A single row of sheet piles is driven into a permeable layer as shown in the figure. Given: • H = 5.5 m . На — 4.4 m Calculate the seepage loss per meter length of the sheet pile (at right angles to the cross section shown). Bear in mind that in the flow net of the system the number of flow channels is Nf = 4 and the number of potential drops is Na = 8, + Sheet pile H H2 D k = 4 × 10-4 cm/sec Impermeable layer Round your final answer to three significant figures. ® m³ / day /m 1.

A single row of sheet piles is driven into a permeable layer as shown in the figure. Given: • H = 5.5 m . На — 4.4 m Calculate the seepage loss per meter length of the sheet pile (at right angles to the cross section shown). Bear in mind that in the flow net of the system the number of flow channels is Nf = 4 and the number of potential drops is Na = 8, + Sheet pile H H2 D k = 4 × 10-4 cm/sec Impermeable layer Round your final answer to three significant figures. ® m³ / day /m 1.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter7: Seepage

Section: Chapter Questions

Problem 7.7CTP

See similar textbooks

Similar questions

Draw a flow net for a single row of sheet piles driven into a permeable layer as showin Figure Q3 (b) below. Thus, determine the seepage loss per meter length of thesheet pile.H1 = 9.6 m D = 5 mH2 = 3.7 m D1 = 13 m
Determine the factor of safety against heave on the downstream side of the single-row sheet pile structure shown in Figure 9.30. Use the following soil and design parameters: H1 = 7 m, H2 = 3 m, thickness of permeable layer (T) = 12 m, design depth of penetration of sheet pile (D) = 4.5 m, and γsat = 17 kN/m3
The value of k of soil around a sheet pile is 10-6 m/s. The flow net of this sheet pile consists of 5 flow lines and 11 equipotential lines. Determine the rate of seepage (in cm3/s per m) if the difference in the water level is of 4m.
For the flow net shown in the figure below, if the datum is selected at the downstream water surface, determine: (a) the total head at point b; (b) the pressure head at point b if point b is 11 m below the downstream ground surface (or 13 m below the downstream water surface); (c) uplift pressure at point b; (d) the factor of safety against heave on the downstream side of the single-row sheet pile structure shown below. The depth of penetration of sheet pile (D) is 4.5 m. (Note: the blue dashed area is the heave zone)
The sheet pile is driven in the Cebu South reclamation area and the area to one side is pumped down as shown in the flow net. The permeability of the sand is 0.001 m/s. below the elevation of 20 m us an impermeable rock layer. Determine the flow per unit length.How high (above the ground surface) the water will rise if a piezometer will be placed at A?
(c) A dam shown in Figure Q1 (c) retains 6m of water. A sheet pile wall on the upstreamside (which is to reduce seepage under the dam) penetrates 4m into a 10m thick of siltysand stratum. Below the silty sand is a thick deposit of clay. Assume that the silty sandis homogeneous and isotropic. (i) Calculate q in cm/s.(ii) Analyze the pore water pressure distribution on the front of the sheet pile (atevery 2m @ at points A, F and G). Given the Nd of points A, F and G are 0.5,1.5 and 3.0 respectively.(iii) Analyze the pore water pressure distribution at the base of the dam. (at every5m @ at points A, B, C, D and E). Given the Nd of points A, B, C, D and E are5.6, 6.7, 8.0, 10.0, 13.0 respectively.(iv) Determine the uplift force under the dam.(v) Calculate the factor of safety against piping. Given Lmin = 0.85m.
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in Figure below with a scale as shown. Given that kx = kz=k = 4 x 10-3 cm/sec, determine How high (above the ground surface) the water will rise if piezometers are placed at points a and b The total rate of seepage through the permeable layer per unit length The approximate average hydraulic gradient at c factor of safety against piping x=1.6 y=2.8
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in the Figure below. Given that kx= kz = k= 5.5 x 10-3 cm/sec, H1 = 6.5 m and H2 = 2.3 m determine: i. How high (above the ground surface) the water will rise if piezometers are placed at points a and b ii. The total rate of seepage through the permeable layer per unit length iii. The approximate average hydraulic gradient at c
A flownet for flow around a single row of sheet piles in a permeable soil layer is shown in Figure 1 below. Given the hydraulic conductivity is 5 x 10-3 cm/sec. Determine:
The Figure below shows a long pile wall driven in sand with Coefficient of permeability K= 0.05cm/sec.it is required to: 1.Estimate the max. possible value of dimension h, where Ah=1.2. 2.Calculate the seepage loss (m /day) per meter of wall
A 600 mm diameter and 25 m long driven concrete pile carries a column load of 1200 kN. It is estimated that the shaft carries 900 kN and the point carries 300 kN. Determine the settlement of the pile head using the Poulos and Davis method with the following data: Es = 25 MN/m2, Ep = 30,000 MN/m2, and s = 0.2
Refer to Figure 18.13. Given L1 = 1.5 m, L2 = 3 m; for the sand, =33, =16.5kN/m3, sat=19.0kN/m3; and, for the clay, c=50kN/m2, =0, sat=20kN/m3. Determine the depth of sheet pile required, allowing for a 50% increase from the theoretical estimate.