A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic impedance of 50 ohms. Calculate the phase velocity for signal propagation along the line, and hence L and C.

A shielded, twin-wire line has a dielectric of relative permittivity 2 and a characteristic impedance of 50 ohms. Calculate the phase velocity for signal propagation along the line, and hence L and C.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.47P

See similar textbooks

Related questions

Q: 1. Verify by means of the truth tables the laws of D'Morgan a) AB = A + B b) a) b) A + B = A.B A 0 0…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Use Nodal Analysis to determine each of the parameters for the provided cicat. VeM A R,(100) R;(200)…

A: Given: Circuit diagram

Q: A ring of radius R has a charge distribution on it is given by = ncose + 8 where n and & are…

A: The given figure is shown below: It is given that: λθ=ηcosθ+δwhere,η and δ are constants.

Q: Den Ston FIGURE 2 X C. For the logic network shown in FIGURE Q2(c): BIED B CD BIOZ NVD i. POZNAT NV…

Q: SS 2-45 Find to in the circuit of Figure P2-45- Μ 33 ΚΩ FIGURE P2-45 10 V Μ 100 ΚΩ 33%

A: Given circuit,

Q: 1) A coil composed of 100 turns has an inductance of 5 mH. If the number of turns is doubled without…

Q: What is the frequency for a wavelength of 2 meters? Show detailed calculation.

A: In this case, the frequency corresponding to a wavelength of 2 meters needs to be determined.

Q: 6. For the follow logic circuit system, the output f is: [ (A) ab. (B) a + b. (C) a'+b'. (D) a'b' a…

A: Given, The logic circuit is,

Q: Determine the voltages 1 and 2 of the network in Fig. by nodal analysis. ΤΩ 3, ΤΑ 1 των 2Ω O Μ ΖΩ 2…

Q: Find the damping ratio and natural frequency for each second-order system shown below and show that…

Q: 2. A generalized circuit constants of a transmission line are A=D=0.895/1.4°, and B- 182.5/78.6° (a)…

Q: The block diagram shown in Figure I represents an unmanned car's speed function. Speed Dynamics…

Q: Design a microstrip line on a 0.5 mm alumina substrate (er = 9.9, tan o = 0.001) for a 50…

Q: A capacitor connected to a 230 V, 50 Hz supply draws 10 amp. What current it will draw for a…

A: We have a capacitor connected with, Supply Voltage (V) = 230 V Frequency (f) = 50 Hz Current through…

Q: What logic function is being performed? Logic function:

A: The given circuit is as shown below,

Q: 1. Provide a block diagram and a function table for the NOR-Gate Latch. 2. Describe, with the aid of…

A: Since you have asked multiple questions, we will solve the first question for you If you want any…

Q: Please solve this one-step equations using the appropriate operation to balance it. Thank You !…

A: Given: One step equation, X-12=3

Q: Problem 9: Find the Thevenin equivalent circuit for the following circuit with respect to the…

A: We need to find out thevenin equivalent resistance and voltage for given circuit

Q: 1) Provide the Boolean expression that matches the following combinational circuit. 2) Create a…

A: It is given that:

Q: State and explain Carson's Bandwidth Frmula. Need urgently help.

A: In the following section, Carson's bandwidth formula has been explained.

Q: learn-us-east-1-prod-fleet01-xythos.s3.amazonaws.com http…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first three. Please resubmit the…

Q: Determine the magnetic field at (0, 0, 5m) due to 15 A current flowing in a circular loop of radius…

A: Given a circular loop in the magnetic field, Current, I=15 A Circular loop radius, a=3 m Magnetic…

Q: 2. The power of a circuit is giving as follow: p(t) = 150e(-10t) Calculate the total energy of the…

A: Given data, Signal is given as, pt=15e-10t

Q: 2. Relation between currents according to KCL is

A: In this case, the relation between the currents in the given circuits needs to be determined:

Q: cedb-e70a-017569bcae60/ecam kderi - Go OI Wallpaper Abyss-- Istanbul Online Ye. 8 am 1A MASTERCHEF…

A: Given- ε= 20 V L= 0.05 H R0 = 3 ohm R1 = 1 ohm R2 = 4 ohm R3 = 4 ohm R4 = 4 ohm R5 = 5 ohm R6 = 3…

Q: Calculate the average power supplied by the source as shown below. * find the averaged power…

A: Given parameters: The series-parallel circuit consisting of R, L, and C components s shown below,…

Q: Q8) If the initial conditions on y(t) and u(t) their derivatives are zero, find the transfer…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: Which of the following statements best describes electric polarization forces on neutral objects? O…

A: a). The expression occurs when an electric field distorts the negative cloud of electrons around…

Q: In the circuit shown below, the maximum power transferred to the resistor R is 30 502 :5V 20 6 V 50…

A: Given circuit,

Q: the attached

A: Given: a) Write down the equation of 1st order Transfer Function in standerd form and the unit step…

Q: or not. Given y(n) = x(n) + x(n-1)+x(n-2). Find whether the system is stable

A: We have an system as, y(n) = x(n) + 18x(n - 1) + 13 x(n - 2) And we have been asked to check whether…

Q: There is no figure with this question. The net charge passing through a circuit element is given by…

A: Given the net charge passing through a circuit element, qt=4t3+3t With the time t in second.

Q: V; -02 V 20 ΚΩ Μ • 10 ΚΩ 200 ΚΩ ΖΙΩ

A: Given: Circuit diagram

Q: A series R-C circuit consists of a resistor of 700 2, time constant of 28 msec. The value of…

A: The time constant is the time taken by the RC network to reach 63.2% of its final value.

