A router uses the following routing table: Destination Mask Interface 144.16.0.0 255.255.0.0 eth0 144.16.64.0 255.255.224.0 eth1 144.16.68.0 255.255.255.0 eth2 144.16.68.64 255.255.255.224 eth3 A packet bearing a destination addres 144.16.68.117 arrives at the router. On whic nterface will it be forwarded?

Q: A router uses the following routing table: Destination Mask Interface 144.16.0.0 255.255.0.0 eth0…

A: Introduction :Given , Routing table ,Destination address : 144.16.68.117we have asked to find on…

Q: A router uses the following routing table- Destination Mask Interface 144.16.0.0 255.255.0.0 etho…

A: The Answer is

Q: A router uses the following routing table- Destination Mask Interface 144.16.0.0 255.255.0.0 etho…

A: the interface on which the destination address with 144.16.68.117 is forwarded is detailed in step…

Q: A router uses the following routing table- A packet bearing a destination address 144.16.68.117…

A: The following Routing table is given. according to the question, A packet bearing an estimation…

Q: In IPV4, consider sending a 1,300 byte datagram (20 bytes of IP header) into a link that has an MTU…

A: The problem is based on transfer of data using ip addreses.

Q: Given a subnet mask 255.255.255.240. What will be the subnet address for a host with IP 200.10.5.68?…

A: Given a subnet mask 255.255.255.240. What will be the subnet address for a host with IP 200.10.5.68?…

Q: Given a subnet mask 255.255.255.240. What will be the subnet address for a host with IP 200.10.5.68?…

A: Given a subnet mask 255.255.255.240. What will be the subnet address for a host with IP 200.10.5.68?…

Q: to configure a two-router network. All router Use given Figure 1 configurations must be assumed and…

A: EXPLANATION Below is the program for the given question. Hope you understand it well. If you have…

Q: 1. For the given network, write the commands that are used in the host and Router for configuring…

A: Given network diagram is designed in the packet tracer and it is shown below.   Commands : Host…

Q: write an access control list which should only allow 192.168.10.0 & 192.167.10.0 & 192.166.10.0 to…

A: Given: write an access control list which should only allow 192.168.10.0 & 192.167.10.0 &…

Q: Suppose a router has built up the routing table shown below: Subnet Subnet mask Next hop number…

A: The Answer is

Q: 6. Refer to the figure below. The NAT functionality of the router is enabled to provide Internet…

A: The IP address that needs to be changed is =>Option c. 192.168.2.2 As per the given diagram , the…

Q: ICMP is used for addressing error reporting routing forwarding Which of the following is an example…

A: ICMP:- stand for internet Control Message Protocol. Private IP Addresses have the following…

Q: Match each description with an appropriate IP address. (Not all options are used.) a link-local…

A: Please find the answer below :

Q: What does a router do when it gets a packet with a destination network address that is unknown to…

A: Provided the solution for above given question as shown below.

Q: What does a router do when it gets a packet with a destination network address that is unknown to…

A: In this problem, we will discuss about the router's behaviour when the destination network address…

Q: 1.The Intra-Site Automatic Tunnel Addressing Protocol is used to transmit IPv6 packets between dual…

A: The answer of the first question is below. If you want remaining answers also, then post them…

Q: Assign IP addresses to all of the interfaces. For Subnet 1 use addresses of the form 11.192.4.xxx;…

A: Dear Student, The ip addresses needed to be filled by subnetting the given address also, to…

Q: Given a Class C subnet Mask 255.255.255.192. what will be the subnet address and host number for a…

A: Given : Given a class C subnet Mask 255.255.255.192 what will be subnet address and host number for…

Q: P2. Suppose two packets arrive to two different input ports of a router at exactly the same time.…

A: a. Explanation: “No”, it is not possible to forward the packets through the switch at the same time…

Q: A random burst error in a segment of the transport layer occurs when: a.most bits in the segment…

A: A random burst error in a segment of the transport layer occurs when most bits in the segment flip.…

Q: The correct physical address in mark 1 in the following network is A/10 To another | X/44 network…

A:

Q: CIDR router contains in its routing table the mask M 255.255.224.0 and the base address…

A: It is defined as Classless Inter-Domain Routing, which is known as IP addressing scheme that…

