A shunt generator supplies a 33kW load at 225V through cables of resistance, R = 100mΩ.  If the field winding resistance, Rf =56Ω and the armature resistance, Ra =40mΩ. Determine the following below: The terminal voltage is, The e.m.f. generated in the armature is,

Q: From the figure shown below, find the duty cycle, trigger voltage level, threshold voltage level,…

A:

Q: 5 A coil is in series with a 20uF capacitor across a 230V 50HZ supply. The current taken by the…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power. The…

Q: Question 4 a. Two impedances are connected in parallel to an ac supply of frequency 50 Hz. The first…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 4. An induction motor draws 4.5 A at a 0.75 lagging power factor from a 208V, 60 Hz source. a) What…

A: Only one question is to be answered according to bartleby policy.

Q: The Upward wind and down wind velocity of a wind turbine are 12m/s and 5m/s respectively. What is…

A: Given: Downward wind velocity, Sd=5 m/s Upward wind velocity, Su=12 m/s

Q: rder to change the behavior of a 2nd order underdamped system, we need to move its closed-loop poles…

A:

Q: source frequency and the impedance Z ? a) f = 150.66 Hz & Z 28.78/80° b) f = 152.66 Hz & Z =…

A:

Q: b. Determine what is the necessary length and characteristic impedance of a cable to be used as a…

A:

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The…

A: In this question, An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac…

Q: Evaluate (5430° ) × ( 2472° ). Convert the result to rectangular form. What is the value of the real…

A: Given data, Function is given, 5∠300×2∠720

Q: Vcc 3k2 100k2 Frequency Response B www 20 k2 2k2 100k2 1 kas 2 UF Consider the following circuit…

A: Given the following circuit: Given the value of parameters: Cπ=2 nF ,  Cμ=0.5 nF , rπ=10 KΩ , β=100…

Q: .38: For the admittance locus diagram shown beside: Draw the equivalent electric circuit…

A: We have given for the admittance locus diagram:  So, we will first draw the equivalent electric…

Q: A 40kW induction motor with a lagging power factor of 0.76 is supplied by a 120Vrms 60Hz sinusoidal…

A: Given, Power, P= 40 kW Supplied voltage, Vph=120 V (rms) Frequency, f= 60 Hz Power factor,…

Q: Rc 180 Ω Rc 390 N RB RB Vcc 15 V 3.9 kN Boc = 50 27 kN BDc = 125 VBB 3 V

A: Solution:- (a) Given fig (a) From the given circuit,  VBE = 0.7V IB=VBB-VBERB=5-0.73.9K=4.33.9KIB =…

Q: University of Moul College of Electronic Engineering Feineering Department afoint chanay of 30n cis…

A: We need to find out D at given point dur point charge and surface charge density .

Q: Which of the following information cannot be obtained from the wind rose? a. Wind speed b. Wind…

A: Given:  Which of the following information cannot be obtained from the wind rose?

Q: Re For the electrode model given in the figure, assume that R= 3000 Ohm, R, 8 Ohm and C 0.1 micro…

A: Given circuit shown Rd=3000 ΩRs=8 ΩCd=0.1 μFEhc=0.223 v

Q: Problem 2-A building uses 120 solar modules of Panasonic 300 Black Series in rows of 8. While the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac…

A: MPT theorem: This is used to find the maximum power in the load.

Q: tyroscope. Draw the phase portrait of the system, and determine the system's stability? p+a 句

A:

Q: Given the circuit shown below, if Zx = 100/0º determine the current in each branch a) Nodal Method…

A: Since you are asking a question witth 2 methods Here  we apply maxwell's method for determine the…

Q: A factory draws a lagging load of 2000 kW

A: Active Power- It is power utilized by the load. It is the power factor times the apparent power of…

Q: A superheterodyne receiver is to tune the range 88.IMHZ to 107.1MH2. The RF circuit inductance is…

A:

Q: small induction motor with power factor of 0.8. The effective currents flowing through the bank of…

A:

Q: In a 110 Vrms, 50 Hz. Source, determine the following values: Trigonometric equation V peak, and…

A:

Q: 1 Xc = waC V = IX XR = R X = waL First consider an AC voltage source with a driving frequency wa and…

A: The voltage drop across resistor is the product of current flowing through it and the resistor…

Q: In the AC circuit shown in the figure below, R = 70.0 2 and the output voltage of the AC source is…

A:

Q: If emf in a circuit is given by e = 100 sin 628t, the maximum value of voltage and frequency is…

A:

Q: 1. Explain the difference between the AC and DC? Give examples 2. Explain how RC and RL works in a…

A: As per policy i can answer only 1st question.  Difference between AC and DC with 2 examples

Q: b. Determine what is the necessary length and characteristic impedance of a cable to be used as a…

A:

Q: examplein quaterial hight having auavelength of 500 A falls on having aphoto electric work function…

A: The solution is given below

Q: HW # 7.1 Vp = 50 sin(@t), R1 = 1kN , If the firing angle is 30°, draw %3D Vp=Vm sinot R Vo the…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Obtain the phase and gain margins of the system shown in the following figure for the two cases…

A: Gain and phase margin for k=10From th block diagramG(s) = 10s(s+1)(s+5)   put s= jω in oprn loop…

Q: In layman's terms, Give a summary of the concepts of phase modulation.

A:

Q: Find the ff. on the AC circuit below having a 120Vrms as a signal source V1. a.) Total Impedance ZT…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: series RLC combination is connected to an ac source operating at a maximum of 120.0 V and at a…

A:

Q: 23:\The table below showvs the data obtained from sinusoidal test for LTI system, where the irst…

A:

Q: 5 A coil is in series with a 20uF capacitor across a 230V 50Hz supply. The current taken by the…

A: Given:C=20μFV=230Vf=50HzI=8AP=200W Circuit diagram will be like:

Q: A 11 kV, 50 Hz alternator is connected to system which has inductance and capacitance per phase of…

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you…

Q: solve completely The internal resistance of the generator connected to the input of a transmission…

A:

Q: B)The signal Vin(t)-2Cos(2nfit)+2Ces(2mfat), passes through a square-law device where the output…

A:

Q: Shape: sinusoidal, square, or triangular. Amplitude: peak value of the time-varying component of the…

A:

Q: A 110V(rms), 60HZ AC source is connected to a motor, which can be represented by a resistor and an…

A:

Q: Q6: An AM signal of 50 watt power is transmitted in a frequency range 200 – 210 kHz in a…

A: Given data                  Fig: Power spectral density  Transmitted signal power (Pt )=50 W

Q: EIRP Calculations 8) Consider a wireless transmitter that has an antenna gain of 5 dBi. Calculate…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.