A resistor of 12ohms and an inductance of 0.025H are connected in series across a 50Hz supply. What values of resistance and inductance when connected in parallel will have the same resultant impedance and p.f. Find the current in each case when the supply voltage is 230V

Q: I- For the circuit given below 2 ΚΩ I mA 2V 0.5V 0.85V- 0.25V- 1V 4V 4kQ 50K0 Vo 3V 2.7v VA VB IV…

A: According to guidelines, only the first question will be solved. For any other solution, please post…

Q: Q4) For the Amplifier shown in Figure (2), Find V. in terms of V; and V.. 20 Vb 40 m V1 Va ww 1.0kQ…

A:

Q: 3. What is the rated full-load current of a %4-horsepower, 208-volt single-phase motor?

A: We need to find out the current for given power

Q: 1. Use mesh analysis to find vo(t) if is = 20 Ω wwww 10cost(30t + 20°)Α 0.1 0. 40 Ω 50 με 100 m.Η

A:

Q: B) Consider the network in Figure 3b. Ι, ΙΩ 1₁ =-j252 17 16 Figure 3b Given that the instantaneous…

A: Given :V=162sin(2πft)Vin phasor domain:V=Vm2=1622=16∠0°V Series combination or impedace is:Zeq…

Q: What is the value of the slip of an induction motor at rated speed?

A: Answer:The value of slip is zero.

Q: Find the convolution of x(n)=(1/3)n  u(n) and h(n) = δ(n)+(1/3)n u(n). Hint use the convolution…

A: Given  An input and h(n), we need to determine the output using convolution theorem. Please find the…

Q: b) 350 C charge passes a cross section in a conductor within Y minutes. What will be the power in…

A: Whenever a terminal is open is called as a open circuit and no current flows through a open circuit.…

Q: 1. Find the all-day efficiency of a 500 kVA distribution transformer whose copper loss and iron loss…

A: In this question we need to find a all day efficiency of transformer for given loading conditions

Q: نقطة واحدة * ?M-ary help to drive System complexity System simplicity Power improving ] maintain the…

A: Given  Multiple choice question based on M- array modulation technique. Please find the answer with…

Q: Draw the circuit diagram and the output waveform of a Zero Crossing Detector if the input is…

A: Circuit diagram and output waveform of Zero crossing detector:

Q: Example: Determine armature torque and motor speed of 220V, 4-pole series motor with 800 conductors…

A: In this question,  We need to determine the speed of the motor and torque T?    We know  Torque T=…

Q: Two identical uniform line charges lie along the x and y axes with charge densities pl = 10[μC/m].…

A:

Q: 41. Review. The heating element of an electric coffee maker operates at 120 V and carries a current…

A: Given, The heating element of a coffee maker operates at 120V and carries a current of 2.00A water…

Q: Make the described voltage multiplier circuit, determine the voltage charge in each capacitor, and…

A: Voltage Doubler:  A voltage doubler is an electrical circuit that charges capacitors from the input…

Q: .Define the return loss, reflection coefficient and if the return loss (R.L) for a load is 12dB.…

A:

Q: For the amplifier network shown in the figure, neglect the le 012 sin(2m*1000t-180°) Ob8…

A: We need to find out the output voltage for given circuit

Q: 10 V, Rs kQ2, Rc = 10 kn, R₁ = 15 k2, and C₁ = 9m 39.2 mA/V, C₁ = Cn2 = C₁ = T

A: It is given that, V+=10 VV-=-10 VRS=0.1 kΩR1=42.5kΩR2=20.5kΩR3=28.3kΩRE=6kΩRL=15kΩCL=0 The…

Q: 5-horse- a nameplate full-load

A: Given as, Nameplate full-load current =185A Minimum capacity of the conductor is 125%. full load…

Q: Write a report on system control strategies and techniques used in engineering.

A: The term system control refers to the controlling of any system. In terms of electrical system, it…

Q: Q3: find the time Response parameters (Tr, Tp, O.S.Td, Ts) Step response Unit step response of…

A:

Q: In the context of digital communication, please explain Communication Channel and Noise in detail.

