a) Suppose you have resistors 2.0 11., 3.5 KR, and 4.5 Kort and a bo v power supply, what is the ratio of the total power delivered to the resistors if they are connected in parallel to the total power delivered if they are connected in series? A 4:3 B) 13:2 c) 7.6 b) 10

a) Suppose you have resistors 2.0 11., 3.5 KR, and 4.5 Kort and a bo v power supply, what is the ratio of the total power delivered to the resistors if they are connected in parallel to the total power delivered if they are connected in series? A 4:3 B) 13:2 c) 7.6 b) 10

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Related questions

Q: Find the quantity of heat needed to change a 1.0-g ice cube at absolute zero (-273° C) to 1.0 g of…

A: A) Write the expression for the heat needed to change the ice to boiling water and substitute the…

Q: A mass is suspended by a spring such that it hangs at rest 0.5 m above the ground. The mass is…

A: The mass makes a sinusoidal oscillation of amplitude 40 cm=0.4 m around the height 0.5 m above the…

Q: As shown below, a bullet of mass m and speed v is fired at an initially stationary pendulum bob. The…

Q: A 5.0-kilogram grenade lying motionless on the ground explodes into three pieces. (It's not a very…

A: Let the velocity of third piece be v at an angle ϕ degrees. Also note that the mass of third piece…

Q: A rightward force is applied to a 10-kg object to move it across a rough surface at constant…

Q: To test the effects of high acceleration on the human body, the National Aeronautics, and Space The…

Q: A 392-kg boat is sailing 18.0° north of east at a speed of 1.90 m/s. 31.0 s later, it is sailing…

A: Given:- The mass of the boat is m =392 kg and it sailing 18.0o north of east with the initial speed…

Q: 1 lige pulley going up polling down IN on is lifting a crate (mass = m) using a . The crate rises at…

A: Mass = m = 53 kg Distance = d = 2.7 m Work done by person = W = ?

Q: This is an displacement-time (x-t) graph of a SHM. A O X T 27 -A For A = 4.5cm and T = 1.5s find the…

Q: A space station is constructed in the shape of a wheel 50m in diameter, all the mass on the outer…

Q: WIth the dimensions of a box given, what is the uncertainty of the volume (cm3)? Round your answer…

Q: A block of solid copper sits on a flat, level table. Copper has a density of 8.94 x 10³ kg/m³. The…

A: Given data: Density of copper (ρ) = 8.94×103 kg/m3 Mass (m) = 20.6 kg Area (A) = 2.03×10-2 m2…

Q: Magnetic fields and magnetic forces Two wires run parallel to each other and carry current that…

A: Given Current is flowing in two parallel wire in the same direction . We have to find force between…

Q: For the circuit shown in the figure below, calculate the following quantities. (Assume & = 7.50 V…

Q: 2. The second spectral line in the Balmer series in the hydrogen spectrum, called the Hp line,…

Q: In a particular velocity selector, as shown below, the electric field has a magnitude of 455 N/C,…

A: Given data: Electric field (E) = 455 N/C Magnitude of magnetic field (B) = 0.16 T Required: The…

Q: A resistor is connected across an ac source as shown. For this circuit, what is the relationship…

Q: When you start your record player, a ladybug is sitting on the edge of the record, 15 cm from the…

Q: What is the sum of the following four vectors: a. In unit vector notation b. as a magnitude and an…

A: The vectors are given as: A→=(3 m)i+(5 m)jB→=[(3 m)cos178°]i+[(3 m)sin178°]j=(−2.998 m)i+(0.1047…

Q: What is the voltage amplitude across the capacitor?

A: Voltage across capacitor= current× reactance of capacitor

Q: You solve a second order linear differential equation with constant coefficients and find its…

Q: How fast can the 155 A current through a 0.160 H inductor be shut off if the induced emf cannot…

A: For the inductor we have V=LdIdt=L∆I∆t⇒∆t=LV∆I

Q: A waste management company handles large dumpsters of construction debris. The sorting process…

Q: What is the pressure (in N/m2) inside an alveolus having a radius of 2.04 x 10-4 m if the surface…

Q: A 60 kg person will need to climb a 10m stairway how many times to “work off” a 200 Calorie (that’s…

Q: Water flows out of a spigot at the bottom of a very wide storage tank at a velocity of 10.4 m/s?…

Q: Determine the current I flowing through a solenoid, if the magnetic flux inside its core is found to…

Q: (a) What is the direction of the magnetic field due to "leg 1" at point P? Draw and label this…

A: a) point P lies along the axis of wire (leg 1) so the magnetic field due to leg 1 will be B1=0 at…

Q: Consider a series RC circuit as in the figure below for which R 6.00 MQ, C = 1.00 μF, and ε = 32.0…

A: Given data: The resistance, R=6 MΩ=6×106 Ω The capacitance, C=1 μF=1×10-6 F ε=32 V

Q: What is the maximuim torque he could exert with a force of this magnitude?

