A stone weighed 177 N on earth. It was dropped in to oil of specific gravity 0.8 on a planet whose acceleration due to gravity is 5m/s2. It displaced oil having weight of 100N. What was the volume of oil displaced by the stone?

A stone weighed 177 N on earth. It was dropped in to oil of specific gravity 0.8 on a planet whose acceleration due to gravity is 5m/s2. It displaced oil having weight of 100N. What was the volume of oil displaced by the stone?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter10: Force And Force-related Variables In Engineering

Section: Chapter Questions

Problem 26P: SAE 30 oil is contained in a cylinder with inside diameter of 1 in. and length of 1 ft. What is the...

See similar textbooks

Related questions

Q: A side view of a signboard supported by two trusses is shown in Figure Q1. The board has a length of...

A: To solve the given truss. Cross-section of the sign board: 7.5 m x 6 m Wind pressure = 3 kPa (or k...

Q: Truss: Number of member%3D8 Number of support%3D4 Number of joint%3D6 Determine degree of static ind...

A: Introduction : The given question is related with structural analysis . With help of the data given ...

Q: Classify

Q: Given are the data of a continuous one -way slab. The spans given are all clear spans. For moment ca...

A: One way slab: When the slab is supported on two opposite sides of the slab is known as One way slab....

Q: What is the purpose of Aggregate moisture content test?

A: It is asked to answer about the purpose of aggregate moisture content test.

Q: 1 KN 4 KN 2KN 5 KN/m -70 CM 40 CM -70 CM 40 CM+-40 CM 60 CMH SUPPORT SUPPORT

Q: t is not on the line, the rod reading eading of 1.952 m is observed, the are then resumed: 90 m from...

Q: The peck depth is entered using the letter O Q O P OF

A: The peck depth is entered using letter Q Option A is correct

Q: What will be the efficient minimum spacing 'S' between the channels of laced column formed by 2 ISMC...

Q: IV. PROBLEM SOLVING *** Sign Convention : Positive values are for vertical forces upward and horizon...

A: note: we bartleby experts are required to answer only first 3 sub parts of the question. So please s...

Q: A clay sample, originally 35 mm thick at a void ratio of 1.2 was subjected to a compressive load. Af...

Q: Pasig River EXISTING STRUCTURE EXISTING STRUCTURE PSG COMPOUND Croek Creek 2 SITE DEVELOPMENT PLAN C...

A: Plan detail of a site is given. From the given detail various important factors which comes out fr...

Q: . From petrographic analysis, an igneous rock was found to be composed of a mixture of 30% quartz, 3...

Q: A Cylindrical soil sample of 7.5 cm height and 3.75 cm diameter has been prepared at the shrinkage l...

Q: In the figure (a) shown, fluid A is alcohol with SG = 0.79, fluid B is mercury, z = 450 mm, y = 900 ...

Q: A Saturated soil sample has a volume of 45 ??^3 at the liquid limit. If the soil has a liquid limit ...

Q: The interior angles of a five side traverse are as follows: A = 117°30' B = 96°32' C = 142°54' D = 1...

Q: A fully saturated soil mass has specific gravity of 2.5 void ratio 0.55.Determine water content

A: This question is related to the Soil Mechanics. In this question we calculate the water content of s...

Q: Determine the maximum load P that can be applied in the system consisting of a bent bar bolted at bo...

Q: 2. The force system shown consists of the couple C and the four forces. The resultant of this system...

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of understandin...

Q: 1. Fineness modulus of the aggregate Weight Retained Sieve Individual Percent Cumulative Percent Per...

Q: 2. An arithmetic sequence has a common difference equal to 10 and its 6th term is equal to 52. Find ...

A: We will use formula for nth term

Q: 4. The W360 3 79 rolled-steel beam AC is simply supported and carries the uniformly distributed load...

Q: The bar supported by a pin at B and a cable at A carries a load of 260 N at C. Neglecting the weight...

Q: Problem 11 A survey party proceeded to do their stadia survey work as follows: the transit was set u...

A: We have to determine the value of stadia interval factor of the given stadia survey and the data acc...

Q: 1. Percent passing on sieve 600um Weight Individual Cumulative Percent Sieve Retained Percent Percen...

A: Given Seives size and weight retained on each seive. To Determine Percent passing on seive 600um

Q: The value of compression index (cc) for a remoulded sample whose liquid limit is 40% will be

Q: Determine poisson ratio if lateral is -0.3 and longitudinal strain 0.5

A: Poisson ratio = -(lateral strain / longitudinal strain)

Q: Instruction: Determine the magnitude and direction of the support reactions of the beams provided be...

Q: A rock is thrown upward at a speed of 13.61 m/s. How long will it take to reach its highest point? t...

A: Given data, Initial velocity u = 13.61 m/s

Q: Problem 1: ProCoarse aggregate is placed in a rigid bucket and rodded with a tamping rod to determi...

Q: CVE 331: Theoretical hydraulic conductivity calculation ki Problem 1: The hydraulic conductivity of ...

A: To solve with the help of relation between hydraulic conductivity and void ratio

Q: A rock is thrown upward at a speed of 13.61 m/s. How long will it take to reach its highest point? t...

Q: Problem 2 Normal Distributions A lake has one input stream with a flow rate of 4 m/min. The value of...

A: Given that Flow rate Q= 4 m3/min Mean Value μ= 10grams/m3 Standard Deviation σ'=2 grams/m3 a) Mean...

Q: The size (d,) of droplets produced by a liquid spray nozzle is demonstrated to depend upon the nozzl...

