A) The apparent power for an electric network was measured and found to be 360.6VAL- 56.34. 1. Determine the power factor of the network and sketch the power triangle. 2. Identify the elements of the network and provide a reason justifying your answer.

A) The apparent power for an electric network was measured and found to be 360.6VAL- 56.34. 1. Determine the power factor of the network and sketch the power triangle. 2. Identify the elements of the network and provide a reason justifying your answer.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: For the circuit shown below, determine the real, reactive and apparent power for each element…

A: Write KVL equation for the circuit given and solve for current I; 2402∠60°-I5+8j-2802∠30°=0…

Q: The apparent power for an electric network was measured and found to be 360.6VAL-56.34. Determine…

A: There are two independent questions. We are authorized to answer one question at a time. So we are…

Q: Pls help ASAP. The subject is Electric Networks

A: Given: Brief description: In the above question they have mentioned an electrical circuit which is…

Q: A community requires 60 kW of power output to meet their daily electricity needs. If the site survey…

A: This problem is belongs to hydro power plant

Q: An electric motor having PF of 82% lagging is connected to 600V , 3-phase line (line-to-line) and…

Q: (a) List 5 types of alternative electric power systems. For each system, briefly describe the power…

A: we need to list down 5 types of alternative electric power systems and also need to describe about…

Q: 1. A current of 5 Amp flows through a non - inductive resistance in series with a choking coil when…

Q: A Power plant has maximum demand of 50 MW, a load factor of 60%, a plant capacity of 70% and plant…

A: Given: Maximum Demand=50 MWLoad Factor=60 %Plant capacity=70 %Plant use Factor=80 %

Q: A high-voltage transmission line with a resistance of .39ohms/km carries a current of 1030A. The…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: (i) List FOUR (4) major components in a power system network.

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: If the values of real power and reactive power is specified for a bus, then it is called as PV bus.…

A: If values of real power P and reactive power Q is specified for a bus then it is called PQ bus (load…

Q: : Determine the power absorbed by the dependent source in the circuit below

A: The four resistance 4K, 1K, 2K and 5K are in parallel to each other. 1RP=14+11+15+12 1RP =…

Q: 1. Two properly connected wattmeters are used to measure the power drawn by a 440 V squirrel-cage…

A: As per the guidelines given, We can only provide the solution of the first question in multiple…

Q: Q6/An air conditioner removes heat steadily from a house at a rate of 750 kJ/min while drawing…

Q: Given voltage source = 100V∠0°, give the value of real power, apparent power, and reactive power…

Q: 20 Vrms source supplies a parallel RLC circuit with the following values: R=100 ohms, XL=200 ohms…

Q: .For the following voltage and current phasors, calculate the real power in Watts V = 125 4 8⁰ Vrms…

Q: What are power generation, transmission, and distribution?

A: Power generation : Power generation is the process in which various from of energy like wind energy…

Q: Which of the following information does the dependent current source provide for ambient currents?

Q: 3) hydo power very welal comporent Why porer syolen? in a

A: Hydro power : Hydro-power is a vital contributor to the national power grid system because of its…

Q: Given the following voltages and load impedances: Vab = 22020 ° Vbe = 2204240° %3D Vea = 2204120°…

A: In this question, We need to determine the reading of the wattmeter We know Reading of wattmeter…

Q: Discuss the differences between the current coil and voltage coil of a wattmeter from a design point…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: An industrial assembly hall is continuously lightedby one hundred 40-W mercury vapor lamps…

A: An industrial assembly hall is lighted by 100 mercury vapor lamps whose rating is 40W each. So, the…

Q: 4) For AC supply voltage of 120 Vac, frequency of 60Hertz and capacitive value of 10.61 micro Farad…

Q: A power station has a daily load cycle as under; 260MW for 6 hours; 200MW for 8 hours; 160MW for 4…

A: The load factor (LF) of a power station is the ratio of average load (AL) on power station to…

Q: a) List 5 types of alternative electric power systems. For each system, briefly describe the power…

A: (a) Low-carbon energy is energy produced with fewer carbon emissions, such as wind, solar, hydro, or…

Q: Q1: By using any method for simplifying electric network , Find the current of 10 -: resistor V1 V2…

Q: A) In the context of energy power systems, explain the concept of resource and material intensity

A: A) Building and commissioning an energy power system requires resources such as capital, materials,…

Q: power transmission and distribution subject

A: Capacitance of three core cable- Let take a three core cable. Core to core will be delta connected…

Q: 5. Determine the current that flows through an 8-N resistor connected to a voltage source 110 cos…

A: We need to find current for given voltage

Q: Three coils each having resistance of 35 N and the inductance of 0.01 H are connected in star across…

A: As per bartleby expert policy, only one individual question is to be answered.

Q: R= 180 Q 120 V 30 mH 1000 Hz coil Solve for the Apparent Power delivered by the power supply to the…

Q: 14. An inductive coil and a non-inductive resistance R ohms are connected in series across an a.c.…

A: Given the inductive coil and non- inductive resistance R are connected The inductive coil consists…

Q: Kindly type the answer in the box below and the calculation steps should be written in a white paper…

A: In this question , star connection is given...We have to find out impedance , phase voltage , line…

Q: ower plant has a capacity factor of 40.9% and a plant use factor of 45.2%. How many hours per year…

A: A power is a place where electrical power is produced to supply the demand of its customers.

