A square footing 2.5 m X 2.5 m is built on a homogeneous bed of sand of density 19 kN/m3 having an angle of shearing resistance of 36o. The depth of foundation is 1.5 m below the ground surface. Calculate the safe load that can be applied on the footing with a factor of safety of 3. Take bearing capacity factors as Nc= 27, Nq = 30, Nγ = 35

A square footing 2.5 m X 2.5 m is built on a homogeneous bed of sand of density 19 kN/m3 having an angle of shearing resistance of 36o. The depth of foundation is 1.5 m below the ground surface. Calculate the safe load that can be applied on the footing with a factor of safety of 3. Take bearing capacity factors as Nc= 27, Nq = 30, Nγ = 35

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter16: Soil Bearing Capacity For Shallow Foundations

Section: Chapter Questions

Problem 16.17P

See similar textbooks

Similar questions

A 2 m 3 m spread footing placed at a depth of 2 m carries a vertical load of 3000 kN and a moment of 300 kN m, as shown in Figure P6.14. Determine the factor of safety using Meyerhofs effective area method. Figure P6.14
A circular foundation of 1.5 m diameter is constructed in a sand deposit. Given: Df =1 5 m, soil friction angle Ø =35o and soil unit weight γ =17 4kN/m3. Estimate the ultimate uplift capacity of the foundation.
A square footing 2.8 m X 2.8 m is built on a homogeneous bed of sand of density 18 kN/m3 and ϕ = 36o. If the depth of foundation is 1.8 m, determine the safe load that can be applied on the footing.
A square foundation is 1.5m x 1.5m in plan. The soil supporting the foundation has a friction angle '=20 and c'=15.2 kN/m². The unit weight of soil is y=17.8 kN/m². Determine the allowable gross load on the foundation with a factor of safety F,=4. Assume that the depth of the foundation D=1m and the general shear failure occur in the soils mass.
Calculate the stress at the end of the clay stratum σ, and the increment Δσ that the footing produces a load P = 1200 KN, at points A and B C
The ultimate bearing capacity of a strip footing is 1500 mm wide and 120 cm deep for a frictional cohesive soil, Use Terzaghi's formula at general failure condition. Take Nc= 57.80, Nq= 41.4, Nϒ= 42.4, ϒ = 18kN/m3, c= 15kN/m3
Consider a continuous foundation of width B = 1.4 m on a sand deposit with c' = 0, Φ' = 38° and γ = 17.5 kN/m3. The foundation is subjected to an eccentrically inclined load (see Figure 4.31). Given: load eccentricity e = 0.15 m, Df = 1 m, and load inclination β = 18°. Estimate the failure load Qu(ei) per unit length of the foundation a. for a partially compensated type of loading [Eq. (4.85)] b. for a reinforced type of loading [Eq. (4.86)]
A square footing 2.8 m X 2.8 m is constructed on a uniform bed of sand with a density of 18 kN/m3 and a slope of = 36o. Determine the safe load that may be applied to the footing if the foundation depth is 1.8 m.
A strip footing foundation 1 m wide is constructed in the slope of a hill whose surface inclination is 20°. The soil in the hill is a dense sand, with a unit weight of 19 kN/m3 and an angle of internal friction of 40°. Assume that the D/B ratio is about 1. Applying a factor of safety of 3, determine the wall loading the foundation can carry, per meter of footing length.
A square foundation with dimensions 1m × 1m has to be constructed on a dense sand. The unit weight and the static angle of friction of the soil can be assigned representative values of 19.8 kN/m3 and 36 degrees, respectively. The foundation may occasionally be subjected to a maximum dynamic load of 600 kN increasing at a moderate rate. Determine the required minimum depth (Df) of the shallow foundation using a safety factor of 3.
A square foundation is 1.5 m by 1.5 m in plan. The soil properties supporting the foundation have a friction angle of 28° and c = 15.2 kPa, unit weight = 19.8kN/m3• The depth of the footing is 2.0 m. Factor of safety is 3. Using Terzaghi's Bearing capacity equation, determine the design load on the foundation.
For an eccentrically loaded continuous foundation on sand, given B = 1.9m, Df = 0.81m, e/B = 0.21 (one way eccentricity), unit weight of soil = 18.58 kN/m³, and Φ = 35, Using Meyerhof effective area method, estimate the ultimate load per unit length of the foundation.