A shunt generator supplies a 29kW load at 230V through cables of resistance, R = 108m2. If the field winding resistance, Rf =502 and the armature resistance, Ra =59m2. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,

A shunt generator supplies a 29kW load at 230V through cables of resistance, R = 108m2. If the field winding resistance, Rf =502 and the armature resistance, Ra =59m2. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Related questions

Q: Two similar 6,600-V, three phase generators are running in parallel on constant-voltage and…

Q: A 10 kW, 250 V self-excited generator, when delivering rated load, has an armature circuit voltage…

A: The emf induced in a set of conductors due to relative space variation w.r.t steady magnetic field…

Q: (a) A short shunt cumulative compound dc generator supplies 4kW at 220V. The Shunt field resistance,…

A: Find the induced emf of the DC short shunt commulative type generator.

Q: Draw voltage phasor diagrams for different load cases of salient pole synchronous generators and…

A: Here it is asking to draw the voltage phasor diagrams for different load cases of salient pole…

Q: A shunt generator supplies a 37kW load at 230V through cables of resistance, R = 112mQ. If the field…

A: Dc shunt generator arrangement is shown in figure.

Q: How many poles should a 60-Hz generator have, if it is connected to a turbine operating under a…

Q: Damping factor and the undamped natural frequency for the position control system is given by....?

A: The characteristics equation of the position control system is expressed as:

Q: Consider the two-bus power system shown in Figure P6.2. The marginal cost of production of the…

A: Since you have asked more than one question, I will answer the first question and all its subparts.…

Q: With increasing load current, the output voltage of a separately-excited DC generator falls, which…

A: The separately-excited DC generator the field winding can be excited by an external source. This…

Q: What are the various losses in an induction motor? On what actors do they depend?

A: Following are the various losses in an induction motor a) Core loss b) Stator conductor loss c)…

Q: A shunt generator supplies a 28kW load at 220V through cables of resistance, R = 114mQ. If the field…

A: Solve as below

Q: Between a separately-excited and a self-excited DC generator, which is simpler to construct and why?

Q: 1- Prove from the first principles an expression for the generated EMF at the armature of DC…

Q: Q2: A: A 10-kW 250-V self-excited generator, when delivering rated load, has an armature-circuit…

A: Power delivered Vt×IL. Armature current =load current +shunt field current. We will find armature…

Q: A 4-quadrant DC chopper with bipolar switching operating at a switching frequency of 2kHz, is…

A: Given R=2 ohm Edc =120 V Eb=50 V

Q: Describe constant and variable frequency operation of chopper control. Describe how duty cycle…

Q: A shunt generator supplies a 24kW load at 230V through cables of resistance, R = 106mo. If the field…

Q: Find the maximum efficiency of shunt generator has the armature resistance and shunt resistance 0.08…

A: Given Ra=0.08 Ω Rsh=120 Ω Wr=800 W VT=250 V

Q: A shunt generator supplies a 33kW load at 210V through cables of resistance, R = %3D 122m2. If the…

Q: Damping factor and undamped natural frequency for the position control system is given by what?

A: For the position control system, the characteristics equation is expressed as:

Q: The armature reaction of the DC generator reduces the generated EMF. Select one: O True False

A: Choose the correct option The given statement The armature reaction of the DC Generator reduce the…

Q: Find the number of commutator segments required in a 6-pole dc machine having s simple wave-wound…

Q: A shunt generator supplies a 23kW load at 220V through cables of resistance, R = 114mQ. If the field…

A: The solution can be achieved as follows.

Q: shunt generator supplies a 24kW load at 200V through cables of resistance, R = 110mΩ. If the field…

Q: The breadth factor for 3rd harmonic emf of a 3 phase, 4 pole, synchronous machine having 36 stator…

A: Given a 3-phase synchronous machine having, 3rd harmonic, r =3 Number of pole, P = 4 Number of slots…

Q: What is meant by a self-excited induction generator and what is the critical value of the excitation…

A: Self excited induction generator: For obtaining its magnetizing reactive power, an induction…

Q: When a self-excited compound DC generator supplies load, the terminal voltage is not the same as the…

A: The explanation is as follows.

Q: (a) A short shunt cumulative compound dc generator supplies 8kW at 235V. The Shunt field resistance,…

A: In this question we need to find a Induced EMF and load resistance of a short shunt compund genrator

Q: A shunt generator supplies a 33kW load at 200V through cables of resistance, R = 106m2. If the field…

Q: 11 What is the dq component - Park transform The effective stator field current is I, = and the…

A: The direction of the direct-axis current is along the direction of the rotor magnetic field and the…

Q: (a) Draw the combined space and time phasor diagram for a cylindrical rotor alternator with armature…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: A DC shunt generator supplies a load of 27 kW at 210 V through the cables of resistance, R = 126 mΩ.…

Q: What is the current

Q: A shunt generator supplies a 31kW load at 200V through cables of resistance, R = 108mN. If the field…

Q: A shunt generator supplies a 20kW load at 200V through cables of resistance, R= 100mΩ. If the field…

A: Dc shunt Generator

Q: 2.Mention four Application of DC –DC chopper.

