A student holds a laser that emits light of wavelength 632.8 nm. The laser beam passes through a pair of slits separated by 0.300 mm, in a glass plate attached to the front of the laser. The beam then falls perpendicularly on a screen, creating an interference pattern on it. The student begins to walk directly toward the screen at 3.00 m/s. The central maximum on the screen is stationary. Find the speed of the 50th-order maxima on the screen.

A student holds a laser that emits light of wavelength 632.8 nm. The laser beam passes through a pair of slits separated by 0.300 mm, in a glass plate attached to the front of the laser. The beam then falls perpendicularly on a screen, creating an interference pattern on it. The student begins to walk directly toward the screen at 3.00 m/s. The central maximum on the screen is stationary. Find the speed of the 50th-order maxima on the screen.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter35: Diffraction And Interference

Section: Chapter Questions

Problem 44PQ

See similar textbooks

Similar questions

A beam of 580-nm light passes through two closely spaced glass plates at close to normal incidence as shown in Figure P27.23. For what minimum nonzero value of the plate separation d is the transmitted light bright?
Both sides of a uniform film that has index of refraction n and thickness d are in contact with air. For normal incidence of light, an intensity minimum is observed in the reflected light at λ2 and an intensity maximum is observed at λ1, where λ1 > λ2. (a) Assuming no intensity minima are observed between λ1 and λ2, find an expression for the integer m in Equations 27.13 and 27.14 in terms of the wavelengths λ1 and λ2. (b) Assuming n = 1.40, λ1 = 500 nm, and λ2 = 370 nm, determine the best estimate for the thickness of the film.
Laser light of wavelength 460 nmnm is traveling in air and shines at normal incidence onto the flat end of a transparent plastic rod that has nn = 1.30. The end of the rod has a thin coating of a transparent material that has refractive index 1.75. a)What is the minimum (nonzero) thickness of the coating for which there is maximum transmission of the light into the rod? b)What is the minimum (nonzero) thickness of the coating for which transmission into the rod is minimized?
A glass sheet 1.10 μm thick is suspended in air. In reflected light, there are gaps in the visible spectrum at 573 nm and 645.00 nm. Calculate the minimum value of the index of refraction ?n of the glass sheet that produces this effect. ?=
To keep unwanted light from reflecting from the surface of eyeglasses or other lenses, a thin film of a material with an index of refraction n = 1.38 iscoated onto the plastic lens (n = 1.55). What is the thinnest film that will minimize reflection for λ = 550 nm, the middle of the visible-light spectrum?
assume that two waves of light in air, of wavelength 400 nm, are initially in phase. One travels through a glass layer of index of refraction n1 = 1.60 and thickness L. The other travels through an equally thick plastic layer of index of refraction n2 = 1.50. (a) What is the smallest value L should have if the waves are to end up with a phase difference of 5.65 rad? (b) If the waves arrive at some common point with the same amplitude, is their interference fully constructive, fully destructive, intermediate but closer to fully constructive, or intermediate but closer to fully destructive?
A plano-convex lens rests with its curved side on a flat glass surface and is illuminated from above by light of wavelength 464 nm. A dark spot is observed at the center, surrounded by 19 concentric dark rings (with bright rings in between). How much thicker is the air wedge at the position of the 19th dark ring than at the center? 2.41 um 2.97 um 3.77 um 4.41 um