Q: Q:A 100 MW hydro-electric station is supplying full load for 10 hours a day. Calculate the volume of…

Q: Low power factor has some adverse impact on both the transmission line and on the consumer…

A: “Low power factor has some adverse impact on both the transmission line and on the consumer…

Q: Which of the following has the highest percentage of occurrence in a power network? LLL SLG LL DLG

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: A.) A coal-powered station has a maximum demand of 30 MW, a load factor of 60%, plant capacity…

A: Given data: Load factor = 60%=0.6 Maximum load= 30 MW

Q: Derive the relationship for maximum power Eb = v/2

A: Motor- The motor is an electric machine energy conversion device that converts given mechanical…

Q: The amplitude of the voltage available in the 60-Hz, 230-V power outlet in your home is what? A.…

A: In this we will find The amplitude of the voltage available in the 60-Hz, 230-V power outlet in…

Q: The percent values of the voltage, current, impedance, and volt-amperes for a given power system are…

Q: Show the derivation of the formula in transforming Delta (or Pi ) Network to Wye (or T) Network and…

Q: A. Find the current passing through the 10-ohm resistor and the average power absorbed by it…

A: The given circuit is shown with the mesh currents and the nodes as below,

Q: esign a hydro power plant of 100 kW for Head Balloki, Punjab. Draw a schematic diagram of the plant…

A: Balloki power plant is the 1,223 MW natural gas power plant recently completed in the year of 2018.…

Q: hydo power very wefal cemporent Why pover systen? 9, in a

A: This is a simple theoretical question based on hydroelectric power system and its advantages . I…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

None

A) The apparent power for an electric network was measured and found to be 360.6VAL- 56.34.
1. Determine the power factor of the network and sketch the power triangle.
2. Identify the elements of the network and provide a reason justifying your answer.
B) Define the permeability (ur) of the material. If you are required to design 1H and 1pH inductors,
what type of core will you use in your design and why? support your answer by equations.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A coil of Nichrome wire is 23.0 m long. The wire has a diameter of 0.400 mm and is at 20.0°C. (a) If it carries a current of 0.600 A, what is the magnitude of the electric field in the wire?(b) If it carries a current of 0.600 A, what is the power delivered to it?(c) If the temperature is increased to 300°C and the potential difference across the wire remains constant, what is the power delivered? A coil of Nichrome wire is 23.0 m long. The wire has a diameter of 0.400 mm and is at 20.0°C. Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error.
Topic is Electric Energy Systems. Please provide clear solution to the following problem. Thank you!!
A battery of emf 30.0 V is connected to a switch, an inductor of inductance ? = 0.600 ? and two resistors, R1 = 10.0 ? and R2 = 6.00?. The switch is initially open. A. What are the values of currents ?1, ?2, ?3 just after the switch is closed? (Just give an answer) ?1 = ?2 = ?3 = B.)Which point, a or b, is at higher potential or are they at the same potential, just after switch S is closed? (Just give an answer) C. What is the value of current ?1 through the battery a long time after the switch is closed? Show your work and briefly explain your logic
A circuit element has the following voltage across it and current running through it.?(?) = 3 cos(100? + 30°) V,?(?) = 50sin(100? + 30°) mA.Assume polarities are chosen so that the current is flowing into the positive voltage terminal.(a) Determine if this circuit element is a resistor, capacitor, or inductor.(b) Find the impedance of this circuit element.(c) Find the component value of the circuit element. ie. if it is an resistor find R, if it is a capacitor, find C, if it is an inductor, find L.
A 30-Wp SHS has a charging current of 1.7A at 1000 W/m2 irradiance. When the irradiance is decreased to 800W/m?, how much charging current is expected?
Estimate the AEP for a 3-MW wind turbine in a wind regime that has a CF= 30%. For this turbine explain why the increase of wind speed to levels greater than 25 m/s generates less electrical power compared to wind speeds around 11 m/s
When this resultant voltage is applied to a circuit consisting of a 10-Ω resistor and a capacitance of 17.3 Ω reactance connected in series, find an expression for the instantaneous value of the current flowing, expressed in the same form
Write the solution
If a coil of wire has a resistance of 20ohms at 40oC and 20 at 80oC,what will be the resistance of the coil at 0oC. oC = degrees celcius
Answer the following point in detail and rigorously. Instead of resorting to formulas, develop from basic principles (laws of voltages and currents, definition of electrical power, among others). a) What meaning would you give to the P consumed by an element? Which to Q?
explain in a summarized form the procedures for the calculation of elements for the construction of a PROTOTYPE OF PIEZOELECTRIC TILE FOR THE GENERATION OF ELECTRIC ENERGY THROUGH THE PEDESTRIAN TRAFFIC
Design a 1500-meter-long electrical transmission line with a cross-section size of 0.00199 cm2 that can carry a 50-amp current with a power loss of no more than 5 x105 W. Table 1 shows the electrical conductivity of a variety of materials. What kind of material could be a good candidate?