A temperature control system operates by sensing the difference between the thermostat setting and the actual temperature and then opening a fuel valve an amount. proportional to this difference. Draw a functional closed- loop block diagram similar to Figure 1.8(d) identifying the input and output transducers, the controller, and the plant. Further, identify the input and output signals of all subsystems previously described. [Section 1.4: Introduc- tion to a Case Study]

A temperature control system operates by sensing the difference between the thermostat setting and the actual temperature and then opening a fuel valve an amount. proportional to this difference. Draw a functional closed- loop block diagram similar to Figure 1.8(d) identifying the input and output transducers, the controller, and the plant. Further, identify the input and output signals of all subsystems previously described. [Section 1.4: Introduc- tion to a Case Study]

Understanding Motor Controls

4th Edition

ISBN:9781337798686

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter54: The Operational Amplifier

Section: Chapter Questions

Problem 7RQ: Name two effects of negative feedback.

See similar textbooks

Similar questions

EXPERIMENT TITLE : PID CONTROLLER IN LEVEL CONTROL SYSTEM OBJECTIVE:To demonstrate the characteristic of P,PI and PID controller response on a level controller system. Based on the topic and objective given,please make a clear introduction.
1. Give an example of open loop and closed loop system (one example each). Also state the input, control system, feedback and output parameter. Example. 1. Open Loop - Water Heater: Input - Water Temperature (Cold) System - Heating Element Output - Water Temperature (Hot) 2. Closed Loop - Air-conditioning System Input - Desired Room Temperature Control - Motor controller/Compressor/ACU Feedback - Temperature Sensing Output - Room Temperature
TIME DOMAIN MODELING AND RESPONSE FOR CONTROL SYSTEMS
Draw the state diagram of a High-Level State Machine that describes the operation of a light sequencer for a traffic light. Green should be on for 100 clock pulses, yellow for 20 clock pulses, and red for 70 clock pulses, for this particular street direction.
1.block diagram physical meaning and the time response for different inputs
In the mid-1900s, several technological and analysis concepts came together to make the PID controller widely accepted as an effective industrial controller. Discuss in detail and evaluate the performance of a PID or three-term controllers that are widely used in a typical paper mill where there may be about 2000 control loops, and over 90% of these would be PID control loops.
Draw a block diagram for a mechatronic system that controls the position of a robotic arm for gripping objects. Suggest a sensor system and clarify the flow and nature of signals in your block diagram.
Sensor systems for obstacle detection and avoidance in mobile robots. • Design and develop a suitable processor-based Data Acquisition (DAQ) system and external hardware to interface, measure, display and store the responses from the selected sensors.
explain please. Which type(s) of systems will oscillate in response to a step function?
A proportional controller is used to control the height of water in a tank where the water level can vary from 0 to 4.0 m. The required height of water is and the controller is to close a valve fully when the water rises to 3.9 and open it fully when the water falls to 3.1 m. What transfer function will be required? source : Mechatronics: Electronic Control Systems in Mechanical and Electrical Engineering 6th Edition by W. Bolton question 22.4
What is the significance of paravirtualization in improving virtual machine performance?
One of the disadvantage of negative feedback loop is lag caused because it can only be exerted after controlled variable has been disturbed. In order to minimize lag between a change in a controlled variable and the action of the effector, it is advantageous for the body to anticipate any likely change. Which one of the following physiological mechanism achieves this? Select one: a. Feedbackward control b. Feedforward control c.Positive feedback control d. All of the above e. None of the above