A: Given  we need to enumerate communication channel and noise in detail. Please find the below…

Q: 2. The primary and secondary windings of a 500 kVA, 6600/400 V transformer have resistances of 0-420…

A: As per the guidelines of Bartley we supposed to answer first question only for solution of remaining…

Q: A circuit consisting of a filter and an op-amp is shown in the figure below (fig. 7). If R1 = 5…

A:

Q: Draw the circuit diagram of a non-inverting comparator and inverting comparator

A: Circuit diagram of non- Inverting and Inverting Comparator:

Q: Q1/ Draw the bode plot below on the semi-log paper and find GM and PM for G(s)H(s) = 1…

A: The bode plot can be drawn by converting the transfer function into bode form and then calculate the…

Q: 2ks2 20V Si Ge Ge Determine the diode current. 2kQ Vo

A:

Q: what is the curret gain?

A: BJT (bipolar junction transistor)A transistor having a three terminal made up of semiconductor…

Q: resonant peak

A:

Q: In the network shown, what is the value of le in mA?

A:

Q: 3. Find all-day efficiency of a transformer having a maximum efficiency of 98% at 15 kVA at unity…

A: In this question we need to find a all day efficiency of the given transformer.

Q: age was 11) What the voltage drop over three conductors (with resistance of 0.2 ohms per 50m)…

A:

Q: What is the minimum conductor size, overload protection, and inverse-time circuit- breaker rating…

A: Conductor: A conductor, often known as an electrical conductor, is a substance or material that…

Q: A quaternary PCM system w sinusoidal modulation signa of the desired SNR if 50 dB, find t levels of…

A:

Q: Two resistors are connected in parallel as shown in the figure. What is the value of R, and I7? + VT…

A:

Q: Assume a single phase transformer with primary and secondary winding. Explain what would happen if a…

A: Transformer is a static device which is used to step up/down the voltage or current level without…

Q: 35. A wire of resistivity 2.8 x 10-8 m and length 20 m must dissipate electrical energy at a rate…

A: In this question,  We need to determine the cross sectional area of the wire if  Energy at a rate P=…

Q: Design the fixed bias circuit from the load line given in the figure below. IC sat. =10mA IB=60UA…

A:

Q: Q3-A) The all-day efficiency of 250 KVA transformer is 96.5% when it is loaded follows 10 hours 9…

A: Given,kVA rating =250 kVAη=96.5%For 10 hours,150kW at 0.8 lag PFFor 9 hours,180kW at 0.9 lag PFFor 5…

Q: 1- An FM modulator has a carrier frequency of 200 MHz, is frequency modulated by a sine wave signal…

A:

Q: 2. Determine the transfer function of the circuit.

A:

Q: 4. What are the minimum allowable ampacities of the phase conductors and the neutral conductor that…

A: Given information about a 2-phase, 3-wire motor is Rated supply voltage Vt=230 Volts. Rated output…

Q: power induction motor?

A: Given as, Voltage, V= 600-volt, Power, P=50 hp=50×746 W, Lets take, cos ∅=0.8.

Q: Calculate the distribution factor for a single layer 18 slots 2-pole three-phase stator winding

A: Given: 3 phase stator winding Number of slots = 18 Number of pole = 2

Q: 3. A 500/250 V, 1-phase transformer has constant losses of 150 W. When delivering an output of 8 kW…

A: In this question we need to find a variable loss of the transformer for given loading conditions. In…

Q: Q5-(A)- The all-day efficiency 200 KVA transformer is 96% when it is loaded follows 12 hours 120 k w…

A: From the given data we only we only need data regarding to maximum efficiency of the transformer.…

Q: Draw the circuit of a V-I converter and derive an expression for the output current in terms of…

A: V-I CONVERTER : A voltage to current converter (V to I converter) is an electrical circuit that…

Q: 7: What is the name of the comparator if the reference voltage is 0V

A: If the reference voltage is 0v then it is known as zero crossing detector(voltage comparator).

Q: 5. What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is…

A: In this question,  We need to determine the full load current if voltage V= 230V ,  Power P= 125hp…

Q: Determine the mesh currents i and i.

A: It is given that: