A swith controls the current in a circuit that has large inductance. If the switch is open but near the point of contact where it would close the circuit, a spark can arc between the switch and the point. Is a spark more likely to occur while the switch is being closed to connect the circuit, or while the switch is being opened to disconnect the circuit? why?

Q: 15. R 전자석은 저항과 직렬로 연결된 인덕터로 생각할 수 있다. 유도 계수 L=12.0 H 와 저항 R-4.00 요 울 가진 큰 전자석이 24.0 V의 배터리와 스위치에 그림과…

A: Write the variables with the given values.

Q: Arrange the following soleholds according to increasing inductance. Here N is the number of turns, A…

A: Given Solenoidwhere N is the number of turns. A is the cross-sectional area and L is the length of…

Q: The diagrams show three circuits with identical batteries, identical inductors, and identical…

A: 1 3, 2

Q: The diagrams show three circuits with identical batteries, identical inductors, and identical…

A: Let each resistance is R . Let voltage of each battery is V .

Q: Figure 2 shows a circular, conducting loop that is connected to a 5.0-V battery and a switch S.…

A:

Q: Two solenoids are part of the spark coil of an automobile. When the current in one solenoid falls…

A: The mutual inductance between two solenoids can be related to the self-inductance of the two…

Q: The switch in the figure below is connected to position a for a long time interval. Att = 0, the…

A:

Q: The switch in the figure below is open for  t < 0  and is then thrown closed at time  t = 0. Assume…

A:

Q: An 8.0-H inductor and a 2.0- resistor are wired in series to a 20-V ideal battery. A switch in the…

A:

Q: WER A 1. What is the value of the induced voltage of the self-inductance when the rate of current is…

A: Write the given values of this problem. i1=200 μAi2=20 μATotal time interval=5 μS

Q: How can we calculate the self inductance of a solenoid?

A: Solenoid is a device made by a coil of wire.

Q: An electromagnet has a resistance of 400 ohms and an inductance of 0.64 henry. If 48 volts is…

A:

Q: When the 20.0 A current through an inductor is turned off in 1.50 ms, an 800 V emf is induced,…

A:

Q: The self-inductance of the circuit in the figure below is 9.60  10-8 H. Find the back emf when the…

A: Given data The self-inductance is given as L = 9.60 x 10-8 H. The rate of increase in current is…

Q: A battery is connected in series with a 5Ω resistor and an inductor, as shown in the figure. The…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: Consider the circuit shown in the figure below. Take & = 6.00 V, L = 7.92 mH, and R = 4.40 N. S R…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The Figure Q3(b) shows an inductor having cylindrical ferromagnetic core.Calculate the value of…

A: N = 200 l = 0.075 m d = 0.005 m To find = Inductance of the coil

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

A: Given data,

Q: A 400-turn solenoid, 25 cm long and 2 cm in diameter is traversed by an electric current of 3 A.…

A: (given)   Number of turns (N) = 400 Length (l) of solenoid = 25 cm = 0.25 m  Diameter of solenoid =…

Q: In the circuit below, the switch has been in the open position for a long time. At t=0, the switch…

A:

Q: If magnetic coils are powered by AC, why don’t their contacts open and close 120 times per second?

A: The overload relay (OLR) is similar in design which is used in manual motor starters. The basic…

Q: Describe the relationship between the charge and current oscillating between a capacitor and…

A:

Q: Problem begins here: A piece of electrical component inside a gaming laptop uses a source of…

A: GIVEN: Voltage=V=4Sin4t,Resistance=R=2 ohms, Inductance=I=1 H,  Time=t=2 sec, Io=0.6 A. To Find: The…

Q: What is the difference between Self-inductance and Mutual inductance?

A: In electromagnetism and electronics, Inductance is a property of the electric which induces the…

Q: Can there be an induced emf in a circuit at an instant when the magnetic flux through the circuit is…

A: Magnetic flux

Q: A 27.0 mH inductor, an 6.00 Ω resistor, and a 6.00 V battery are connected in series. The switch is…

A: Given: Inductance of inductor = 27.0 mH Resistance R=6.0 Ω voltage of battery ε=6.0 V

Q: if two coils placed next to one I know there have a mutual inductance of 3.00 MH, what voltage (in…

A:

Q: single loop is made around the center of a solenoid with a length of 20 m and a radius of 4 m. How…

A:

Q: Two coils, 1 and 2, are separated in space, and have a fixed distance between them. When coil 2 has…

A: Given -  Rate of increase of current in coil -1,   di1/dt  = 24.0 A/s EMF induced in coil -2 due…

Q: Current in a circuit falls from 5.0 A to 0.0 A in 0.1 s. If an average emf of 200 V induced, give an…

A: The initial current is 5.0A, Final current is 0.0A, time taken is 0.1s, and the average emf is 200V.…

Q: Consider the RL circuit shown in the figure, where R = 19.8 Q. The switch S is closed at t = 0. At t…

A: Given, R = 19.8 Ωswitch is closed at t = 0 sec, at t = 3.00 ms I = 96.3% of Io

Q: The current in a circuit containing a coil, a resistor, and a battery has reached a constant value.…

A: (a) In the L-R circuit, as the current increases in the coil, it opposes the change but after a…

Q: When a circuit contains a coil such as solenoid, the self-inductance of the coil prevents the…

A: Self inductance is induction of voltage in circuit when current in wire is changing.

Q: The current through a 4.6H inductor is shown in the following graph. The induced (AVind )during the…

A: The inductance L= 4.6 H The induced emf ∆Vind=-L∆i∆t

Q: Two solenoids are part of the spark coil of an automobile. When the current in one solenoid falls…

A:

Q: 1, Consider the circuit shown in the figure. The battery has emf ɛ = 30 volts and negligible…

A:

Q: A solenoid has a cross sectional area of 0.5 m2 and is 3 m long. If the inductance is 7 mH,…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.