A surge of 100 kV travels along an overhead line towards its junction with a cable. The surge impedance for the overhead line and cable are 400 ohms and 50 ohms respectively. The magnitude of the surge transmitted through the 12.4 cable is

A surge of 100 kV travels along an overhead line towards its junction with a cable. The surge impedance for the overhead line and cable are 400 ohms and 50 ohms respectively. The magnitude of the surge transmitted through the 12.4 cable is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.13P

See similar textbooks

Related questions

Q: estimate the distance over which the load of 15000 KW at 0.85 power factor can be delivered by a…

A: Given information: The value of the line current is determined as follows:

Q: 11. A three-phase 345-kV transmission line with a horizontal tower top configuration has a 24.6-ft…

A: According to question:

Q: Question 5: A single-phase transmission line has a resistance of 0.22 ohm and inductive reactance of…

A: Given transmission line is single-phase transmission line. Resistance of the line, R=0.22Ω.…

Q: Problem 3.5: From a 3-phase, 480 V generator switchboard, a feeder takes 3-phase power to two…

A: A feeder takes 3 phase power at the other end through cables and transformer Combined series…

Q: A 70-kV, three-phase short .Determine t

A: It is given that: V= 70 kVL=18 KmZphase=1+j5 ΩPR3-ϕ=90 MW

Q: A 30 km, three phase overhead transmission

Q: Calculate the inductance per phase per meter for a three- phase double-circuit line whose phase…

Q: Calculate the capacitance per km per phase for a 3 phase, 50HZ, double circuit line shown in figure…

A: Capacitance- Capacitance is dependent on the ratio of Q and V and independent of the individual…

Q: In a three phase overhead system , each line is suspended by a string of three insulator. The…

Q: A transmission line of 550 Ω surge impedance is connected to a cable of 100 Ω surge impedance at the…

Q: Most industrial loads (Motors, Fluorescent lights) are inductive in nature and have a lagging power…

A: To select correct answer Most industrial loads (Motors, Fluorescent lights) are inductive in nature…

Q: The resistance and reactance of the single- phase 60HZ transmission line conductors are 7.2 ohm and…

Q: For a transmission line, the value of the open circuit and short circuit impedance are 100 ohm and…

A: If ZOC is the open circuit input impedance and ZSC is the short circuit input impedance of a…

Q: A three phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure…

A: expression for the transposed line for the inductance. Given line is double circuit. Assume…

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A: Given data, Corona loss P1=53 KW at V1=106 KV Corona loss P2=98 KW at V2=111 KV Phase voltage is…

Q: 9.23 A three- phase, 230-kV, 60H2, comple tely transpesed transmission line 1113-MCM horizontal…

A: In this question we need to find a capacitance , admittance and total charging current of line .

Q: The voltage regulation of a transmission line is negative for lagging power factor. Select one: O…

A: Given Voltage regulator is negative for lagging load True or false

Q: Refer to Figure 1. Using its equivalent reactance diagram, what is the total impedance of the system…

Q: The impedance per phase of a 3-phase transmission line on a base of 100 MVA and 100 kV is 2 p.u. The…

A: Given, MVAold=100 MVAKVold=100 kVZpuold=2 p.u.MVAnew=400 MVAKVnew=400 kV

Q: a single phase overhead transmission line delivers 4000k w at 11 kV at 0.8 pf lagging. If resistance…

A: First we will calculate receiving end current from given values, using formula we will find sending…

Q: Using admittance parameters determine I0 for the circuit shown below

Q: For the given 3-phase power transfer, a star system is associated with a greater insulation.…

A: The insulation for 3 phase does not depend connection.

Q: Consider the following statements: Surge impedance loading of a transmission line can be increased…

A: we need to explain how SIL can be increased.

Q: In single phase AC distribution system, the net drop is the sum of the drop in resistance due to the…

A: In single phase AC distribution system, we will have resistance as well as reactance components.

Q: Which of the following combinations comprise the Transmission Line Impedance? O A. Conductance and…

A: Consider the diagram for the equivalent circuit model for the characteristic impedance of the…

Q: Determine the per unit impedance of a transmission line having an impedance of 30 + j110 Ω on 100…

Q: The base current and base voltage of a 345 kV system are chosen to be 3000A and 300kV respectively.…

A: The solution is given below

Q: A certain 3-phase equilateral transmission line has a total corona loss of 53 kW at 106 kV and a…

Q: The resistance and reactance of the single-phase 60Hz transmission line conductors are 5.4 ohm and…

Q: A short 3- line with an impedance of (6 + j8) N per line has sending and receiving end line voltages…

A: Given a short 3-φ line with, Impedance per line, Z = (6 + j8) Ω Resistance, R = 6 Ω Reactance, X = 8…

Q: Problem 3.5: From a 3-phase, 480 V generator switchboard, a feeder takes 3-phase power to two…

Q: Draw the equivalent circuits of the lines by writing the impedance values in place as given in…

A: The equivalent circuit of a transmission line is nothing but the representation of a transmission…

Q: The scheduled power at the bus of a power system is the Difference of the Generation and load power…

A: A bus in a power system is defined as the vertical line at which the several components of the power…

Q: The power loss in an overhead transmission line would increases when the of the line is increases.…

A: The solution is given below

Q: A single-phase transmission line 30 kV, 60 Hz, 100 kVA, consists of two hard-drawn aluminium…

Q: A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of…

A: In this question we will find distance between conductors D with given GMD....

Q: b. Determine the inductance per km per phase of a single circuit 460 KV line using two bundle…

A: Given:- r=2.5 cm

Q: A surge of 100 kV travels along an overhead line towards its junction with a cable. The surge…

A: Given, A surge travels along an overhead line towards its junction with a cable is, V= 100 kV The…

Q: The sensitivity of a node to real power changes is 100 MW/kV of line voltage and that to reactive…

Q: a 220 kv 50 hz three phase transmission line consists of 1.4 cm radius conductors spaced 2 m apart…

A: Given data, Line voltage VL=220 KV Radius of conductor r = 1.4 cm Space between the cinductors d =…

Q: Two units of generation maintain 132 kV and 120 kV (line) at the ends of an interconnector of…

A: Power to be transferred = 22MW, Receiving end voltage VR =120kV, Sending end voltage=132kV,…

Q: A short single phase transmission line has a loop impedance of (0.2+j1.2) ohm. At what leading power…

A: Given: A short single phase transmission line has, Loop impedance, Z=0.2+j1.2 Ω so Resistance, R =…

Q: 4. (a) A transmission line with a characteristic impedance of 100 has a load of 1 k2 resistance in…

Q: A 3¢, with VL-L of 34.5 kV, grounded-Way feeder has 556.5 kcmil ACSR with 30-strands AL conductor,…

A: for star connection , phase current = line current . apparent power = 3 ×VL×IL

Q: Draw the impedance diagram with all reactances marked in per unit. Choose a base of 50 MVA, 13.8 kV…

Q: 9. Determine the transformer tap ratios when the receiving end voltage is equal to the sending end…

A: Given data: VR=VSVs=230 kVPo=80 MWpf=0.8ZL=40+j150 Ω

Q: At low power factor, the feeders have to carry more current for the same power to be transmitted.…

A: We know that active power is VIcosphi . As cosphi is very low, it has to draw more current to…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

A surge of 100 kV travels along an overhead
line towards its junction with a cable. The surge
impedance for the overhead line and cable are
400 ohms and 50 ohms respectively. The
magnitude of the surge transmitted through the
12.4
cable is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three-phase line, which has an impedance of (2+j4) per phase, feeds two balanced three-phase loads that are connected in parallel. One of the loads is Y-connected with an impedance of (30+j40) per phase, and the other is -connected with an impedance of (60j45) per phase. The line is energized at the sending end from a 60-Hz, three-phase, balanced voltage source of 1203V (rms. line-to-line). Determine (a) the current, real power. and reactive power delivered by the sending-end source: (b) the line-to-line voltage at the load: (C) the current per phase in each load: and (d) the total three-phase real and reactive powers absorbed by each load and by the line. Check that the total three- phase complex power delivered by the source equals the total three-phase power absorbed by the line and loads.
While the instantaneous electric power delivered by a single-phase generator under balanced steady-state conditions is a function of time havi ng two components of a constant and a double-frequency sinusoid, the total instantaneous electric power delivered by a three-phase generator under balanced steady-state conditions is a constant. (a) True (b) False
A surge of 100 kV travels along an overhead line towards its junction with a cable. The surge impedance for the overhead line and cable are 400 ohms and 50 ohms respectively. The magnitude of the surge transmitted through the cable is ?
A transmission line of 550 Ω surge impedance is connected to a cable of 100 Ω surge impedance at the other end. If a surge of 400 kV travels along the line to the junction point. Determine the voltage build-up at the junction. High voltage engineering subject
a 12500kva load is supplied at a power facter of 0.8 lagging by a 3 phase transmissiom line whose voltage is to be maintained at 33kv at both ends. Determine the capacity of the synchronous condenser to be installed given that the line resistance and reactance per phase are 5 ohms and 13 ohms respectively
A three-phase transposed line is composed of one ACSR Bobolink conductor per phase with a horizontal spacing of 11 meters as shown in the figure. phase with a horizontal spacing of 11 meters as shown in the figure. The conductors have a diameter of 3.625 cm and a RMG of 1.439 cm. Calculate the inductance and capacitance to the neutral of the line.
A Single-Phase, 50 Hz Distribution Line has two conductors in parallel with a distance of 2.75 m apart. The radius of each conductor is 2 cm. Calculate the following: A. Inductance and Inductive Reactance of the Line per meter. B. Capacitance per meter and Capacitive Reactance in Ohm-m.
The annual load duration curve of a power supply system may be considered as straight line from 40 MW to 8 MW. The load factor of the system is ?
Determine the per unit impedance of a transmission line having an impedance of 30 + j110 Ω on 100 MVA and 132 kV base voltage.
A three phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure below. Calculate and derive an expression for the transposed line for the inductance. Assume balanced equally distributed loads.
The conductor of a single-phase 60-Hz line is a solid round aluminum wire having a diameter of 0.412 cm. The conductor spacing is 3 m. Determine the inductance of the line in millinery’s per mile. How much of the inductance is due to internal flux linkages? Assume skin effect is negligible.
A three-phase symmetrical double circuit line is arranged in a horizontal plane as shown in figure below. Calculate and derive an expression for the transposed line for the inductance. Assume balanced equally distributed loads