Q: Modify Control Circuit such that when an overload condition occurs a red pilot light turns on,…

A: To modify circuit with overload relay and pilot light of

Q: Solve the linear ODE below using the Laplace transform technique: d²y dt² assume zero initial…

Q: 1- Design this circute and found R₁, R₂ 23 Drow A.c circute and found Ri, Ro 3) Write the De and As…

A: According to guidelines, only the first 3 subparts will be solved. For any other part please post a…

Q: Explain Hall effect transducer also state Different values of hall coefficient with different…

A: The Hall effect transducers are based on Hall effect which was discovered in 1879. The Hall effect…

Q: Example 20. Calculate the power drawn in a circuit given the following voltage and current…

Q: A 6-bit R-2R ladder D/A converter has a reference voltage of 6.5V. It meets standard linearity. Find…

Q: Use any technique you prefer to prove the logic rule: A.(A + B) = A

A: Given, The logic expression is AA+B≡A

Q: An alternator is connected in star. Its phase voltage is 250 V. This alternator supplies the load…

Q: RMS value of an alternating current is 30 A and its frequency is 25 Hz. Write its equation to find…

A: We have an RMS value of an alternating current and we have been asked to find its instantaneous…

Q: In the cross-section shown in the figure, two long straight wires held against a plastic cylinder of…

A: Given: Radius 20 cm current carried by wire 1 is 60 mA Magnitude of wire2 is 80 nT Find Angle θ2

Q: If the peak voltage of a 60-Hz AC generator is 250 V, what is the instantaneous voltage after the…

A: According to the question, it is given that Peak Voltage Vpeak = 250 V Frequency of AC generator =…

Q: In the figure shown below, determine the power of the voltage source. 352 6A (↑) 252 ww wit 201

A: Given circuit,

Q: For Z₁ = 1 KQ, Z₂ = 0.1 µF, Z3 = 500 №2, Z4 = 1 ko, derive an expression for the transfer function…

Q: 7.27. A linear time-invariant discrete-time system has transfer function 3z H(z) = (z+0.5)(z- 0.5)…

A: Given:- transfer function Hz=3zz+0.5z-0.5 Output response, yn=0.5n-3-0.5n+4un We have to find…

Q: Using Parseval's theorem,

Q: A dc motor with its rotor and field coils connected in series has an internalresistance of 2.00 Ω.…

A: Given data: The internal resistance r=2.00 Ω The voltage V=120 V The current I=4.00 A

Question

A shielded, twin-wire line has a dielectric of relative permittivity 2 and a
characteristic impedance of 50 ohms. Calculate the phase velocity for
signal propagation along the line, and hence L and C.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single-phase overhead transmission line consists of two solid aluminum conductors having a radius of 3 cm with a spacing 3.5 m between centers. (a) Determine the total line inductance in mH/m. (b) Given the operating frequency to be 60 Hz, find the total inductive reactance of the line in /km and in/mi. (c) If the spacing is doubled to 7 m, how does the reactance change?
3-phase line has conductors 4 cm in diameter spaced equilaterally 2 m apart. If the dielectric strength of air is 29 kV (max) per cm, find the disruptive critical voltage for the line. Take air density factor =0.952 and irregularity factor mo = 0.9.
the air-filled two-wire line has a characteristic impedance of 50 Ω and is operated at f = 3GHz .the load is ZL= 100 +j40Ω . for the line above, calculation ZL on the chart the line impedance 2.5 cm from the load , the admittance, the VSWR on the line, and distance from the load to the first voltage minimum and maximum.
A 3-phase line has conductors 6 cm in diameter spaced equilaterally 3 m apart. If the dielectric strength of air is 30 kV (max) per cm, find the disruptive critical voltage for the line. Take air density factor δ = 0.952 and irregularity factor m = 0.8.
A very low-loss microstrip transmission line has the following per unit length parameters: R = 2 Ω/m, L = 80 nH/m, C = 200 pF/m, and G = 1 µS/m. (a) What is the characteristic impedance of the line if loss is ignored? (b) What is the attenuation constant due to conductor loss? (c) What is the attenuation constant due to dielectric loss?
A parallel-wire transmission line has separation between conductors equal to four times the conductor diameter. If the dielectric material separating the two conductors is Foam Polystyrene with a velocity factor equal to 0.91, what is the characteristic impedance of the transmission line?
A lossless transmission line has an inductance of 125 nH/m. Find the velocity factor for this line if the shunt capacitance is 200 nF/m.
A short-circuited transmission line section is exactly one-quarter wavelengthat a frequency of 1250 MHz. Calculate the inductave reactance , and (b) the eq uiva le nt inductance, at a frequency of 500 MHz. The character st ~ impedance of the line is 50ohm
A 3 –phase 50 HZ transmission line have conductors of sections 90 mm2 and effective diameter of 1cm and are placed at the vertices of an equilateral triangle of side 1metre. The line is 20 km long and delivers a load of 10MW at 33kV and p.f 0.8. Neglect capacitance and assume temperature of 20 oC. Determine the efficiency and the regulation of the line
A 15-km, 60Hz, single phase transmission line consists of two solid conductors, eachhaving a diameter of 0.8cm. If the distance between conductors is 1.25m, determine theinductance and reactance of the line
A transmission line has two aluminum conductors in bundle. The self GMD of each conductor is 8.90 mm and the distance between the conductors and phase is 40 cm and 9 m, respectively. What is the inductance of the line per phase? A. 2 μH/m B. 4 μH/m c. 1 μH/m D 3 μH/m
A lossless transmission line has a Zo of 50 ohms and a line velocity of 2.4 x 10^8 m/s. If the operating frequency is 1 MHz. Determine the capacitance in pf.