A Standard Proctor compaction test performed on a sample of crushed limestone (G; = 15.70) obtained a maximum dry unit weight of 80 pef at OMC. A field compacted sample showed a moisture of 99% and a unit weight of 193.7 pef. Find the relative compaction (RC). Find the degree of saturation S of the field soil sample

A Standard Proctor compaction test performed on a sample of crushed limestone (G; = 15.70) obtained a maximum dry unit weight of 80 pef at OMC. A field compacted sample showed a moisture of 99% and a unit weight of 193.7 pef. Find the relative compaction (RC). Find the degree of saturation S of the field soil sample

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter5: Soil Compaction

Section: Chapter Questions

Problem 5.15P

See similar textbooks

Similar questions

A Standard Proctor compaction test performed on a sample of crushed limestone (G; = 9.70) obtained a maximum dry unit weight of 80 pef at OMC. A field compacted sample showed a moisture of 98% and a unit weight of 803.7 pef. Find the relative compaction (RC). Find the degree of saturation S of the field soil sample.
A sample coarse grained soil is 50mm. In diameter and 150mm long was tested in a constant-head apparatus. The soil sample was prepared at a void ratio of 1.5. The total head was kept constant at 300mm and the amount of water is collected in 4 sec. was 50cm^3. The test temperature was 22°Ca.) Compute the temperature correction factor.b.) Compute the corrected coefficient of permeability in cm/sec. c.) Compute the interstitial velocity.
Determine the maximum dry unit weight of compaction Determine the optimum moisture content Determine the void ratio at the optimum moisture content. Gs = 2.70 Determine the degree of saturation at the optimum moisture content A field unit determination test for the soil, yielded the following data. Moisture content = 12% and moist unit weight = 106 lb/cu.ft. Determine the relative compaction.
Results of a standard proctor ompaction test on a silty sand are shown. PLEASE COMPLETE SOLUTION. 1) Find the maximum dry unit weight and optimum moisture content. 2) What is the moist unit weight at optimum moisture content? 3) What is the degree of saturation at optimum moisture content? Given: ?? = 2.69 4) If the required field dry unit weight is 18.5 ??/?3, what is the relative compaction? 5) What should be the range of compaction moisture contents in the field to achieve the above relative compaction? 6) If the minimum and maximum void ratios are 0.31 and 0.82, respectively, what is the relative density of compaction in the field?
9. The results of a Standard Proctoretest is tabulated as follows: (CHECK PICTURE) Determine the maximum dry unit weight of compaction Determine the void ratio at the optimum moisture content Gs = 2.68 Determine the optimum moisture content Determine the degree of saturation at the optimum moisture content
During a consolidation test, a sample of fully saturated clay 3 cm thick is consolidated under apressure increment of 4500 lb/ft2. When equilibrium is reached, the sample thickness is reduced to2.60 cm. The pressure is then removed and the sample is allowed to expand and absorb water.The final thickness is observed as 2.8 cm and the final moisture content is determined as 24.9%. Ifthe specific gravity of the soil solids is 2.70, find the void ratio of the sample before and afterconsolidation
A 443 gram, 42.8 mm diameter by 97 mm long clay specimen was tested in a triaxial test. After failure, the entire specimen was dried to a constant mass of 342 grams. Using either an assumed specific gravity of 2.579 or assuming saturation (whichever is more appropriate), FIND the moisture content (%, 1 decimal place).
A 75 mm diameter and 150 mm high clay specimen has a mass of 1392.5 g. When it is dried, the mass becomes 1196.5 g. Find the degree of saturation in the specimen, assuming the specific gravity of the soil grains is 2.70. Show handwritten solution.
3. The following table lists the results of a standard Proctor assay. Determine the maximum dry compaction density and the optimum moisture content. Also obtain the void ratio and degree of saturation for optimum moisture content. Assume Gs = 2.68.
a. A soil specimen with volume of 0.60x10-4 m3 , weighs 0.105 kg. Its dry weight is 0.0802 kg, and Gs is 2.65. Compute • Water content m, % • Void ratio e and porosity n Degree of saturation Sr, %
CONSTANT HEAD PERMEABILITY TEST a. why the need to get the temperature of the collected water? b. what is the reason why we need a saturated specimen? c. why does the soil need to be compacted before undergoing the process?
A 1 m thick soil with an initial void ratio of 0.94 was compacted by a roller and its thickness reduced by 0.09 m. The specific gravity of this soil is 2.65. A 178.0 g soil sample was collected from the compacted soil mass to examine the degree of compaction. The sample was dried in an oven for 24 hours and it had a dry mass of 142.4 g. Determine the degree of saturation of the soil after the compaction.