Answered: A soil specimen has a volume of 0.05 m³…

Engineering

Civil Engineering

A soil specimen has a volume of 0.05 m³ and a mass of 87.5 kg. Given: w=15%, G,= 2.68. Determine a. Void ratio

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.18P

See similar textbooks

Related questions

Q: A layer of soft clay having an initial void ratio of 2.00 is 10 m thick. Under a compressive load…

Q: Find the value of void ratio if porosity of soil is 0.0012

A: Given data in question Porosity To find out Void ratio

Q: The following data are given for a specimen of soil: M= 221 g, Ms = 128 g, Gs = 2.7, Sp = 75%.…

Q: 6. The dry unit weight of a soil sample is 14.8 kN/m. Given that G, = 2.72 and w = 17%, determine:…

Q: The results of a constant head permeability test for a fine sand sample having a diameter of 150 mm…

Q: A natural deposit of soil was found to have a water content of 27% and to be 88% saturated. Gs=2.7.…

A: Given :- water content = 27% Degree of saturation= 88% Gs= 2.7

Q: Estimate the vertical coefficient of permeability for a uniform clay deposit where representative…

A: Given data: Liquid Limit = 92 Plastic Limit =34 Void ratio = 1.75 clay fraction = 0.4

Q: A soil sample has a porosity of 40% then what will be the value of void ratio? (A) 0.667 (C) 0.6 (B)…

A: Given data : Porosity (n)=40%

Q: The void ratio of a 10 mm thick soil sample is 1.8. What would its new thickness be if its void…

Q: 8. For a normally consolidated clay specimen, the results of a drained triaxial test are as follows:…

A: Given data: The total axial stress at failure will be major principal stress at failure and is…

Q: For a soil sample in a natural condition, void ratio (e) is 0.67, degree of saturation (S) is 75%,…

A: e=0.67 S=75% Gs=2.7

Q: A sample of saturated sand has a dry unit weight of 18 kN/m3 and a specific gravity of 2.7. If…

Q: (c) In laboratory, there is a 0.23 m3 of moist clay soil with a mass of 300 kg. The soil was oven…

Q: A saturated soil specimen has w = 36% and ᵞd = 85.43 lb/ft3. Determine: Saturated unit weight (in…

A: Given: Water content, w = 36% Dry unit weight, γd = 85.43 lb/ft3

Q: Find the void ratio if the value of porosity of soil is 32%

A: Given data :- Porosity = 32 % Then Porosity = 0.32 Now We have to find the value of the void…

Q: If a soil sample of volume =1 cm3 and actual density =2000 kg/m3, and bulk density = 1700 kg/m3, the…

Q: SIT S. The results of two-drained tri-axial tests on a saturated clay are recorded as follows:…

Q: An undisturbed sample of clay has a wet mass of 30 kg, a dry mas of 25 kg, and a total volume of…

A: Given: Wet mass of clay = 30 kg Dry mass of clay = 25 kg Total volume = 0.014 m3 Specific gravity =…

Q: A soil sample has a void ratio of 0.72, moisture content of 12% and Gs = 2.72 Determine the…

Q: Water depth in a lake is 3 m. A soil sample was collected from the sediment in the lake and the…

A: Draw the cross-section from the data provided in the table. Assume the entire top clay layer is…

Q: %. Determine the followine" The void ratio in a moist soil is 0.73, moisture content = 11% and the…

A: Void ratio = 0.73 moisture content=11% Degree of saturation = 40%

Q: Calculate the void ratio for each value of effective pressure and plot a void ratio versus log s…

A: Given: Dry mass, MS = 128 g Specific gravity, GS = 2.75 Area of specimen, A = 30.68 cm2

Q: The void ratio of a clay sample is 0,5 and the degree of saturation is 70%. What is the bulk unit…

Q: A soil specimen has a volume of 0.05 m3 and a mass of 87.5 kg. Given: w = 15%, Gs = 2.68. Determine…

A: Solution: Given Data: Mass=87.5 Kgw=15 %Gs=2.68Volume=0.05 m3 Consider the unit weight of water (γw)…

Q: The void ratio of a soil sample decreases from 1.50 to 1.25 when the pressure is increased from 25…

A: Given data : Initial pressure σ1=25 tonnes/m2Final pressure σ2=50 tonnes/m2Initial void ratio…

Q: A saturated soil specimen has w=36% and Yd=85.43 lb/ft*3 determine; a.)void ratio b.)porosity…

A: s=1 G=2.608

Q: solve with complete solutions and explain. A soil sample of diameter 37.5 mm and length 75 mm has a…

Q: Question 8 (1) - Oedometer test What are the boundary conditions applied to a soil sample tested in…

A: Concept- Oedometer test- This test is used to measure the consolidation in the soil sample. The…

Q: Question attached

A: As math type not available, providing hand written solution

Q: an initial void ratio of 1.11. It is compressed and the void ratio changed to 0.82. Determine

Q: Determine the porosity

A: SOIL MECHANICS:

Q: 10) For a given soil, ya = 2180 kg/m and n = 0.3. Determine: a. Void ratio

Q: The following data are given for a specimen of soil: MT = 221 g, Ms = 128 g, Gs = 2.7, S= 75%.…

A: Given data: Total weight of the soil (MT) = 221 g Total weight of solids (MS) = 128 g Specific…

Q: 3. A natural soil deposit has a bulk unit weight of 18.44 kN/m³ and water content 5%. Calculated the…

A: Given data: Bulk unite weight of the soil = 18.44 kN/m3 water content (w1) `= 5% raised water…

Q: A specimen of clay has been obtained from below the groundwater table and the total unit weight γt…

