A solution contains 1.47x10-2 M magnesium acetate and 1.07x10-2 M manganese(II) nitrate. Solid sodium hydroxide is added slowly to this mixture. What is the concentration of manganese(II) ion when magnesium ion begins to precipitate? [Mn²+] = Submit Answer M Retry Entire Group 2 more group attempts remaining

A solution contains 1.47x10-2 M magnesium acetate and 1.07x10-2 M manganese(II) nitrate. Solid sodium hydroxide is added slowly to this mixture. What is the concentration of manganese(II) ion when magnesium ion begins to precipitate? [Mn²+] = Submit Answer M Retry Entire Group 2 more group attempts remaining

Introductory Chemistry: A Foundation

9th Edition

ISBN:9781337399425

Author:Steven S. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 116AP

See similar textbooks

Similar questions

68. Aluminum ion may be precipitated from aqueous solution by addition of hydroxide ion, forming Al(OH)3. A large excess of hydroxide ion must not be added, however, because the precipitate of Al(OH)3 will redissolve as a soluble compound containing aluminum ions and hydroxide ions begins to form. How many grains of solid NaOH should be added to 10.0 mL of 0.250 M A1Cl3 to just precipitate all the aluminum?
A 100.0-mL aliquot of 0.200 M aqueous potassium hydroxide is mixed with 100.0 mL of 0.200 M aqueous magnesium nitrate. a. Write a balanced chemical equation for any reaction that occurs. b. What precipitate forms? c. What mass of precipitate is produced? d. Calculate the concentration of each ion remaining in solution after precipitation is complete.
In order to determine the purity of ammonium sulfate, a sample with a mass of 0.850 g is dissolved in KOH. The equation for the reaction that takes place is NH4+(aq)+OH(aq)NH3(aq)+H2OThe ammonia liberated is distilled into a flask that contains 50.00 mL of 0.250 M HCI. Not all the HCI is consumed. The excess HCI reacts with 17.3 mL of 0.120 M NaOH. What is the mass percent of (NH4)2SO4 in the sample?
42. a. Fill in the following table as if it is a well plate and you are mixing two aqueous compounds at a time to see if a precipitate forms. If a precipitate is expected to form, indicate that by writing the correct formula for the precipitate in the corresponding box in the table. If no precipitate is expected to form, write “NO” in the box. CaCI2 Pb(NO3)2 (NH4)3PO4 Na2CO3 AgNO3 K2SO4 b. How do you prepare 300.0 mL of a 0.250 M CaCl2 solution using an available 2(X) M solution? Support your answer with calculations, but also make sure you describe how to prepare the solution.
Douglasite is a mineral with the formula 2KC1 FeCl2 2H2O. Calculate the mass percent of douglasite in a 455.0-mg sample if it took 37.20 mL of a 0.1000-M AgNO3 solution to precipitate all the Cl as AgCl. Assume the douglasite is the only source of chloride ion.
There are many ionic compounds that dissolve in water to a very small extent. One example is lead(II) chloride. When it dissolves an equilibrium is established between the solid salt and its component ions. Suppose you stir some solid PbCl2 into water. Explain how you would prove that the compound dissolves but to a small extent? Is the dissolving process product-favored or reactant-favored? pbcl2(s)pb2+(aq)+2cl(aq)
When 85.0 mL of 0.250 M Ba(OH)2 solution is added to 85.00 mL of 0.250 M Al (NO3)3 solution, a white gelatinous precipitate of Al(OH)3; is formed. Assuming 100% yield, (a) what mass (in grams) of Al(OH)3 is formed? (b) what is the molarity of each of the ions Ba2+, OH-, Al3+, NO3- in the resulting solution?
Lead poisoning has been a hazard for centuries. Some scholars believe that the decline of the Roman Empire can be traced, in part, to high levels of lead in water from containers and pipes, and from wine that was stored in leadglazed containers. If we presume that the typical Roman water supply was saturated with lead carbonate, PbCO3 (Ksp = 7.4 1014), how much lead will a Roman ingest in a year if he or she drinks 1 L/day from the container?
What mass of solid aluminum hydroxide can be produced when 50.0 mL of 0.200 M Al(NO3)3 is added to 200.0 mL of 0.100 M KOH?
Strong acid solutions may have their concentration determined by reaction with measured quantities of standard sodium carbonate solution. What mass of Na2CO3 is needed to prepare 250. mL of 0.0500 M Na2CO, solution?
The cations Ba2+ and Sr2+ can be precipitated as very insoluble sulfates. (a) If you add sodium sulfate to a solution containing these metal cations, each with a concentration of 0.10 M, which is precipitated first, BaSO4 or SrSO4? (b) What will be the concentration of the first ion that precipitates (Ba2+ or Sr2+) when the second, more soluble salt begins to precipitate?