Q: 192.168.30.10o 192.168.70.1 192.168.2.2 192.168.0.2 Question 1: The subnet mask in the following…

A: In the given network 4 routers, 6 switches and each switch is connected to 1 or 2 hots. Based on the…

Q: From the figure below, summarize the network addresses to a single network address and write a…

A: Given:

Q: An ISP has the following block of addresses 132.204.192/20. The manager of this ISP hired you to…

A: The answer is

Q: Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as…

A: Code:

Q: Given a Class C subnet Mask 255.255.255.192. what will be the subnet address and host number for a…

A: 192 in binary =11000000 gives 4 possible subnets of (showing 2 most significant bits): 00,01,10,11…

Q: An internal router protocol and an external routeing protocol have different functions.

A: Introduction: A routing protocol describes how routers exchange information to identify routes for…

Q: In the IPV4 addressing format, the number of networks allowed under Class C addresses is 2^7 O 2^24…

A: Foe class C address  size of network field  = 24 bits but first 3 bits are fixed that is 110 Total…

Q: In packet switching: A. Dissembling and re-assembling of data is not required. B. Every chunk of…

A: In packet switching: A. Dissembling and re-assembling of data is not required. B. Every chunk of…

Q: Given the following subnet mask, what is its representation in CIDR notation? 255.255.255.248 Are…

A: Please note we are only allowed to solve one question in one post. please post the remaining…

Q: Given a subnet mask of 255.255.255.192 for a C Class network, there will be how many bits for subnet…

A: The following is the solution

Q: For example, let say that your Network 1 needs 30 hosts and you are in a class C network, you would…

A: Part(A) Class A address range is from 0-127. The value of the subnet mask for Class A 255.0.0.0.…

Q: 2. Write the necessary commands to configure Inter VLAN communication (Router on a Stick) for the…

A: Below i have given steps;

Q: Suppose two packets arrive to two different input ports of a router at exactly the same time. Also…

A: In the shared bus topology to avoid the data collision and to maintain the traffic, only one user…

Q: Suppose two packets arrive to two different input ports of a router at exactly the same time. Also…

A: a.Fabric uses a shared bus: To prevent data collisions and maintain traffic, only one user can…

Q: Suppose two packets arrive to two different input ports of a router at exactly the same time. Also…

A:

Q: Suppose two packets arrive to two different input ports of a router at exactly the same time. Also…

A: a. Fabric uses a shared bus: (No, not possible) In shared bus topology to avoid the data collision…

Q: A router receives a packet with destination address (222.186.114.16) Show how it finds the network…

A: Given, The destination address: 222.186.114.16 The range of class C network: (192-223) So, the given…

Q: A router receives a packet with destination address (222.186.114.16) Show how it finds the network…

A: IPv4 address are consist of 32 bits. A unique identifier for computers connecting to a network is an…

Q: Höst åddress in a subnet. Suppose you - subnet mask is 255.255.255.240 what would ba our dafe

A: LAN stands for Local Area Network. It can be defined as a network or collection of devices or…

Q: Find the address in all networks.   Subnets =1000. Hosts =60   Address = 165.100.0.0. class- 0…

A: EXPLANATION Below is the answer for the given question. Hope you understand it well. If you have any…

Q: The routing technique FLOODING is used in certain contexts. It means that Group of answer options…

A: Flooding means a data packet arriving through one network interface of a router is forwarded to…

Q: 39. The figure below shows the TCP Congestion Window for various transmission rounds of a…

A: The congestion window size at round 12 is 16. Now time out occurred at round 12. In case of TCP…

Q: ARP only permits address resolution to occur on a single network. Could ARP send a request to and…

A: The following is the solution

Q: What happens if a router receives a packet with a destination network address it doesn't recognize?

A: When a router receives a packet, the router checks its routing table to determine if the table lists…

Q: What happens if a router receives a packet with a destination network address it doesn't recognize?

A: The question is: if a router receives a packet with a destination network address it doesn't…

Q: What does the "slash-decimal" notation (for example, 1090:9:900:210D:100:100:227:32F / 60) that can…

A: The problem is based is on the basics of types of IP address in computer networks.

Q: Network Addresses Using the IP address and subnet mask shown write out the network address 188.…

A: Note: we are only allowed to solve three subparts in one question. to get answers to others, please…