A tank contains R134a initially at 3 degrees Celsius with a quality of 0.25. the pressure is held constant by nitrogen gas acting against a flexible bladder as shown. The valve is opened between the tank and a supply line carrying R134a at 975kPa, 118 degrees Celsius. The pressure regulator allows the pressure in the tank to remain constant as the bladder expands. The valve between the line and the tank closed at the instant when it contains 20kg of R134a with a quality of 0.95. if the entropy generation amounts to 1.025 kj/k, determine: Initial mass of r134a in the tank (kg) Heat transferred (kj) Is heat absorbed or released in the process Show mass, energy and entropy balance equations when starting  Initial state, state at inlet, final state H1,s1,h2,s2

Q: Determine the magnitudes of the pin reactions at A, B, and C caused by the weight of the uniform…

A: Given data as per the question weight of beam =5330 lb Calculations Let G is the centriod of the…

Q: Q2/ Determine the forces at the pin ? joint (F) and the roller support (G) 30KN 20 KN 2m B 2m D 2m E…

A:

Q: Determine the work and heat (both in kJ/kg) during the polytropic expansion of steam from 2.8 MPa at…

A:

Q: A heat engine operates between a source temperature of at [500 + last 2 digit of student ID]°C and a…

A: Carnot Heat Engine is a type of heat engine which gives maximum efficiency and correspondingly…

Q: For oil flow through a pipe, velocity increases    1. with decrease in area of cross section…

A:

Q: degree of reaction of a reaction turbine

A:

Q: The system is made up of the 1-m, 6.5-kg uniform rod AB and the two uniform disks (each of 0.15 m…

A:

Q: M3= lkg f2=1 N-s/m MI= Ikg Kl=1 N/m fl=1 N-s/m K2=1 N/m F(t M2= 1kg f3=1 N-s/m

A:

Q: A 75 mm diameter compound bar is constructed by shrinking a circular brass bush onto the outside of…

A:

Q: The following figure is a truss a joint of truss members. What will be the value of T1 and T2 if the…

A:

Q: Chillers often operate with COPs within the range of: A: 1.5-6 B: 2.5-7 C: 2-8 D: 3-9

A: Option  ( B ) is correct 2.5 to 7

Q: diagram of ‘regeneration cycle’ and state the advantages and disadvantages of regeneration.

A:

Q: A steel pipe 1.5m in diameter is required to carry an internal pressure of 650kPa. If the allowable…

A:

Q: A diesel engine works on the dual combustion cycle and has a compression ratio of 18. At the start…

A:

Q: If the Darcy Weisbach friction factor for a fluid flow through a pipeline is calculated as0 016, the…

A: When a fluid flows from one section to another section, there occurs a reduction in its total energy…

Q: For what value Mof the clockwise couple will the horizontal component A, of the pin reaction at A be…

A: When an amount of push or pull act on the object, it has the ability to change the state of the…

Q: You are asked to design a garden hose with an integral flow sensor. Suppose the normal inside…

A: Given data Diameter of garden hose = d1  =  2 cm Diameter of special restrictor = d2 = 1 cm Flow…

Q: PROBLEM 15.193 150 mm The L-shaped arm BCD rotates about the z axis with a constant angular velocity…

A:

Q: Two pipes link two reservoirs (A and B) that are 15m apart in height. Pipe 1 is 60 mm wide and 100 m…

A: Elevation difference between reservoirs A and B, H=15 mPipe 1 diameter, d1=60 mm= 0.060 mPipe…

Q: What work is done on a level track in bringing the velocity of a train weighing 200 tons from zero…

A: Given : m = 200 tons =200000 kg v = 30 mi/hr = 13.41 m/s F = 12 lb/ton = 53.38 N/ton S = 5280 ft =…

Q: Steam is throttled to 0.1 MPa with 20- degrees of superheat. What is the quality of throttled steam…

A:

Q: Wet steam at 200°C and 20% moisture is compressed in an irreversible adiabatic process to a process…

A:

Q: 2. Liquid hydrocarbon fuel, C16H43 is burned with 25% excess air. Calculate the actual air fuel…

A: Stoichiometric air is calculated and then actual air is found. Finally, A/F ratio is calculated.

