A single hoop of metal wire is placed near a localized region of uniform magnetic field that is directed into the page. Which of the following processes will lead to an induced emf and induced current on the hoop? I. II. X ххх K XXX* ххх x X Hoop rotating clockwise (Axis is perpendicular to the page) xxx XXX X X X Decreasing magnetic field magnitude III. C X X X X хх X X X X X Hoop moving downward X ххх K **** A- A-- x x x K X X Hoop rotating about the horizontal axis X X X IV.

A single hoop of metal wire is placed near a localized region of uniform magnetic field that is directed into the page. Which of the following processes will lead to an induced emf and induced current on the hoop? I. II. X ххх K XXX* ххх x X Hoop rotating clockwise (Axis is perpendicular to the page) xxx XXX X X X Decreasing magnetic field magnitude III. C X X X X хх X X X X X Hoop moving downward X ххх K **** A- A-- x x x K X X Hoop rotating about the horizontal axis X X X IV.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Faraday’s Law

Section: Chapter Questions

Problem 31.6OQ: The bar in Figure OQ31.6 moves on rails to the right with a velocity v,. and a uniform, constant...

See similar textbooks

Similar questions

Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
Singly charged uranium-238 ions are accelerated through a potential difference of 2.00 kV and enter a uniform magnetic field of magnitude 1.20 T directed perpendicular to their velocities. (a) Determine the radius of their circular path. (b) Repeat this calculation for uranium-235 ions. (c) What If? How does the ratio of these path radii depend on the accelerating voltage? (d) On the magnitude of the magnetic field?
A square, flat loop of wire is pulled at constant velocity through a region of uniform magnetic field directed perpendicular to the plane of the loop as shown in Figure OQ31.5. Which of the following statements are correct? More than one statement may be correct. (a) Current is induced in the loop in the clockwise direction. (b) Current is induced in the loop in the counterclockwise direction. (c) No current is induced in the loop. (d) Charge separation occurs in the loop, with the top edge positive. (e) Charge separation occurs in the loop, with the top edge negative. Figure OQ31.5
The bar in Figure OQ31.6 moves on rails to the right with a velocity v,. and a uniform, constant magnetic field is directed out of the page. Which of the following statements are correct? More than one statement may be correct. (a) The induced current in the loop is zero. (b) The induced current in the loop is clockwise. (c) The induced current in the loop is counterclockwise. (d) An external force is required to keep the bar moving at constant speed. (e) No force is required to keep the bar moving at constant speed.
A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
The picture tube in an old black-and-white television uses magnetic deflection coils rather than electric deflection plates. Suppose an electron beam is accelerated through a 50.0-kV potential difference and then through a region of uniform magnetic field 1.00 cm wide. The screen is located 10.0 cm from the center of the coils and is 50.0 cm wide. When the field is turned off, the electron beam hits the center of the screen. Ignoring relativistic corrections, what field magnitude is necessary to deflect the beam to the side of the screen?
An astronaut is connected to her spacecraft by a 25-m-long tether cord as she and the spacecraft orbit Earth in a circular path at a speed of 3.0 105 m/s. At one instant, the voltage measured between the ends of a wire embedded in the cord is measured to be 0.45 V. Assume the long dimension of the cord is perpendicular to the vertical component of Earths magnetic field at that instant. (a) What is the magnitude of the vertical component of Earths field at this location? (b) Does the measured voltage change as the system moves from one location to another? Explain.
Review. In studies of the possibility of migrating birds using the Earths magnetic field for navigation, birds have been fitted with coils as caps and collars as shown in Figure P30.1. (a) If the identical coils have radii of 1.20 cm and are 2.20 cm apart, with 50 turns of wire apiece, what current should they both carry to produce a magnetic field of 4.50 10-5 T halfway between them? (b) If the resistance of each coil is 210 . what voltage should the battery supplying each coil have? (c) What power is delivered to each coil?
A heart surgeon monitors the flow rate of blood through an artery using an electromagnetic flowmeter (Fig. P28.47). Electrodes A and B make contact with the outer surface of the blood vessel, which has a diameter of 3.00 mm. (a) For a magnetic field magnitude of 0.040 0 T, an emf of 160 V appears between the electrodes. Calculate the speed of the blood. (b) Explain why electrode A has to be positive as shown. (c) Does the sign of the emf depend on whether the mobile ions in the blood are predominantly positively or negatively charged? Explain.
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?