A tank containing gas is separated into two compartments, labelled A and B, by a partition. A and B each carries volume of 15 m³ and 5 m³, respectively. Initially, the specific volume of gas in B is 5 m³/kg. When the partition is removed, the resulting specific volume becomes 8 m³/kg. Find the original specific volume of gas in A.

A tank containing gas is separated into two compartments, labelled A and B, by a partition. A and B each carries volume of 15 m³ and 5 m³, respectively. Initially, the specific volume of gas in B is 5 m³/kg. When the partition is removed, the resulting specific volume becomes 8 m³/kg. Find the original specific volume of gas in A.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter1: Units And Measurement

Section: Chapter Questions

Problem 87AP: A car engine moves a piston with a circular cross-section of 73000.002cm in diameter a distance of...

See similar textbooks

Similar questions

A car engine moves a piston with a circular cross-section of 73000.002cm in diameter a distance of 3.2500.001cm to compress the gas in the cylinder. (a) By what amount is the gas decreased in volume in cubic centimeters? (b) Find the uncertainty in this volume.
A vertical cylinder of cross-sectional area A is fitted with a tight-fitting, frictionless piston of mass m (Fig. P18.40). The piston is not restricted in its motion in any way and is supported by the gas at pressure P below it. Atmospheric pressure is P0. We wish to find the height h in Figure P18.40. (a) What analysis model is appropriate to describe the piston? (b) Write an appropriate force equation for the piston from this analysis model in terms of P, P0, m, A, and g. (c) Suppose n moles of an ideal gas are in the cylinder at a temperature of T. Substitute for P in your answer to part (b) to find the height h of the piston above the bottom of the cylinder. Figure P18.40
(a) Given that air is 21% oxygen, find the minimum atmospheric pressure that gives a relatively safe partial pressure of oxygen of 0.16 atm. (b) What is the minimum pressure that gives a partial pressure of oxygen above the quickly fatal level of 0.06 atm? (c) The air pressure at the summit of Mount Everest (8848 m) is 0.334 atm. Why have a few people climbed it without oxygen, while some who have tried, even though they had trained at high elevation, had to tum back?
A vertical cylinder of cross-sectional area A is fitted with a tight-fitting, frictionless piston of mass m (Fig. P16.56). The piston is not restricted in its motion in any way and is supported by the gas at pressure P below it. Atmospheric pressure is P0. We wish to find die height h in Figure P16.56. (a) What analysis model is appropriate to describe the piston? (b) Write an appropriate force equation for the piston from this analysis model in terms of P, P0, m, A, and g. (c) Suppose n moles of an ideal gas are in the cylinder at a temperature of T. Substitute for P in your answer to part (b) to find the height h of the piston above the bottom of the cylinder.
(a) Show that the density of an ideal gas occupying a volume V is given by = PM/KT, where M is the molar mass. (b) Determine the density of oxygen gas at atmospheric pressure and 20.0C.
How many cubic meters of helium are required to lift a balloon with a 400-kg payload to a height of 8 000 m? Take He = 0.179 kg/m3. Assume the balloon maintains a constant volume and the density of air decreases with the altitude z according to the expression air = 0ez/8, where z is in meters and 0 = 1.20 kg/m3 is the density of air at sea level.
A metallic container of fixed volume of 2.5103 m3 immersed in a large tank of temperature 27 contains two compartments separated by a freely movable wall. Initially, the wall is kept in place by a stopper so that there are 0.02 mol of the nitrogen gas on one side and 0.03 mol of the oxygen gas on the other side, each occupying half the volume. When the stopper is removed, the wall moves and comes to a final position. The movement of the wall is controlled so that the wall moves in infinitesimal quasi-static steps. (a) Find the final volumes of the two sides assuming the ideal gas behavior for the two gases. (b) How much work does each gas do on the other? (c) What is the change in the internal energy of each gas? (d) Find the amount of heat that enters or leaves each gas.
An airplane is cruising at altitude 10 km. The pressure outside the craft is 0.287 atm; within the passenger compartment, the pressure is 1.00 atm and the temperature is 20C. A small leak occurs in one of the window seals in the passenger compartment. Model the air as an ideal fluid to estimate the speed of the airstream flowing through the leak.
A liquid with a coefficient of volume expansion just fills a spherical shell of volume V (Fig. P16.53). The shell and the open capillary of area A projecting from the top of the sphere are made of a material with an average coefficient of linear expansion . The liquid is free to expand into the capillary. Assuming the temperature increases by T, find the distance h the liquid rises in the capillary.
A popular brand of cola contains 6.50 g of carbon dioxide dissolved in 1.00 L of soft drink. If the evaporating carbon dioxide is trapped in a cylinder at 1.00 atm and 20.0C, what volume does the gas occupy?
A gas of unit weight 0.05 pound per cubic foot flows at the rate of 1.6 pounds per second past section A through a long rectangular duct of uniform cross section 2 ft x 2 ft. At section B, the gas weighs 0.060pound per cubic foot. Find the average velocities of flow at sections a A and B.
Consider a symmetrical U-shaped tube, of circular section and internal diameter d<<R, containing an incompressible liquid of density ρ. Before starting the rotation of the system, the system is in equilibrium, where the rotating branch has an initial height of fluid equal to L, while at the other end of the tube there is a chamber of height h and filled with a gas at initial pressure P0. The top cap of the chamber is attached to the tube. However, the bottom cap can be moved vertically acting as a “piston”, as shown in the diagram. Both the mass of the lower lid and that of the gas contained in the chamber are negligible.Suddenly the tube begins to rotate at constant angular velocity ω. About: For the initial instant find a relationship between the pressure P0 of the gas, the height h, the properties fluid physics and Patm.