A set of conductors is used to supply residential unit with a total load current of 60 A at a single-phase supply voltage of 230 V. What would be the minimum size of the conductor to be used to achieve at least 5% voltage drop? The total conductor length is 300 ft.

Q: 3. What is the gain factor (Inverting and Non-inverting) when RR = 100 kQ and Rin 10 k2?

A: 3) To find the gain factor in case of inverting and non-inverting amplifier when  Input resistance =...

Q: dipole antenna

A: Small dipole antenna- Dipole antenna is said to be small dipole antenna when- Small dipole antenna l...

Q: Estimate the optical loss due to Fresnel reflection at a fiber core from GaAs each of refractive ind...

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: Determine the time required for 4 x 1016 electrons to pass through the imaginary surface of the figu...

A:

Q: Find the total current in polar form

A: In this question,  We need to find the total current in polar form .  We are solving this problem us...

Q: In the following circuit : Vout=2.8 V R +1 VoW 22 kM 22 kN R2 +1.8 V oW 22 kN o VOUT Select one: O T...

A: Given circuit,

Q: e and f is 5

A:

Q: Are the state space equations for the r = Ar + Bu correct? 1 -k k +. 文。 M M M, 13 -b, * 0. 文。 -k M M...

A: We need to tell about whether the given statement is true or false.  

Q: copper wire 5m long, 1mm in diameter carries a current of 12A. Find: (a) the wire’s resistance (b...

A:

Q: 3. Simplify the following expression in sum-of-products form using a 4-variable Karnaugh map. f (w, ...

A: Given boolean expression, fw,x,y,z=w.x.y.z+w.x.y+x.y.z+w.y.z

Q: 1. 220V ( 2.5k ohms

A: To find  1. Instantaneous current(I) 2. Maximum current(Imax) 3. Phasor diagram      

Q: Voltage is the energy required to move a unit charge through an element, measured in volts (V). * Ye...

A: Given, Voltage is the energy required to move a unit charge through an element, measured in volts? ...

Q: Figure Q1(b) shows a negative feedback system. The amplifiers' open loop gains are given as follow: ...

A: It is given that: A1f=251+jf5000A2f=181+jf5000A3f=201+jf5000

Q: 1. (a) Calculate Ro in the following circuit if the ratio Iş/Io=0.4. (b ) Calculate the power suppli...

A: Using current division rule find io in terms of is then using given relation find the resistance Ro....

Q: Consider a silicon pn junction at T= 300 Kwith an acceptor doping concentration (1 x 10cm-3) and a d...

A:

Q: Operational amplifier has infinite bandwidth. Select one: O True False

A: Operational Amplifier is an electronic device which can be used to amplify the input signal. Resisto...

Q: Can you write the operations with explanations? The signal shown in Figure 3(b) is the input voltag...

A:

Q: Find the current through the bottom resistor. Do this in three ways: (a) Use series and parallel rul...

A:

Q: Consider a silicon pn junction at T= 300 K with acceptor doping concentrations of 101 cm and donor d...

A:

Q: Determine the current I3 in the circuit below in polar form. Write the magnitude only in four decima...

A: The solution is given below 

Q: Q3. Apply the Mason's gain formula to the signal- flow graphs shown in figure C(s) C(s) and below to...

A: With the help of Mason's gain transfer function formula singnal flow graph can be obtained. To deter...

Q: 1 4 mA 102 2iz

A:

Q: Q10/ At room temperature (300 K) with the Fermi level located exactly in the middle of the bandgap, ...

A: We need to find out the probability of a state being empty

Q: Determine the equivalent impedance across a and b in polar form. Write the angle only in four decima...

A: In this question We need to determine the equivalent impedance across terminal a and b.  We are solv...

Q: A short-shunt compound generator delivers a load current of 30 A at 220 V and has armature, series-f...

A: Given  Armature resistance = 0.04Ω series-field resistance = 0.2Ω Shunt field resistance = 100Ω Per ...

Q: The lowest value of the transmitted power of a pulsed radar signal in order to detect a target area ...

