A sample of Oz with a pressure of 1.42 atm and a volume of 280 mL is allowed to react with excess CO at 107 °C.2 CO (g) + 0, (g) 2 CO, (g)Calculate the pressure of the CO, produced in the reaction if it is transferred to a 2.00-L flask and cooled to 33 °C.atm

We have to calculate the pressure of CO2 produced.

Answered: A sample of Oz with a pressure of 1.42…

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter8: Properties Of Gases

Section: Chapter Questions

Problem 43QRT

See similar textbooks

Similar questions

93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)
A collapsed balloon is filled with He to a volume of 12.5 L at a pressure of 1.00 atm. Oxygen, O2, is then added so that the final volume of the balloon is 26 L with a total pressure of 1.00 atm. The temperature, which remains constant throughout, is 21.5 C. (a) What mass of He does the balloon contain? (b) What is the final partial pressure of He in the balloon? (c) What is the partial pressure of O2 in the balloon? (d) What is the mole fraction of each gas?
Nitrogen trifluoride is prepared by the reaction of ammonia and fluorine. 4 NH3(g) + 3 F2(g) 3 NH4F(s) + NF3(g) If you mix NH3 with F2 in the correct stoichiometric ratio, and if the total pressure of the mixture is 120 mm Hg, what are the partial pressures of NH3 and F2? When the reactants have been completely consumed, what is the total pressure in the flask? (Assume T is constant.)
A chemist weighed out 5.14 g of a mixture containing unknown amounts of BaO(s) and CaO(s) and placed the sample in a 1.50-L flask containing CO2(g) at 30.0C and 750. torr. After the reaction to form BaCO3(s) and CaCO3(s) was completed, the pressure of CO2(g) remaining was 230. torr. Calculate the mass percentages of CaO(s) and BaO(s) in the mixture.
A sample of a smoke stack emission was collected into a 1.25-L tank at 752 mm Hg and analyzed. The analysis showed 92% CO2, 3.6% NO, 1.2% SO2, and 4.1% H2O by mass. What is the partial pressure exerted by each gas?
In a typical automobile engine, a gasoline vapor-air mixture is compressed and ignited in the cylinders of the engine. This results in a combustion reaction that produces mainly carbon dioxide and water vapor. For simplicity, assume that the fuel is C8H18 and has a density of 0.760 g/mL. (a) Calculate the partial pressures of N2 and 02 in the air before it goes into the cylinder; assume the atmospheric pressure is 734 mmHg. (b) Consider the case where the air, without any fuel added, is compressed in the cylinder to seven times atmospheric pressure, the compression ratio of many modem automobile engines. Calculate the partial pressures of N2 and O2 at this pressure. (c) Now consider the case where 0.050 mL gasoline is added to the air in the cylinder just before compression and completely vaporized. Assume that the volume of the cylinder is 485 mL and the temperature is 150C. Calculate the partial pressure of the gasoline vapor. (d) Calculate the amount (mol) of oxygen required to bum the gasoline in part (c) completely to CO2 and H2O. (e) The combustion reaction in the cylinder creates temperatures in excess of 1200K. Due to the high temperature, some of the nitrogen and oxygen in the air reacts to form nitrogen monoxide. If 10% of the nitrogen is converted to NO, calculate the mass (g) of NO produced by this combustion. (f) Hot-rod cars use another oxide of nitrogen, dinitrogen monoxide, to create an extra burst in power. When such a power boost is needed, dinitrogen monoxide gas is injected into the cylinders where it reacts with oxygen to form NO. Calculate the mass of dinitrogen monoxide that would have to be injected to form the same quantity of NO as produced in part (e). Assume that sufficient oxygen is present to do so.

Recommended textbooks for you

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781133611097

Author:

Steven S. Zumdahl

Publisher:

Cengage Learning

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781337399074

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A sample of Oz with a pressure of 1.42 atm and a volume of 280 mL is allowed to react with excess CO at 107 °C. 2 CO (g) + 0, (g) 2 CO, (g) Calculate the pressure of the CO, produced in the reaction if it is transferred to a 2.00-L flask and cooled to 33 °C. atm