Q: 30. Which are used for power factor correction in industrial applications? a. farads b. capacitors…

Q: A single phase motor connected to 400V, 50HZ supply takes 37A at a power factor of 0.8 lagging.…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 1. Choose an ac source voltage with frequency of 60 Hz. 2. Choose a value for the following:…

A: Requirements Power factor of load =0.9 to 0.96 Load is in form of impedance source frequency =60 Hz…

Q: [A] Three identical capacitors are connected in DELTA to a 420V, 50Hz 3-phase supply. If the line…

A: (a) Given: Delta connected capacitors, VL=420 V f=50 Hz IL=22 A Solution: for delta connection,…

Q: 1. An inductive circuit takes a current of 15 A at 0.78 pf when connected to a source 250 V, 50 hz…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: C. Problem Solving. Draw the circuit and show your complete solutions. 1. Given the value of a 6-ohm…

Concept explainers

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors. The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.

Question

Please Include complete solutions, formulas and notes to follow
thank you.

1. A resistance of 10on, an inductance of 75.0 mH, and a capacitor of 4.0 uF are
connected in series with a generator (100 volts at 2500 rad/sec). Find
a. the current in the circuit
b. the voltage across each circuit component
c. the power dissipated in the circuit
d. the phase angle between the current and the voltage in the circuit.
ONIVER

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase source has a terminal voltage V=1200volts and a currentI=1530, which leaves the positive terminal of the source. Determine the real and reactive power and state whether the source is delivering or absorbing each.
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
A series circuit composed of a resistance of 24 ohms, an inductance of 0.09 henry and a capacitance of 8 microfarad, is connected to a 120-volt 50-Hz supply. Calculate (a) the line current, (b) impedance of the circuit, (c) voltage drop, (d) total reactive power, (e) power factor.
Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω are connected in parallel. If the average value of 198 V sinusoidal AC voltage is applied to this system, find the line current, impedance and phase angle of the circuit. (Take the frequency as 60 Hz.)
an R-L circuit takes a current of 7amp that lags behind the 231-volt source by 35elec deg. calculate the power factor, power, impedance, resistance, and inductive reactance of the circuit.
The length of a three-phase power transmission line with a nominal operating voltage of 69 kV is 16km. The impedance of the transmission line per unit length is 0.125 + j0.4375 ohm/ km. At the end of the line, a 70 MVA star connected load with a power factor of 0.8 back under 69 kV interphase voltage is fed. Capacitive circuit element with a capacitance of 19.14 mikro F / phase is placed as shunt at the end of the transmission line. According to these given; a) Line head voltage and current, b) Calculate the active and reactive power per line.
This wind farm needs a 250 km connection laid to Sommerville. The choice is either a 3 phase system or a bipolar dc system at 400 kV and ±400 kV at the receiving end respectively. (i) The 3-phase system has resistive losses per phase of 0.1 Ω/km. Calculate the system losses (in watts) when delivering 0.8 GW. (ii) The bipolar dc system has resistive losses of 0.1 Ω/km. Calculate the system losses (in watts) when delivering 0.8 GW. (iii) Calculate the efficiencies of the two systems. (iv) Comment on which system you would choose to use and why.
The resistance and reactance of the single-phase 60Hz transmission line conductors are 5.4 ohm and 7.4 ohm respectively. The transmission line delivers 45MW at a power factor of 0.65 lagging to the load with 54kV receiving end voltage. Determine the following The inductance of the transmission line in mH Sending end power factor Percentage voltage regulation Percentage Efficiency
Find the following: the power drawn by the 100ohm variable resistor If the variable resistor is set to 200-ohms, instead of 100-ohms, What is the power drawn by the 200-ohms resistor? total current of the system Is the circuit inductive, capacitive, or neither (resistive)? NOTE: Polar form for Voltage & Current. Rectangular form for Impedance
Three-Phase Power Calculations
The resistance and reactance of the single-phase 60Hz transmission line conductors are 7.6 ohm and 6.6 ohm respectively. The transmission line delivers 20MW at a power factor of 0.66 lagging to the load with 54kV receiving end voltage. Determine the following a) The inductance of the transmission line in mH b) Sending end power factor c) Percentage voltage regulation d) Percentage Efficiency
According to the relevant legislation, the reactive energy tariff is not applied to household subscribers with connection power in kW and below, lighting subscribers, single-phase subscribers and producers that provide energy (generation) to the system? a) 5. b) 12 c) 9. d) 50