Q: A soil sample has a bulk unit weight of 17.5 kN/m^3 at a water content of 10.1%. Use Gs=2.58…

A: Given Bulk unit weight = 17.5kN/m3 Water content = 10.1%=0.101 G = 2.58

Q: 2. The following results were obtained from an oedometer test on a specimen of saturated clay:…

A: From the given question it is required to determine the final settlement due to consolidation of the…

Q: The void ratio of a soil sample decreases from 1,50 to 1.25 when the pressure is increased from 25…

A: Given data : Initial void ratio (e1)=1.50 Final void ratio (e2)=1.25 Initial pressure (p1)=25…

Q: A consolidated-drained triaxial test was conducted on a normally consolidated clay. The results are…

Q: * in the Standard Proctor Test, the number of soil layers equals to 3 O 5 O 6 O 2 O 8 O

Q: For a normally consolidated clay specimen, the results of a drained triaxial test are as follows: •…

A: Given ,Chamber confining pressure = 125kN/m2Deviatpr stress at failure = 175 kN/m2σ'3 = 125…

Q: A sample of soil compacted according to a standard Proctor test has a unit weight of 130.9 lb/ft^3…

A: Compaction- It is the process of increasing the unit weight of soil by reducing air voids.

Q: The following data apply to a soil sample (say 1 m3) taken from a construction site: a. Specific…

A: Given, V = 1 m3G = 2.7e = 0.8

Q: Compute the void ratio of a saturated soil sample. Given: Mass (saturated) = 178g Mass (after drying…

A: Given data, Mass of saturated soil = 178 gm Mass of dry soil = 139 gm Gs = 2.7 To find out the void…

Q: 2. A soil sample has a unit weight of 16 kN/m^3 and a saturation of 40%. When the saturation is…

A: Given data in question Unit weight is 16 kN/m3 when S = 40% Unit weight is 120 kN/m3 when S = 90%…

Q: The soil sample in a tri axial test have the following stresses Cell pressure 25 Кра 34 Кра Pore…

A: For drained condition .Case 1 : σ1=σ3+σ∝=25+20=45 kpaSo ,σ1-u=σ3-utan2θ+2 C…

Q: A soil sample has a bulk unit weight of 18.8 kN/m^3 at a water content of 16.9%. Use Gs=2.69…

Q: Q2: A soil specimen has a volume of 0.1 m³ and a mass of 100 kg. If the water content is 20% and…

Q: A cylindrical specimen of dry sand with a minimum and maximum void ratio (emin and emax) of 0.5 and…

A: We have relationRelative density isRd=emax-eemax-emin

Q: 1) The moist unit weight of a soil is 19.2 kN/m3 . Given that Gs = 2.69 and w = 9.8%, determine: a.…

Concept explainers

Weight-Volume relationships

Weight is defined as the quantity of matter contained in a body. Weight can also be defined as the force acting on a body due to gravity. Mathematically, weight can be defined as-

Question

A soil specimen has a volume of 0.05 m³ and a mass of 87.5 kg.
Given: w= 15%, G,= 2.68. Determine
a. Void ratio

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a normally consolidated soil, the following is given: Determine the following: a. The compression index, Cc. b. The void ratio corresponding to pressure of 200 kN/m2
1. A soil sample has a volume of 5400 cm^3 and mass of 10.45 kg, and the water content of the soil is w = 11%. Determine (a) unit weight , dry unit weight , saturated unit weight, (b) void ratio and porosity, (c) degree of saturation (assume Gs=2.7).
5. A clay layer having a thickness of 10.83 m. has an initial void ratio of 1.14. It is compressed and the void ratio changed to 0.81. Determine the reduction in thickness, in mm., of the clay layer. Round off to three decimal places. Input the numerical value only.
Question-2: A soil profile is shown in Figure 2.1. Calculate and plot the variation of total vertical stress, pore pressure and effective vertical stress with depth.
Estimate the vertical coefficient of permeability for a uniform clay deposit where representative test results are as shown: LL = 92, PL = 34 percent of clay size particles in the soil =40 void ratio ( approximate ) = 1.75
SUBJECT SOIL MECHANICS: a soil sample has a porosity of 39.8% and a specific gravity of 2.75. a) calculate the void ratio. b) calculate the saturated unit weight in kn/m^3. c) calculate the effective unit weight in kn/m^3
solve with complete solutions and explain. A soil sample of diameter 37.5 mm and length 75 mm has a wet weight of 1.32 and dry weight of 1.1 N. Determine the degree of saturation, porosity, bulk unit weight and dry unit weight.
A soil specimen has a volume of 0.06 m3 and a mass of 89.5 kg. Given: w=16%, Gs = 2.64. Determinea. Void ratio b. Porosity c. Dry unit weight d. Moist unit weight e. Degree of saturation
A saturated soil specimen has w = 36% and ᵞd = 85.43 lb/ft3. Determine: Saturated unit weight (in lb/ft3)
A layered soil is shown in Figure 7.33. Given: • H1 = 1.5 m k1 = 9 × 104 cm/sec• H2 = 2.5 m k2 = 7.8 × 10−3 cm/sec
A soil profile is shown bellow. Given: H1 =1.83 m, H2= 0.91 m, H3=1.83 m. Determination of Unit Weight of each layers. Calculate σ, u, and σ’. Plot the variation of σ, u, and σ’ with depth.
A clay layer having a thickness of 14.23m has an initial void ratio of 1.11. It is compressed and the void ratio changed to 0.82. Determine the reduction in thickness, in mm, of the clay layer. Round off to three decimal places.