A rigid steel container is partially filled with a liquid at 15 atm. The volume of the liquid is 1.23200 L. At a pressure of 30 atm, the volume of the liquid is 1.23100 L. Find the coefficient of compressibility in GPA^-1 of the liquid over the given range of pressure if the temperature compression is allowed to return to its initial value.

Q: How much work (in ft-lb) is done when 10 ft of an air is initially at a pressure of 1 atm and a…

A: 0 is the correct answer. Since the volume of cylinder remains constant. It is an isochoric process.…

Q: What is the bulk modulus of elasticity of a liquid if a pressure of 150 psi is applied to 15 ft3 of…

A:

Q: H.W- The weight(9N) falls with in cylinder at constant velocity of 46mm/sec with dimeter=149.5mm.…

A:

Q: A closed cylindrical vessel contains a fluid at a pressure of 625 psi. The cylinder, which has an…

A:

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: A rectangular gate having a width of 4 ft is located in the sloping side of a tank as shown in the…

A: Given:  Inclined submerged gate  Dimensions of gate  To find: Value of P as shown in figure

Q: The air in an automobile tyre with a volume of 0.015 m3 is at 30°C and 140 kPa. Determine the amount…

A: Given data in question  Volume = 0.015m3 Temperature = 30°C Atm pressure  100kPa Initial pressure…

Q: The 700-N force is applied to the 100-kg block, which is stationary before the force is applied.…

A: Given:- The mass of the block = 100 kg  The force on the block = 700 N  The block is stationary…

Q: 2.) A liquid having a Reynolds number of 1500 flows thru a 200-mm diameter pipe, 220m long. The head…

A:

Q: The mass of a wooden block of 25 kg shown in the figure below is supported by an elastic spring with…

A: Mass of wooden block(M)=25 kg Stiffness of spring(K)=25 kN/m Dashpot damping coefficient(C)=0.2 Mass…

Q: n. B 45° 450 W,- W, 500 Ibs 20°

A:

Q: 37 T1 The rod with a mass of 50 kg in the figure above is homogeneous and its length is 10 m. Since…

A:

Q: A bumper, consisting of a nest of three springs, is used to arrest the horizontal motion of a large…

A:

Q: Consider a 1-m wide inclined gate of negligible weight that separates water from another fluid. What…

A:

Q: 2.35 A rubber sheet of thickness t and area A is compressed as shown in the figure. All contact…

A: Show that the change in the thickness of the rubber sheet caused by the load P ,as given above

Q: An irregular container, closed at the end, is filled with water (999 kg/m3). Consider the opening…

A: Density of water, ρw =999Kgm3The given container is filled with water and left limb is open to…

Q: A flat plate of area 1.5x10 6 mm2 is pulled with a speed 0.4m/s relative to another plate located at…

A: Area of flat plate, A=1.5×106 mm2=1.5 m2 Speed of flat plate relative to another plate, du=0.4 m/s…

Q: Example 6.24. A sliding block, having a mass of 40 kg, slides over a 40 mm dia 1200 mm long…

A:

Q: w = Wo-kc? 8kw/m B. am 4m

A:

Q: The velocity field in a flow system is given by v = 2i + (x+y)j + (xyz)k. The acceleration of the…

A: Calculate the acceleration at (1,1,2)?

Q: A compressed liquid is a cylinder that has a volume of 0.400 m ^ 3 at 70Pa and a volume of 0.396m ^…

A:

Q: The can, which weighs 0.2 lb, has an open end. If it is inverted and pushed down into the water,…

A:

Q: The difference in pressure across a soap bubble of diameter 0.005 m immersed in water (surface…

A: Given data, Soap bubble diameter D = 0.005 m Surface tension of water T = 0.072 N/m Pressure…

Q: HW1: In Figure below , the 1200N block is acted upon by the 600N force and the unknown force P as…

A: Concept: Given problem can be solved using equations of static equilibrium and resolving forces in…

Q: 3. What is the diameter change of a 50-ft spherical tank made of ½" steel plate due to internal…

A: Internal diameter = 50 ft.  wall thickness = t = 0.5'' v = 0.3. p = 100 psi. E = 30,000,000 Psi.