A: Application of dc chopper: 1.They are used for DC motor control (battery-supplied vehicles), solar…

Q: An engineer is designing 4-pole DC generator with 30 conductors by using simplex two-layer wave-…

Q: A 10 pole wave wound shunt generator delivers 178 A at a terminal voltage of 236 V. Ra and Rsh are…

A: For generator Armature current = Load current +shunt field current. Generated voltage =Terminal…

Q: A shunt generator supplies a 33kW load at 225V through cables of resistance, R = 100mΩ. If the…

Q: A shunt generator supplies a 30kW load at 215V through cables of resistance, R = 110mn. If the field…

Q: A shunt generator supplies a 31kW load at 230V through cables of resistance, R = 122mΩ. If the…

A: In this question we need to find a terminal Voltage and internal emf genrated by Shunt Genrator.

Q: A shunt generator supplies a 32kW load at 220V through cables of resistance, R = 128mΩ. If the…

A: A shunt generator supplies 32kW load at 220V through cables of resistance, Cable resistance R =…

Q: Explain the construction working principle and derivation for the emf induced in a DC generator.…

A: According to question: Construction of DC generator: The DC generator consists of two parts: One…

Q: Plot the external and internal characteristics of DC shunt generator.

Q: analyze 3 commonly used ac motor starting methods using suitable diagrams and torque-speed curves

A: Starting of a 3-phase induction (AC) motor: A 3-phase induction motor is widely used in industries.…

Q: Describe briefly the basic constructional parts of a DC machine and explains the basic working…

A: Since you have asked multiple questions, we will solve the first one for you. In case you need…

Question

A shunt generator supplies a 29kW load at
230V through cables of resistance, R =
108m2. If the field winding resistance, Rf
=502 and the armature resistance, Ra
=59m2.
Determine the following below:
The terminal voltage is,
The e.m.f. generated in the armature is,

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A shunt generator supplies a 30kW load at 215V through cables of resistance, R = 110mn. If the field winding resistance, Rf =680 and the armature resistance, Ra =45mn. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,
A shunt generator supplies a 20kW load at 200V through cables of resistance, R= 100mΩ. If the field winding resistance, Rf =50Ω and the armature resistance, Ra =40mΩ, determine (a) the terminal voltage, and (b) the e.m.f. generated in the armature
A DC shunt generator supplies a load of 27 kW at 210 V through the cables of resistance, R = 126 mΩ. If the field winding resistance, Rf = 62 Ω and the armature resistance, Ra = 35 mΩ, Determine (a) the terminal voltage, and (b) the E.m.f. generated in the armature. The terminal voltage is = The E.m.f generated in armature is =
Consider the AC circuit shown in the image, that is driven by a voltage V=V0cos(ωt). a) What is the current through the capacitor, C? Give its amplitude and phase relative to the drive voltage. b) What is the total current through the voltage source? Again require amplitude and phase relative to the drive voltage.
Describe constant and variable frequency operation of chopper control. Describe how duty cycle generated by saw-tooth and sinusoidal modulating signal and compare their performance .
111/ The armature reaction of the DC generator reduces the generated EMF. Select one: True False
A shunt generator supplies a 31kW load at 230V through cables of resistance, R = 122mΩ. If the field winding resistance, Rf =50Ω and the armature resistance, Ra =51mΩ. Determine the following below: The terminal voltage is, Answer and unit for part 1 The e.m.f. generated in the armature is,
Q23) A shunt generator supplies a 20KW load at 200V through cables of resistance, R = 100mΩ. If the field winding resistance ,Rf=50Ω and the armature resistance, Ra=40mΩ, i) Estimate terminal voltage across the load. ii) Calculate the emf generated in the armature.
Discuss about Generator modeling in transient stability and derive the formula for the real and reactive power supplied by it.
Illustrate open circuit internal circuit and external characteristic for dc shunt generator
Discuss motherboard power delivery systems, including voltage regulators and phases. How do they impact system stability and overclocking capabilities?
A 4-quadrant DC chopper with bipolar switching operating at a switching frequency of 2kHz, is connected to a 120VDC source (Vs) and a DC motor which has a counter EMF (CEMF) of 50VDC at rated speed. The armature resistance is 2Ω and the armature inductance is 20mH. Calculate: a) Output voltage with an 80% duty cycle b) Magnitude and direction of the DC armature current with an 80% duty cycle. c) Duty cycle for a forward braking current of 10ADC. (Assume the speed has not changed due to the large inertia of the load.)