A: It is given that: Cross-sectional area=σ=10 m2Distance=D=120 kmFrequency=ν=35 GHzGain=G(dB)=34 dBSo,...

Q: 4. Calculate the working values of the following circuits from the parameters in the given table. pa...

A:

Q: AL= JOL X, = Inductive Reactance w = Angular Frequency f = Frequency L = Inductance i = Imaginary un...

A: Problem 1 : An inductor of inductance 6 mH is connected with a supply voltage of 220 V 50 Hz supply ...

Q: 12–94. A golf ball is struck with a velocity of 80 ft/s as shown. Determine the speed at which it st...

A: Please refer the attached images for the complete answer..

Q: 2. Calculate the working values of the following circuits from the parameters in the given table. pa...

A:

Q: 52 E, 48V R1 R2 20 2 10 2

A: In the given circuit 10Ω and 20Ω are in parallel and their equivalent is given as: R12=10×2010+20=6....

Q: Calculate the working values of the following circuits from the parameters in the given table. param...

A: We need to find out gain and output voltage for given opamp circuit

Q: s3(t), and s4(1), respectively, where s1 (1) = 20/2 sin 2t s2(t) = 0 1 TM = Тм 20 s3 (1) = 10/2 cos ...

A: Solution- Given,  A equiprobable messages m1, m2, m3, m4  m1 → S1(t)= 202sin2πTmt m2 →S2(t) =0      ...

Q: 3. Adding Extra DC Voltage Source (+5V) R1 Vo 1K Vi D 5V 4. Adding Extra DC Voltage Source (-5V) R1 ...

A:

Q: Consider a silicon pn junction at T= 300 K with acceptor doping concentrations of 10to cm"3 and dono...

A:

Q: R1 750 R2 1250 R3 200 0 ww 10 O v1 = 2.8 V2 = 4V V3 = 3.2V O v1 = 1.11 V2 = 2.22 V3 = 1.66 O v1 = 1....

A:

Q: A power conversion system having an impulse response h[n]={1,-1} accepts the input x[n]={1,-2,2, 1,3...

A: Overlap save method:

Q: Derive a Boolean expression for the following circuit. A X C

A: Given boolean circuit,

Q: 3.1 Apply nodal analysis to find the node voltage V in the circuit of Fig. P3.1. Use the information...

A: Given circuit,

Q: 1. Given the operational amplifier below. a. Solve for the input voltage, if the feedback resistors ...

A:

Q: S+4

A:

Q: Q7/ The Fermi level is only defined at absolute zero *

A:

Q: DFT

A:

Q: What is the nominal value of a resistor with the first three colour bands ORANGE, VIOLET, RED?

A:

Q: An R-L load drawing I1 current from to 250V, 50H z supply is consuming 1.5kW. When a capacitor is co...

A:

Q: Given the sequential circuit below, derive the excitation table. RQ FF1 Y X- Emphasis RQ %24 FF2 Wha...

A: For FF1 the output be 'A'  For FF2 the output be 'B' In the given problem, C is given there is no In...

Q: Problem No. 7 *13. Determine V, and In for the network of Fig. 163. 2 ΚΩ Si +10 Vo- oV, GaAs 2 kΩ 2 ...

A:

Q: Q4/ The average time between the two scattering events is denoted by:

A: Given: Average time between two scattering events

Q: Determine Vhf in the circuit in polar form. Write the angle only in four dec 80260°V 3+j60 2-j50 j3n...

A:

Q: (V1. V2. V3): *

A:

Photoelectric

The photoelectric effect occurs when light (or similar incident radiation, including X-rays) falls on material together with a metal plate and causes it to emit electrons. The discovery of the photoelectric effect led to important new theories (and to a Nobel Prize for Albert Einstein). Photoelectric cells, or photocells, are utilized in burglar-alarm light detectors and garage-door openers (each employs a through-beam of light this is broken when something movements throughout it), and also to play soundtracks on film movies (in which a light beam shines through the soundtrack encoded at the film and is "read" with the aid of the photocells).