A: Given:- The size of the droplets produced by a liquid spray nozzle depends on:- a) Nozzle diameter (...

Q: Determine poisson ratio if lateral is -0.3 and longitudinal strain 0.5

Q: Situation C: A rectangular beam has a concrete strength of 24 MPa. The yield strength of the reinfor...

Q: What annuity over a 10 year period at 8% interest is equivalent to a present worth of P100,000?

Q: The turnbuckle is tightened until the tension in cable AB is 2.4 kN. Determine the moment about poin...

A: We have to determine the value of moment about x-axis due to tensile force at AB as per the given da...

Q: A built up section shown consists of A992 steel made from plates fully welded together. The flanges ...

A: For plastic section, neutral axis (N.A) divide the section into two equal area.

Q: 0.5 psi Оpen Air 0.1 ft Water Liquid (SG = 0.6) Mèrcury (SG = 13.6) I Figure P2.38 Compartments A an...

A: We have to determine the value of manometer reading h if the barometer pressure is 14.7 psia and pre...

Q: If the resultant force is required to act along the positive u axis and have a magnitude of 5 kN, de...

Q: Below is a moment diagram of a certain beam. 2(m) 2(m) 2(m) 1(m) 3.32 2.96 Mx n=2 -2.04 -2.4 1. Dete...

A: As per guidelines provided by Bartleby, I am attempting only first three sub part of the question. T...

Q: Calculate percentages passing, total percentages retained, or percentages in various size fractions...

A: To calculate the percent retained in each sieve, total percentage retained and the percent passing. ...

Q: A solid circular steel column is 3 m long and 0.4 m in diameter. It carries a oad of 50 MN. The modu...

A: (i) Find the stress in the column. (ii) Find the strain in the column.

Q: 1. The density of the water if the its temperature is 15.6 degrees Celsius in kg per cubic meter? ) ...

A: Option (a) is correct. More explanation is given below.

Q: As a material engineer in the field warehouse how will you test or check the cement delivered on si...

A: On site cement is tested using simple ways like Texture of cement should be smooth Should be fre...

Q: Determine the maximu m allowable lo ad P

Q: 50 kN/m 20 kN/m IMANTIHalinomm Kam * A D B 4 m 3 m 4 m RA Rp

Q: PI Lt PC C D Forw tangen jent R PT 12

A: What has to be determined in this question.

Concept explainers

Professional survey

A professional survey is a systematic questionnaire that the target audience fills out online, usually by filling out google forms. Professional surveys can vary in length and format. The data is stored on a website and the testing tool usually provides a certain level of data analysis in addition to a professional expert review. Several professional online survey softwares are present worldwide like, SoGoSurvey, SurveyGizmo, SurveyMonkey, Qualtrics, and so on.

Question

100%

civil engineers pls answer

A stone weighed 177 N on earth. It was dropped in to oil of specific gravity 0.8 on a planet whose acceleration due to gravity is
5m/s2. It displaced oil having weight of 100N. What was the volume of oil displaced by the stone?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A liquid has a specific weight of 41.5 lbs/ft3. How much will a cylinder that measures 18” tall and 13” in diameter weigh?
A certain gas weighs 7 KN/m^3 at a certain temperature and pressure. What are the values of its density, specific volume, and specific gravity relative to air weighing 12 N/m^3?
A cube of material is 4 in. on a side and floats at the interface between kerosene (SG=0.82) and water, as shown.a. Find the specific gravity of the material. b. How much weight is required to fully submerge the cube underwater?Show Free body diagramThe answer should be: a) 0.973 and b) 0.063 lb
If the density of a certain liquid is 1.89 slugs/ft3, what is its specific weight in KN/m3?
If the specific gravity of the unknown fluid is 12.56 what is its specific weight in lb/ft³?
4.) A quart of SAE 30 oil at 68 °F weighs about 1.85 lb. Calculate the oil's specific weight, mass density, and specific gravity.
A hollow cylinder 1.72-m in diameter and 6-m long weighs 3,046 N. How many cubic meters (m3) of metal weighing 102 kN/m3 must be placed inside the cylinder such that 1.1 m. of the cylinder is protruding above the liquid surface? The hollow cylinder is submerged in a liquid that has a specific gravity of 2.7. Round off to four decimal places.
An 8 ft diameter by 16 ft height vertical tank is receiving water (? = 62.5 lb/ft3) at the rate of 295 gal/min and discharging through a 4-in ID line with a constant speed of 6 fps. At a given instant, the tank is half full. Determine the following: QUESTION 1: the mass change in the tank (sample answer: 20,287.65 lb. round off to 2 decimal place
Determine the weight of an exploration vehicle whose mass is 250kg on the Earth. What is the mass of the vehicle on the Moon ( gMoon = 1.6 m/s2 ) andthe planet Mars ( gMars = 3.7 ) m/s2 ? What is the weight of the vehicle on theMoon and Mars?
a.) If the specific weight of a liquid is 55 lb/ft3, what is its density? b.) If the specific weight of a liquid is 9.6 kN/m³, what is its density? c.) If the specific volume of a gas is 295 ft3/slug, what is its specific weight in lb/ft³?
3. A brass sphere (sp.gr. 8.60) is placed in a body of mercury. If the diameter of the sphere is 30cm. a. What minimum force would be required to hold it submerged in mercury? b. What is the depth of floatation of the sphere when it is floating freely?
A supertanker filled with oil has a total mass of 14.5 × 108 kg. If the dimensions of the ship are those of a rectangular box 275 meters long, 90 meters wide, and 60 meters high, determine how far the bottom of the ship is below sea level. ( ρsea = 1020 kg/m3)