Q: you weigh yourself on a bathroom scale at the equator, is the reading you get greater than, less…

Q: 8.2 Two objects of masses m₁ = 5 kg and m₂ = 3 kg moving eastward with speeds v₁ = 10 ms¹¹ and v2 =…

A: Given: The masses of the objects are m1=5 kg, and m2=3 kg. The initial velocities of the object are…

Q: Consider two pendulums, Pendulum 1 with length L and Pendulum 2 with length 2L. How does the period…

A: Solution:- 1) The time period of oscillation of a simple pendulum is given by T = 2π(L/g)1/2 Here,…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

Q: During the FIBA World Cup. Philippines Kai Sotto decided to take a gamewinner three point shot…

Q: a. Use Newton's 3rd Law to explain, briefly, why you can't get to the moon by standing on an iron…

Q: For the circuit shown in the figure below, calculate the following quantities. (Assume = 7.50 V and…

Q: How many more students were enrolled at the University of Michigan in 2000 than in 1900? Answer in…

A: We have the following given data; The number of students were enrolled in 1900 is x1=3.7×103 The…

Q: An electron in a uniform electric field experiences a force due east. If the electron is replaced…

A: The force on the electron is directed due east.

Q: A spring-loaded dart gun is used to shoot a dart straight up into the air. When fully compressed,…

A: Solution

Q: According to the law of refraction, a ray entering a material with higher refractive index will:…

A: Given data: A ray entering a meterial with higher refractive index Required: The direction of…

Q: The greatest ocean depths on the Earth are found in the Marianas Trench near the Philippines, where…

Q: oes around a curve on a road that is banked at an angle of 33.5°. Even though the road is slick,…

Q: Question ( Which of the following is a unit vector parallel to the vector? Select one: O None of…

Q: 1. A charge of 12x10 °C and a charge of 3.0x10°C are separated by a distance of 60.0 cm. Find the…

Q: You have designed and constructed a solenoid to produce a magnetic field equal in magnitude to that…

Q: A fire hose ejects a stream of water at an angle of 35° above the horizontal with a speed of 25 m/s.…

A: Given data: Initial velocity (u) = 25 m/s Angle (θ) = 35°, above the horizontal Required: The…

Q: A rightward force is applied to a 6-kg object to move it across a rough surface at constant vel The…

Q: Please show your complete solution on paper. Thank you! Compute for the density of Palladium which…

Q: A pendulum consists of a small object hanging from the ceiling at the end of a string of negligible…

Question

Suppose you have resistors 2.010, 3.5KR, and 4.5K and
a loo v power supply, what is the ratio of the total power
delivered to the resistors if they are connected in parallel
to the total power delivered if they are connected in series?
A) 4:3
13) 13:2
c) 7.6
D) 10
a)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Resistors are commonly rated at 18W,14W,12W ,1 W and 2 W for use in electrical circuits. If a current of1 = 2.00 A is accidentally passed through a R=1.00 resistor rated at 1 W, what would be the most probable outcome? Is there anything that can be done to prevent such an accident?
Check Your Understanding How would you use a river and two waterfalls to model a parallel configuration of two resistors? How does this analogy break down?
Semi-truck or trucks use four large 12-V batteries. The starter systemrequires 24 V, while normal operation of the truck’s other electrical components utilizes 12 V. How could the four batteries be connected to produce 24 V? To produce 12 V? Why is 24 V better than 12 V for starting the truck’s engine (a very heavy load)?
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
Ralph has three resistors, R1, R2, and R3, connected in series. When connected to an ideal emf source E1, current I1 flows through the resistors. a. If the resistors are instead connected to a second source with E2=2E1, what is the new current through the resistors in terms of the first current? b. Show that, if each resistance is doubled and the resistors are connected in series to the second emf source, the current through the resistors is equal to I1.
Three identical 60.0-W, 120-V lightbulbs are connected across a 120-V power source as shown in Figure P28.72. Assuming the resistance of each lightbulb is constant (even though in reality the resistance might increase markedly with current), find (a) the total power supplied by the power source and (b) the potential difference across each lightbulb.
Check Your Understanding Digital meters are able to detect smaller currents than analog meters employing galvanometers. How does this explain their ability to measure voltage and current more accurately than analog meters?
(a) What advantage does 120-V operation offer over 240 V? (b) What disadvantages does it have?
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.