A sand with a minimum void ratio of 0.42 and a maximum void ratio of 0.88 has a relative density of 42.0 %. How much will a 5. 2 m of this sand layer settle if the sand is densified to a relative density of 68.0 %? Assume that the sand layer is compressed in the vertical direction only.

A sand with a minimum void ratio of 0.42 and a maximum void ratio of 0.88 has a relative density of 42.0 %. How much will a 5. 2 m of this sand layer settle if the sand is densified to a relative density of 68.0 %? Assume that the sand layer is compressed in the vertical direction only.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter9: Consolidation

Section: Chapter Questions

Problem 9.17P

See similar textbooks

Related questions

Q: An undisturbed sample of clay loam has a saturated mass of 15 kg, a total volume of 0.008 m3. What…

A: given data saturated mass=15kg total volume=0.008m3 particle desity=2.65g/cm3

Q: A horizontal stratified soil deposit consists of three layers each uniform in itself. The…

Q: The void ratios at the densest, loosest and natural states of a sand deposit are 0.2, 0.6 0.4,…

Q: A clay layer consolidates after 6 years when its thickness is 5.70 m and the void ratio is 1.08.…

Q: A soil has a discharge velocity of 6 x 10 m/s and a void ratio of 0.5. What is its seepage velocity?

A: Given data : Void ratio (e)=0.5Velocity (V)=6×10-7 m/s

Q: an undisturbed 1200 cm^3 sample of sand weighs 19.5 N when dry. The void ratios at the maximum and…

Q: If a saturated layer has a unit weight of 125 pcf, what is the submerged unit weight?What is the…

A: Saturated unit weight = 125 pcf Water unit weight = 62.40 pcf Submerged unit weight = 125 - 62.5…

Q: SITUATION 1: A sample of silty clay has a volume of 14.88 cm3, a total weight of 28.81 g, a dry…

Q: A soil has a discharge velocity of 6 x 107 m/s and a void ratio of 0.5. What is its seepage…

A: Given- discharge velocity V=6×10-7 m/svoid ratio e=0.5It is needed to find the seepage velocity Vs

Q: A Cylindrical soil sample of 7.5 cm height and 3.75 cm diameter has been prepared at the shrinkage…

Q: A recently filled up fill was 10.54 m thick and its average void ration was 1.0. The fill was loaded…

A: depth of recently fill d1=10.54 m; void ratio e1=1.0 after compression void ratio e2=0.8 and…

Q: Water flows through a sand filter as shown on the figure. The soil has a cross sectional area of…

Q: An undisturbed sample of clay has a wet mass of 30 kg, a dry mas of 25 kg, and a total volume of…

A: Given: Wet mass of clay = 30 kg Dry mass of clay = 25 kg Total volume = 0.014 m3 Specific gravity =…

Q: A soil sample has a void ratio of 0.72, moisture content of 12% and Gs = 2.72 Determine the…

Q: A layer of saturated clay with 4 m thick is overlain by sand with thickness of 5 m deep, the water…

A: Fluid mechanics alludes to an expansive designing field that concentrates on the major conduct of…

Q: Water depth in a lake is 3 m. A soil sample was collected from the sediment in the lake and the…

A: Draw the cross-section from the data provided in the table. Assume the entire top clay layer is…

Q: Question attached

A: Solution; (A) Settlement at point A Equation: Sc=mv*σ'z*H

Q: What is the value of the natural water content in percentage? B) What is the value of the in-situ…

A: SOIL MECHANICS:

Q: Estimate the void ratio if the effort s increases to 360 kN / m2.

A: Draw the compression diagram :

Q: The coefficient of permeability of fine sand is 0.012 cm/sec at a voids ratio o0.57. Estimate the…

A: Please refer the attached image for complete solution.

Q: A soil deposit has three layers having same thickness each but the permeability's of the layers are…

A: given permeability ratios=1:2:4=k:2k:4kIt is required to find the ratio of average permeability in…

Q: During a consolidation test, a sample of fully saturated clay 3 cm thick (= ho) is consolidated…

Q: What is the soil property that directly correlates to the degree of saturation at a suction value of…

A: Answer : A soil-water characteristic curve (SWCC)

Q: Calculate the saturated density from void ratio 0.8.

A: The saturated density of soil is defined as the bulk density of soil when the soil is below water…

Q: an initial void ratio of 1.11. It is compressed and the void ratio changed to 0.82. Determine

Q: Problem 3.5 A layer of sand extends from ground level to a depth of 9 m and overlies a layer of…

Q: The dry density of a sand with a porosity of 0.387 is 1600 kg/ m3, determine the void ratio,…

Q: For a normally consolidated clay layer in the field, the following values are given: Thickness of…

A: Given: The thickness of clay layer is 8.5 ft. The void ratio is 0.8. The compression index is 0.28.…

Q: clay layer having a thickness of 10.83 m. has an initial void ratio of 1.14. It is compressed and…

Q: an undisturbed 1200 cm^3 sample of sand weighs 19.5 N when dry. The void ratios at the maximum and…

Q: A soil has a discharge velocity of 6 x 10 m/s and a void ratio of 0.5. What is its seepage velocity?…

Q: A uniform collapsible sand stratum, 2.5 m thick, has specific gravity of its sand as 2.65, with a…

A: given- H=2.5 mG=2.65e=0.65

Q: A soil with a volume of 0.0283 m3 has a specific gravity of 2.7, a dry weight of 0.376 kN, and a wet…

A: Total volume of soil = 0.0283m³ Specific gravity = 2.7 Weight of solid = 0.376KN Weight of water =…