Q: An aluminum rod is rigidly attached between a steel rod and a bronze as shown. Axial loads are…

A:

Q: The compound shaft consists of bronze and steel segments, both having 127-mm diameters. If the…

A:

Q: Both portions of the rod ABC are made of an aluminum for which E = 69.9GPA. Knowing that the…

A:

Q: Air is compressed in an adiabatic compressor from 55 psia and 660 R to 270 psia and 1200 R.…

A: Given   Initial pressure, P1 = 55 psia    Final pressure, P2 = 270 psia Find  Isentropic efficiency

Q: 3. 130 Consider a Rankine cycle with reheat as shown in the diagram, with state properties as Reheat…

A: as per guideline i have to solve only three subpart of your question

Q: By the method of this article, determine the rectangular and polar radii of gyration of the shaded…

A:

Q: An adiabatic compressor receives 1.5 m³/s of air at 30°C and 101 kPa. The discharge pressure is 505…

A:

Q: A steel pipe 1.5m in diameter is required to carry an internal pressure of 750kPa. If the allowable…

A:

Q: of the MM245 Automotive gearbox. The input and output torque.

A: MI of A=0.019kgm2B=0.1kgm2Torque=7.27 NmTo-Find:-1) Gear Ratio that gives the maximum angular…

Q: Consider the rectangular cardboard shown in the figure. If you cut a hole in the material and…

A: Correct answer: (A) increases

Q: Steam enters a nozzle operating at steady state at 30 bar, 330.6 °C, with a velocity of 103 m/s. The…

A:

Q: 6% of the stroke. State 1 is defined by 14psia and 140°F. For the hot-air standard with k=1.34 and…

A:

Q: Problem 21:  Suppose a Carnot engine has an efficiency of 42.5 % and a cold reservoir temperature of…

A: Heat Engine is a thermodynamic device which is used to convert heat into useful work and reject the…

Q: Draw the following using the figure given: 1. 45 degree CAVALIER 2. 45 degree CABINET OBLIQUE 3.…

A: According to the details provided in the question, we need to draw 1. cavalier oblique view  2.…

Q: A flanged bolt coupling is used to connect a solid shaft 85 mm in diameter to a hollow shaft 100 mm…

A:

Q: The man pushes the 20 lbm crate with a force of F = 150 lbf and with an angle of 45 deg from…

A: find the power supplied by the man.

Q: A 5 lbm ball starts rolling up a 30deg incline at speed of 20 ft/s. Using conservation of energy,…

A: Given data: m=5 lbmθ=30°v=20 ft/st=5 s Need to determine the power gravity does on the ball when it…

Q: Steam at a pressure of 1000 psia and 650 0F enters an adiabatic turbine and leaves at 65 psia. The…

A:

Q: For oil flow through a pipe, velocity increases O 1, with decrease in area of cross section O 2.…

A: Option : With decrease in area of cross section

Q: Air enters the diffuser of a turbojet engine with a mass flow rate of 65 lb/s at 9 lbf/in2, 420°R,…

A: Given data as per the question  Flow rate = 65 lb/s The pressure ratio for the compressor = 12…

Q: 9. A nozzle is designed to expand air from 689 kPaa and 32 °C to 138 kPaa. Assume an isentropic…

A:

Q: The four rigid gears, loaded as shown in the figure, are attached to a 1.63-in.-diameter steel…

A: The shear stress in the shaft AB can be determined as shown below.

Q: e following initial conditions x(0) = 0.5 m, *(0) = 0. Data: m= 10kg.

A:

Q: 14. A 3-ft-diameter log (s.g. = 0.82) divides two shallow ponds as shown in figure below. Compute…

A: Answer: ◆ Horizontal reaction: 2527.200 lb (left). ◆ Vertical reaction: 370.507 lb (upward).

Q: Air is compressed in an adiabatic compressor from 75 psia and 660 R to 290 psia and 1320 R.…

A: Given   Initial pressure, P1 = 55 psia    Final pressure, P2 = 270 psia Find  Isentropic efficiency

Q: Determine the y-coordinate of the centroid of the shaded area. 65 mm 37° 37° 75 mm 65 mnt 45 mm 45…

A:

Q: The variable h designates the arbitrary vertical location of the center of the circular cutout…

A:

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.