A river bed consists of a layer of sand 8.25 m thick overlying impermeable rock; the depth of water is 2.50 m. A long cofferdam 5.50 m wide is formed by driving two lines of sheet piling to a depth of 6.00 m below the level of the river bed and excavation to a depth of 2.00 m below bed level is carried out within the cofferdam The water level within the cofferdam is kept at excavation level by pumpi

A river bed consists of a layer of sand 8.25 m thick overlying impermeable rock; the depth of water is 2.50 m. A long cofferdam 5.50 m wide is formed by driving two lines of sheet piling to a depth of 6.00 m below the level of the river bed and excavation to a depth of 2.00 m below bed level is carried out within the cofferdam The water level within the cofferdam is kept at excavation level by pumpi

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter15: Braced Cuts

Section: Chapter Questions

Problem 15.6P

See similar textbooks

Similar questions

A 10-m-thick layer of stiff saturated clay is underlain by a layer of sand (Figure 9.28). The sand is under artesian pressure. A 5.75-m-deep cut is made in the clay. Determine the factor of safety against heaving at point A.
A 5m thick clay (Gs = 2.65, water content = 0.28) is overlain by a 4.5m thick layer of sand (Gs = 2.60, e = 0.70, S = 0.85). The ground water table is locate 4.5m from the ground surface. 1. at what depth would the vertical effective stress be equal to 120kpa?2. what is the vertical effective stress at a depth 9m below the ground surface? 3. what depth of excavation required to reduce the effective stress at the bottom of the clay layer by 100kpa?
Problem # 4. A 2m. clay layer has values of e = 0.92, Gs = 2.72 and liquid limit of 40%. Above the clay is a 3m thick layer of sand with e =0.50 and Gs = 2.62. The water table is located 1.6 m below the ground. If a 3m thick backfill is placed on the ground surface having a unit weight of 17.3 kN/m^3, determine the following: a. Compression index of clay.b. Effective pressure at the midpoint of clay.c. Primary settlement for normally consolidated clay.
In typical deposit of submerged soil, the approximate depth at which the inter-granular pressure is equal to 60 kN/m² is: (Ysat = 30 kN/m³)
At what depth would total the vertical stress in a deep deposit of clay (e = 1.1, Gs = 2.74)be 100 kPa if the water table is 1 m below the ground surface and the above the watersurface a saturation degree of 90 % exists. What is the effective stress at the same depth?
the coordinates of two points on the virgin compression curve as follows: e (kn/m2) 1.22 108 .97 225 Determine the void ratio that corresponds to a pressure of 300 kn/m2
A wide excavation is made on a site which has the following soil conditions: 0-2 m Gravel: gsat = 21.8 kN/m3, gdry = 18.5 kN/m3 2-6 m Silty sand: gsat = 19.6 kN/m3, gdry = 18.4 kN/m3 6-21 m Heavy Clay: gt = 20 kN/m3 21 m and below: PERVIOUS sandstone The water table is at a depth of 1.5 m below the ground level. The piezometric pressure head at the top of the pervious sandstone is 5 m above the ground surface. If an excavation of depth 10 m is required, and a factor of safety of 1.5 against heave at the bottom of the clay layer is set, calculate the pressure head reduction required in sandstone.
A rectangular channel with width = 10 meters and depth = 2 meters has a flow slope of 0.001 and roughness n = 0.025. The flow rate is 90 m3/s. Determine the shear stress on the channel in Pascals.
At what depth would total the vertical stress in a deep deposit of clay (e = 1.1, Gs = 2.74) be 100 kPa if the water table is 1 m below the ground surface and the above the water surface a saturation degree of 70 % exists. What is the effective stress at the same depth?
What is the intensity of active earth pressure at a depth of 10.0 m in dry sand with an angle of shearing resistance of 30 degrees and unit weight of 18kN /m ^ 3 ?
Estimate the lateral earth pressure developed at a depth 5 m below the soil surface of a loose sand deposit (wet unit weight of soil is 17.5 kN/m3). Also estimate the lateral pressure for the same depth if the sand is in a dense condition (unit weight is 20.5 kN/m3). What would be the total lateral pressure for the loose sand condition described if the water table were at the ground surface?
A long embankment 30 m wide is to be built on ground. The net vertical pressure applied by the embankment (assumed to be uniformly distributed) is 90kpa. The soil profile and stress distribution beneath the center of the embankment is also shown. The value of mv for the upper clay is 0.35m2/MN, and for the lower clay mv=0.13m2/MN. Tthe permeabilities of the cllays are 10-10m/s and 10-11m/s for the upper and lower soil respectively. Determine the final settlement under the center of the embankment due to consolidation