Q: Problem 3.5 • A layer of sand extends from ground level to a depth of 9 m and overlies a layer of…

Q: For the condition where the soil is 100 percent saturated and the wet unit weight is known, what is…

Q: A uniform sand stratum 2.5 m thick has a specific gravity of 2.62 and a natural void ratio of 0.62.…

Q: During a consolidation test, a sample of fully saturated clay 3 cm thick (= ho) is consolidated…

Q: A soil deposit has three layers having same thickness each but the permeability's of the layers are…

A: Given data in question Same thickness of layers Ratio of permeabilities To find out Ratio of…

Q: A soil has a bulk density of 1.91 Mg/m3 and water content of 9.5%. the value of Gs is 2.7, calculate…

Q: A dry sand sample of (1350 gm) was subjected to compression stress (198.6 kPa) of (0.9 kN) force. If…

Q: The soil profile shown below is typical of Miami-Dade County. Estimate the equivalent permeabilities…

A: Data given: Asked: Estimate the equivalent improbabilities kv(eq) and kh(eq) in cm/sec, and the…

Q: A soil layer of 5 m thickness considered to be ultimately settled, when it's thickness became 4.3 m…

A: Given data, e0= 0.75, e100= 0.25, et= 0.6, ∆H = 5 – 4.3 = 0.7 m, ∆h = ?

Q: During a consolidation test, a sample of fully saturated clay 3 cm thick (= ho) is consolidated…

Q: Total predicted settlement due to consolidation of a low clay layer a certain pressure is 150mm. If…

Q: A horizontal stratified soil deposit consists of three layers each uniform in itself. The…

A: To find the effective average permeability

Q: A normally consolidated clay in the field has the following properties: Compression index = 0.26…

A: All the relevant data is given in the question and with the help of data we will calculate the…

Q: For a clay layer in the field, the following values are given: • Thickness of clay layer = 3 m •…

A: cσi=130kPaσf=130+65=195kPaσP=1.5σi=195kPa

Q: For an aquifer of sand having porosity of 35% and specific yield of 25%, what volume of water would…

Q: During a consolidation test, a sample of fully saturated clay 3 cm thick (= h) is consolidated under…

Q: The figure shows a soil profile with a silty sand (y= 17 kN/m²; Ysat = 19.2 kN/m3) underlain by high…

Question

A sand with a minimum void ratio of 0.42 and a maximum void ratio of 0.88 has a relative
density of 42.0 %. How much will a 5. 2 m of this sand layer settle if the sand is densified to a
relative density of 68.0 %? Assume that the sand layer is compressed in the vertical direction
only.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A clay layer consolidates after 6 years when its thickness is 5.70 m and the void ratio is 1.08. Assuming the secondary compression index in 0.04, estimate the secondary compression settlement in the next 15 years. Express your answer in mm rounded to the nearest whole number.
an undisturbed 1200 cm^3 sample of sand weighs 19.5 N when dry. The void ratios at the maximum and minimum unit weight were determined to be 0.43 and 0.92. The specific gravity of solids is known to be 2.73. Calculate the dry unit weight of sand in kN/m^3
The in-situ void ratio of a bed of sand is 0.6. If the unit weight of sand particles is 165.4 pcf, calculate γd and γsat of sand. If sand gets completely submerged, what would be its submerged unit weight?
For the condition where the soil is 100 percent saturated and the wet unit weight is known, what is the equations for submerged soil?
The bulk unit weight of the soil is 16.680 kN/m3 at a saturation of 36.870 % and the effective unit weight is 9.580 kN/m3. If the maximum and minimum void ratio of the soil is 0.880 and 0.390, respectively, determine the following: max dry unit weight , relative density , saturated unit weight
A horizontal stratified soil deposit consists of three layers each uniform in itself. The permeabilities of these layers are 8 × 10–4 cm/s, 52 × 10–4 cm/s, and 6 × 10–4 cm/s, and their thickness are 7, 3 and 10 m respectively. Find the effective average permeability of the deposit in the horizontal and vertical direction (mm/s).
4. A silty sand has a void ratio of in the loosest condition equal to 0.86 and a void ratio of 0.30 in the densest condition. If the relative density of the sand is 54%, calculate the porosity and the specific gravity if the sand has a dry unit weight of 16.85 kN/m³.
A normally consolidated clay layer, 3 m thick, has the following properties : Initial void ratio, e0= 0.8 Compression index, Cc = 0.25 Average effective pressure, σ’0 = 125 Kpa Expected pressure increase, Δσ’ = 45 Kpa Secondary compression index, Ca = 0.02 Time of completion of primary settlement = 1.5 years What is the total settlement of the clay layer five years after the completion of the primary settlement?
A soil sample obtained at the Earth Dam site in Hydroelectric Power Scheme has a bulk unit weight of 18.5 kN/m3 at water content of 13.5%. spesific gravity 2.65 Determine the soil void ratio, degree of saturation and volume of air voids
A bed of sand consists of three horizontal layers of equal thickness. The value of k for the upper and lower layers is 1x10-4 m/s. What is the ratio of the average permeability of the bed in the horizontal direction to that in the vertical direction?
A soil with a volume of 0.0283 m3 has a specific gravity of 2.7, a dry weight of 0.376 kN, and a wet weight of 0.459 kN. 1) Determine the volume of voids (Ans. 0.0149 m3) 2) Determine the void ratio (Ans. 1) 3) If the soil was submerged, determine the effective unit weight (Ans. 8.34 kN/m3)
A clay layer having a thickness of 14.23m has an initial void ratio of 1.11. It is compressed and the void ratio changed to 0.82. Determine the reduction in thickness, in mm, of the clay layer. Round off to three decimal places.