Q: The vertical reducing section shown in the figure contains oil with S flowing upward at the rate of…

A:

Q: In figure 2.5, if the pressure of gas in bulb A is 50 cm Hg vacuum anc Patm = 76 cm Hg, the height…

A:

Q: The block weighing 1 kN is subjected to the forces as shown. Assuming the block starts at rest,…

A: Force in the vertical directionmg = 800Sin30 + 1000×35⇒mg = 1000⇒m = 101.937 Kg

Q: In the figure shown, given that the absolute pressure at B is 290 kPa. Therefore, the value of "h"…

A:

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: Consider the tank shown. Which of the following pressure relations is correct? Air Air 2 ft 3ft Air…

A:

Q: Problem 6. What is the bulk modulus of a liquid which is compressed in a cylinder from a volume of…

A: Given data : Initial pressure (P1)=80 N/cm2Final pressure (P2)=150 N/cm2Initial volume (V1)=0.0125…

Q: 500 N 90° A 30° 450 N B

A: Determine the friction force between A and B.

Q: A time dependent force F(t) is applied on a block (initially at rest) which is resting on a rough…

A:

Q: A cubic meter water is subjected to a pressure increase of 20 MPA. If the bulk modulus of elasticity…

A: We know Bulk modulus=Change in pressureChange in volume

Q: 4) A plate is at a distance of 0.025 mm from a fixed plate and is moving at speed of 60 cm/s when a…

A:

Q: 2.) A liquid having a Reynolds number of 1500 flows thru a 200-mm diameter pipe, 220m long. The head…

A: Given that  Reynolds number = 1500 Diameter = 200 mm Length = 220 m long Head loss = 0.20 Required…

Q: 1. A flow in which the quantity of liquid flowing per second is constant, is called flow. A. O…

A: The flow in which the quantity of liquid flowing per second is constant is called STEADY FLOW.

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Volume of water in container=1m3 It is required to determine the change in volume of water when a…

Q: Fluid Mechanics A drop of water at 20oC is forming under a solid surface. The configuration just…

A: Assume:The surface tension of the water (σ) at 20ºC is 0.073 N/m.The value of acceleration due to…

Q: Block A has a mass of 100 kg and the coefficient of friction is 0.20. Determine the friction force…

A: Determine friction force  between     Aand B,FAB

Q: The 10-kg block is moving with an initial speed of 4 m/s. The coefficient of kinetic friction…

A: Draw the free body diagram.

Q: Example 6.24. A sliding block, having a mass of 40 kg, slides over a 40 mm dia 1200 mm long…

A: Given :

Q: A box with one inlet and two outlets is shown in the figure below. The fluid is oil with a specific…

A: Given -

Q: 9. A beaker is filled with a liquid of density p1 up to a certain height. A is a point, h m…

A: Solution : The pressure at point A will be decreased according to the condition which is mentioned…

Q: A beaker of height (h) 1 m is filled with an oil of specific gravity (SG) 1.17. If the acceleration…

A:

Q: Q2: For the figure ,point A is (30 cm) below the surface of liquid, What is the pressure. * s2'1=P…

A:

Q: 1.9 Apply the grid method to calculate the density of an ideal gas us- ing the formula p = p/RT.…

A: Given data:P=35 psiR=1716 ft-lbf/slug-°RT=100 °F

Q: roblem: A homogeneous cylinder weighing 32.2 Ib has a narrow slot cut in it as shown. A force of 12…

A:

Q: 8- If a liquid has an amount of viscosity (0.0048 poise) Calculate the sternum of the sternum…

A: Given data viscosity= 0..48 poise u=15y+2   So, dudy=15