Need help for this. Thank you. Research for the present problems in the Philippines with regards to our transportation facilities on Land. Give at least two concerns for each type and the corresponding possible solution and explanation.

Q: The reduced level of a floor is 99.995 m, the staff reading on the floor is 1.505 m. If the inverted…

A:

Q: #1 Consider the compound beam shown. Suppose that P₁= 1000 N, P₂ = 1600 N, w = 600 N/m and point E…

A:

Q: St. No. A B с D E The table below is the page of a level field book. 1) Calculate the difference in…

A: To find difference in level between A and G Depth of fill at D

Q: The table below contains the cross- sections Areas of road Calculate the volumes of the earth work…

A:

Q: A solid shaft of 150 mm radius is used to transmit torque. Find the maximum torque transmitted by…

A:

Q: Solved Examples Q.6. Show that the natural period of a light weight with central point load is yo/g…

A: solution of above problem is below:

Q: Specify cloth area per compartmeat, ft2.

A: Given data:- The given air is flowing at, 145000 acfm at 1 atm The given temperature is, 220°F

Q: A storage tank of air, 30 inches in diameter, is to withstand an internal pressure of 180 psi with a…

A: Given:- d=30 inches internal pressure=180 psi design factor=3.5 C1020 annealed relative strength=92%…

Q: Assuming the criterion for suspended load transport is u-/v> 0.40 and for transport is u-/v> 0.10, a…

A: Diameter of particle=2mm Kinematic viscosity=1.186 *10-6 m2/s To find Reynolds number nd drag…

Q: A simply supported timber beam is 50 mm by 200 mm in cross-section and 4 m long. If the fiber stress…

A: Given: Cross section= 50mm by 200mm Length =4 m = 4000mm Allowable stress = 8.3 MPa Required:…

Q: According to Lacey's regime theory, what will be the regime scour depth for a channel in soil having…

A:

Q: A loose compacted sand fill is 1.80 m in depth and has a relative density of 40%. Laboratory tests…

A:

Q: * In levelling operation If second reading is more than first, it represents a rise If first reading…

A: In surveying levelling is done to measure the elevation of different points or survey line on the…

Q: What is the slope of EH if distance between them 300m.and R.L of E-30.09and R.L of H=29.25 0.0025 O…

A: Distance between EH(L)=300m To find slope of EH

Q: Q-5 A soil sample has shrinkage limit of 6%, and the specific gravity of the soil grains is 2.6. The…

A: Given data: Soil shrinkage limit, ωs=6 %=0.06 Specific gravity of soil, Gs=2.6 At shrinking limit,…

Q: a graphical solution technique. Your drawing should Upload a pdf file of your final worked solution

A:

Q: Q3: A cast-iron bracket has a cross section and subjected to loading shown; A) If the compressive…

A:

Q: Determine the superelevation required

A:

Q: The table below contains the cross- sections Areas of road Calculate the volumes of the earth work…

A: To find volume of earthwork

Q: The measured length of an inclined distance was recorded to be 417.698 m long.  The difference in…

A:

Q: Problem 21: A rod is composed of three segments and carries the axial loads as shown. Determine the…

A: Stress is defined as internal resisting force per unit area of the cross section. In the given…

Q: In order to determine the DHV from a traffic count worksheet, the first step is to:  Group of…

A: The peak-hour factor (PHF), which can be applied to a specific location or a section of a street and…

Q: Q4: Determine the maximum deflection and its location of the simply supported beam shown in the…

A:

Q: Analyze the beam by drawing the shearing force and bend moment equations. Write your solutions…

A:

Q: 13. A distance between points A and B is measured and recorded as 123.456 m, using a tape that has a…

A: To determine the true distance between A and B.

Q: St. No. A B C D E F The table below is the page of a level field book. 1) Calculate the difference…

A:

Q: A wide, shallow sand-bed channel has a slope of 0.00105 (assume smooth channel banks). The average…

A: Given: Slope, Se = 0.00105 Flow rate, Q = 5380 ft3/s Area, A = 640 ft2

Q: Q2: The solid rod shown in the Figure has a radius of (20 mm). If it is subjected to the forces of…

A: Reference : Mechanics, Stress induced in rod. Given : 2 forces acting at B and radius of 20 mm…

Q: Determine the MPN of coliform organism per 100 ml ?

A: Given. Water sample is analysed for coliform organism by the multiple-tube fermentation method. Test…

Q: A field measures 40 hectares. When 8 cumecs of water was supplied for 6 hours, 30 cm of water was…

A:

Q: A Ax = Note: Point C is 1.5m below left support A. kN B 6 kN 6 m3 m Ay = 1.5 m. C D 12 kN mk 4 kN E…

A: Given data  Find support reaction at A (Ax and Ay)

Q: Two straight lines intersect a of 120°. The radius of a curve two straight lines is 600m. The long…

A:

Q: Q1: A simply supported beam and its cross section are shown in Figure. The beam carries a load of…

A: Given data  B = 200 mm  D = 300 mm  Diameter of hole = 150 mm  Find maximum bending stress at X-X.

Q: Given the figure below, Solve for the following unknowns. 17 m A 12 m B 35 kN/m 245 KN Determine the…

A:

Q: Problem 2. Given the following traverse notes for a closed traverse, LINES AB BC CA AZIMUTH 225°…

A:

Q: The table below contains the information about Areas of cross-sections of road. .Calculate the…

A: Using Simpsons one third rule

Q: St. No. A B C D field book. 1) Calculate the difference in level between point A and G. 2) If it is…

A: To find difference in elevation between A and G Depth of fill at D

Q: The following 10 vehicle speeds (in mi/h) were in measured on a roadway segment: 60, 65, 64, 71, 66,…

A: Using formula

Q: In removing a weak dam over a large reservoir what strategic analysis would you adopt in order to…

A: Solution: Dam: A dam is an earthen or concrete structure that is constructed across a river stream…

Q: 8. Two vertical-sided reservoirs each have a surface area of 186 m² and are connected by a submerged…

A:

Q: For the truss shown in Fig. P-111, calculate the stresses in members CE, DE, and DF. The…

A: ###Determination of stresses in Members CE,DE,DF ###Using method of separation ###

Q: A wide, shallow sand-bed channel has a slope of 0.00105 (assume smooth channel banks). The average…

A: I am solving 5th question as per bartleby guidelines one question

Q: 1. After the Taal Volcano erupted, two personnel from the Philippine Institute of Volcanology and…

A:

Q: a. Determine the plastic section modulus. b. Determine the plastic moment capacity if Fy = 345 MPa…

A: ###Determination of Plastic  Section Modulus and Plastic  moment  capacity and UDL ###

Q: All angles are preferred to measure clockwise because of the graduations of theodolite circle…

A:

Q: The direct and indirect costs estimated by a contractor for bidding a project is Rs. 160000 and Rs.…

A:

Q: An embankment for a highway 30 m wide and 1.5 m in compacted thickness is to be constructed from…

A:

Q: Station X(m) Y (m) A 0 0 B + 170 +320 + 470 +90 + 340 - 110 <-40 - 220 703 C D E

A:

Q: and a web thickness of 10 mm. Total depth of 1 - section is 300 mm. a. Determine the plastic section…

A: Given, Fy = 248MPa I section Thickness of flange= 12 mm Width of flange = 170 mm Web thickness = 10…

Q: If d is the distance between equidistant odd ordinates, the Simpson's rule for the areas, is d/2[h1…

A: To determine the formula of Simpson's rule.

Transportation Systems and Organizations

The transportation system is the system of moving vehicles with goods and persons. It consists of three basic elements: