A signalized intersection has four approaches. If the north, south, east, and west approaches have average control delays of 21, 25, 34, and 32 seconds, respectively, and their respective volumes are 198, 176, 265, and 303 pc/h, what is the intersection LOS? Group of answer choices LOS C LOS B LOS A LOS D

A signalized intersection has four approaches. If the north, south, east, and west approaches have average control delays of 21, 25, 34, and 32 seconds, respectively, and their respective volumes are 198, 176, 265, and 303 pc/h, what is the intersection LOS? Group of answer choices LOS C LOS B LOS A LOS D

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter8: Intersection Control

Section: Chapter Questions

Problem 24P

See similar textbooks

Similar questions

A signalized intersection has two lane groups. The two WBT lanes (lane group #1) have a total volume of 863 pc/h and an average control delay of 24.5 seconds. The one WBL lane (lane group #2) has a volume of 203 pc/h and an average control delay of 36.5 seconds. What is the approach's LOS? Group of answer choices LOS A LOS D LOS C LOS B
An intersection has a three-phase signal with the movement allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired Phase 1 2 3 Allowed Movement NB L, SB L NB T/R, SB T/R EB L, WB L EB /T/R, WB T/R Analysis Flow Rate 330, 365 veh/h 1125, 1075 veh/h 110, 80 veh/h 250, 285 veh/h Saturation Flow Rate 1700, 1750 veh/h 3400, 300 veh/h 650, 600 veh/h 1750, 1800 veh/h Calculate the Following: 1.)Sum of flow ratios for critical lane groups 2.)minimum cycle length 3.)using v/c equation ratio, calculate the effective green time for phase 1 4.)using v/c equation ratio, calculate the effective green time for phase 2 5.)using v/c equation ratio, calculate the effective green time for phase 3
Q4b. What are the relevance of the following considerations in traffic signal timing design? i. Incorporating all-red interval in the inter-green period ii. Conversion of all vehicle categories to passenger car units (PCU)
Subject: transportation engineering Read the question carefully and give me right solution according to the question. A signal has four phases, where the critical lane group flow ratios are 0.115, 0.204, 0.099, and 0.248. If the lost time per phase is 6 seconds and the critical intersection v/c ratio is 0.88, calculate the minimum cycle length and the phase effective green times such that the lane group v/c ratios are equal.
An approach to a pretimed signal has 32 seconds of effective green, a saturation flow rate of 1800 veh/h, and a volume-to-capacity ratio less than 1. If the cycle length is 115 seconds and the overall delay formula (Eq. 7.27) estimates an average delay that is 38 seconds greater than that estimated by using just the uniform delay formula, determine the vehicle arrival rate in veh/h. (Assume the signal is isolated and d_3 = 0.
A) Calculated (not rounded) clearance interval for an intersection approach of 50 mph that needs to cross 45 ft of intersection width. B) If a roadway has an AADT of 25000 vehicles, of which 2000 occur during the peak hour, what is the k factor? C) The stopped time delay for an intersection approach is 34.5 seconds. The control delay is most likely D)An intersection approach has a capacity of 1600 vph. What is the likely queue at the end of an hour if the 15 minute vehicle arrivals are 350, 500, 300, and 500? E)A roadway has a measured flow of 2400 vphpl and SMS of 60 mph, what is the density and LOS?
TRANSPORTATION ENGINNERING-TRAFFIC SIGNALS An approach to a predetermined signal has 25 seconds of effective green for a 60 second cycle. The approach volume is 500 vehicles/hour and the saturation flow rate is 1400 vehicles/hour. Calculate the average vehicle delay using D/D/1 queing.
Two adjacent signalized intersections along a major arterial are 650 ft apart (stop line to stop line distance). If the space mean speed between these two intersections is 22 mph, what should be the signal offset of the downstream intersection relative to the upstream intersection? Group of answer choices 20.0 sec 13.5 sec 40.0 sec 29.5 sec
Supposed vehicles arve at a signalized road intersection at an average rate of 360 vehhr and the cycle of the trac light is set at 40 seconds. In what percentage of cycles wil the number of venices be amring: 2.1. Exacty 5 2.2. Less than 5 If, after the lights change to green, there is time to clear only 5 venices before the signal changes to red again, what is the probabilty that waiting vehicles are not cleared in one cycle?
A signalized intersection has four phases. The yci are 0.15, 0.19, 0.21, and 0.17 for the four phases, respectively. If the cycle length is 108 seconds and the total lost time is 16 seconds, what is the effective green time for phase 2? Group of answer choices 23 sec 25 sec 21 sec 19 sec
In order to determine the DHV from a traffic count worksheet, the first step is to: Group of answer choices Calculate the PHF of each approach Determine which hour has the highest total intersection volume in veh/hr Convert all of the turning counts from veh/15-min to veh/hr Calculate the PHF of the intersection
plz, solve this problem, it is not graded question. Transportation Engineering-1 During a 70 sec period, a detector is occupied by vehicles for the following times: 0.31, 0.39, 0.41, 0.35, and 0.53 sec. Estimate the values of flow (q), density (k) and speed (v). Assume that the loop detector is 10 ft and that that the average length of the vehicle is 20 ft.