A ship loads in fresh water to her salt water marks and proceeds along a river to a second port consuming 20 tonnes of bunkers. At the second port, where the density is 1016 kg per cu. m, after 120 tonnes of cargo have been loaded, the ship is again at the load salt water marks. Find the ship’s load displacement in salt water. Kindly show the step by step solution and be careful with the units

A ship loads in fresh water to her salt water marks and proceeds along a river to a second port consuming 20 tonnes of bunkers. At the second port, where the density is 1016 kg per cu. m, after 120 tonnes of cargo have been loaded, the ship is again at the load salt water marks. Find the ship’s load displacement in salt water. Kindly show the step by step solution and be careful with the units

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.5P: Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen,...

See similar textbooks

Similar questions

A ship arrives at the mouth of a river in water of density 1016 kg per cu. m with a freeboard of ‘S’ m. She then discharges 150 tonnes of cargo, and proceeds up river to a second port, consuming 14 tonnes of bunkers. When she arrives at the second port the freeboard is again ‘S’ m, the density of the water being 1004 kg per cu. m. Find the ship’s displacement on arrival at the second port. Kindly ahow the step by step solution and careful with the units. Thank you!!!
When disturbed, a floating buoy will bob up and down atfrequency f . Assume that this frequency varies with buoymass m , waterline diameter d , and the specific weight γ ofthe liquid. ( a ) Express this as a dimensionless function. ( b )If d and γ are constant and the buoy mass is halved, howwill the frequency change?
Solve this please. In FPS system, showing detailed units. Assume density of water 62.4lbm/ft3
3. Supposed that air (std.) has a uniform density of 1.2kg/m^3, estimate how high (meters) above the sea level where there exists a zero pressure. Assume that in the given condition, barometric pressure at sea level is 101.325 kPa. Include also the free body diagram or figure of the problem, and your findings after solving it.
What is the standard sea level density (p) in slugs/ft^3?
A tank contains oil (s = 0.80), gasoline (s = 0.90) and sea water (s = 1.03). If the depth of the liquids are 0.5 m, 0.8 m and 1 m for oil, gasoline and sea water respectively. Find the pressure at the interface of oil and gasoline and bottom of the tank.
A ship of 7500 tonnes displacement has KM 8.6 m, KG 7.8 m and 20 m beam. A quantity of deck cargo is lost from the starboard side (KG 12 m, and centre of gravity 6 m in from the rail). If the resulting list is 3 degrees 20 minutes to port, find how much deck cargo was lost.
If a scuba diver descends too quickly into the sea, the internal pressure on each eardrum remains at atmospheric pressure, while the external pressure increases due to the increased water depth. At sufficient depths, the difference between the external and internal pressures can rupture an eardrum. Eardrums can rupture when the pressure difference is as little as 35 kPa. What is the depth at which this pressure difference could occur? The density of seawater is 1025 kg/m3. 1)sketch (include everything in the system) 2)solution(step by step)
A 118-mm-diameter pipe enlarges to a 149-mm-diameter pipe. At section 1 of the smaller pipe, the density of gas in steady flow is 264.656 kg/m3, and the velocity is 23 m/s; at section 2 of the larger pipe, the velocity is 15 m/s. Find the unit weight (in kN/m3) of the gas at section 2. Round off to three decimal places.
A milkshake has fairly similar density to that of water (m s = 1200 kg/m3) but is far more viscous ( = 1kg/ms) (a) Say you try to drink a milkshake through a straw that is 30 cm long and 5 mm in diameter. Your lungs are capable of creating a vacuum pressure of 3000 Pa. (Vacuum pressure just means a pressure below that of the atmosphere, so plung = patm 3000 Pa.) You Önd that if you place the straw just at the surface of the liquid, you are unable to suck the milkshake through the straw, but if you push the straw deeper into the shake, you can. To what depth, d, would you need to push the straw in order to just start to sip the milkshake?(b) Suppose you push the straw to a depth of 10 cm and suck with a suction pressure of 3000 N/m2. What volume áow rate of milkshake can you produce through the straw
As shown in the figure, there are two different fluids and pressurized air in a tank. A hydrostatic force of 8000 N acts on the 40x50 cm panel on the front surface of the tank. In this case A) Calculate the air pressure. B) Find the height (h) of mercury on the manometer. (For air, neglect the variation of pressure with height.) pwater=1000 kg/m3, poil=890 kg/m3, pmercury=13600 kg/m3, g=9.81 m/s2
The sketch shows an oil manometer that is connected between two pipes which transport water. The density of water can be taken as 998kg/m3, the specific gravity of glycerol is 0.76 and atmospheric pressure is 100 kPa. The respective dimensions (as shown on the sketch) are given below: h1 = 0.17 m h2 = 350 mm h3 =15cm. From the given data, calculate the pressure difference between the two pipes.